2006 VOLVO C70 Owners Manual

The battery should be disconnected from the vehicle when a battery charger is used directly on the battery.
WARNING!
PROPOSITION 65 WARNING!
Battery posts, terminals, and related accessories contain lead and lead compounds, chemicals known to the state of
California to cause cancer and reproductive harm. Wash hands after handling.
1. More frequently in warm climates.
pg. 163 Maintenance and servicing
Battery
Battery replacement
Switch off the ignition and remove the key.
Unscrew the cover over the battery.
Wait at least 5 minutes after switching off the ignition before disconnecting the battery so that all information in the
vehicle's electrical system can be stored in the control modules.
Remove the cover and unscrew the front side of the battery box using a screwdriver.
Disconnect the battery negative (ground)
Release the clamp holding the battery.
Disconnect the positive cable and lift out the battery.
Install the new battery in the reverse order.
WARNING!
Never expose the battery to open flame or electric spark.
Do not smoke near the battery.
ProCarManuals.com

Battery fluid contains sulfuric acid. Do not allow battery fluid to contact eyes, skin, fabrics or painted surfaces. If
contact occurs, flush the affected area immediately with water. Obtain medical help immediately if eyes are affected.
pg. 164 Maintenance and servicing
Bulbs
Bulbs used in the car1. Low beam headlight 55W H11
2. Bi -Xenon headlight (option) 35W D2S
3. High beam headlight 55W HB3
4. Brake light, Rear fog light P21/W5
5. Turn signal, front/ rear (amber bulb) PY21W
6. Tail lights, Parking light, Side marker light P21/W5
7. Footwell lighting, cargo compartment light W5W
8. Vanity mirror 1,2W
9. License plate lighting,
Parking light in headlight housing
Side turn signal (amber bulb) W5W
10. Front fog light (option) 55W H11
NOTE:
Never touch the glass of bulbs with your fingers. Grease and oils from your fingers vaporize in the heat and will
leave a deposit on the reflector, which will damage it.
The optional Bi -Xenon headlight bulbs contain trace amounts of mercury. These bulbs should always be disposed
of by a trained and qualified Volvo service technician.
Certain bulbs not listed here should only be replaced by a trained and qualified Volvo service technician.
pg. 165 Maintenance and servicing
Replacing front bulbs
ProCarManuals.com

Removing the headlight housing
The entire headlight housing must be lifted out when replacing the high/low beam, parking light, turn signal, and side
marker bulbs. To lift out the housing:
Remove the key from the ignition and turn the headlight switch to position 0.
Open the hood.
Pull up the headlight housing's retaining pin (1)
Pull the headlight housing to one side and then forward (2).
Disconnect the wiring connector.
Lift out the headlight housing and place it on a soft surface to avoid scratching the lens.
After the defective bulb has been replaced, reinsert the housing in the reverse order. Check that the retaining pin is
correctly inserted.
WARNING!
Bi -Xenon headlights (option) - due to the high voltage used by these headlights, these bulbs should only be replaced
by a trained and qualified Volvo service technician.
Low beam bulb
Open the hood.
Remove the headlight housing.
Press the retaining clamps to the sides.
Release the bulb's retaining spring by pressing it to the right, and then moving it outward and downward.
Pull out the bulb.
Disconnect the wiring connector from the bulb. Installing a new bulb.
Insert the new bulb. It can only be installed in one position.
ProCarManuals.com

pg. 166 Maintenance and servicing
Replacing front bulbs
Press the retaining spring upward and slightly to the left until it snaps into place.
Press the wiring connector onto the bulb.
Put the plastic cover in place.
Press the retaining clamps back into place.
Reinstall the headlight housing.
High beam bulb
Open the hood.
Remove the headlight housing.
Turn the bulb holder counterclockwise and pull it out. Replace the bulb. Note how the bulb holder is positioned.
Reinstall the bulb holder. It can only be installed in one position.
1. Reinstall the headlight housing.
ProCarManuals.com

Parking light bulb
Pull out the bulb holder with a pair of pliers. The bulb holder should not be pulled out by the wire.
Replace the bulb.
Press the bulb holder back into place. It can only be installed in one position.
pg. 167 Maintenance and servicing
Replacing front bulbs
Turn signal
Turn the bulb holder counterclockwise and remove it.
Remove the bulb from the holder by pressing it in and twisting it counterclockwise.
Insert a new bulb and reinstall the bulb holder in the headlight housing.
ProCarManuals.com

Side marker light
Turn the bulb holder counterclockwise, pull it out, and replace the bulb.
Reinstall the bulb holder. It can only be installed in one position.
Front fog light (option)
Switch off all lights and turn the key to position 0.
Remove the panel around the fog light housing. Depress the tabs around the edges as shown in the illustration in the
right column.
Unscrew both torx screws in the fog light housing and remove it.
Disconnect the connector from the bulb.
Turn the bulb counterclockwise and pull it out.
Install the new bulb in its seat and turn it clockwise.
Reconnect the connector to the bulb.
Secure the fog light housing with the screws and press the panel back into place.
pg. 168 Maintenance and servicing
Replacing bulbs in the trunk
ProCarManuals.com

Removing the tail light bulb holder
All bulbs in the tail light cluster can be replaced from the trunk. To access the bulb holder:
Switch off all lights and turn the key to position 0.
Remove the covers in the left/right panels as shown above to access the bulbs.
Disconnect the wiring connector from the bulb holder.
Press the catches together and pull out the bulb holder.
Replace the defective bulb.
Press the wiring connector back into position.
Press the bulb holder into place and reinstall the cover.
Location of tail light bulbs
1. Brake light
2. Parking light
3. Fog light (driver's side only)
4. Turn signal
5. Back-up light
NOTE: If the message indicating a burned out bulb remains in the information display after the bulb has been
replaced, consult a trained and qualified Volvo service technician.
ProCarManuals.com

Rear reading lights
Insert a screwdriver and turn it gently to detach the bulb housing.
Remove the defective bulb.
Install a new bulb.
Press the bulb housing back into place.
High-level brake light
These bulbs are of a special type. It is recommended that they be replaced by a trained and qualified Volvo service
technician.
pg. 169 Maintenance and servicing
Replacing interior bulbs
License plate lighting
Replacing the bulb
Switch off all lights and turn the key to position 0.
Remove the screw with a screw driver.
Detach the entire bulb housing and carefully pull it out. Turn the connector counterclockwise and pull out the bulb.
Replace the bulb.
Reinstall the connector and turn it clockwise.
Reinstall the entire bulb housing and screw it into place.
Footwell lighting
The footwell lighting is located under the dashboard on the driver's and passenger's sides. To replace a bulb:
ProCarManuals.com