3822006 TACOMA from Jan.’06 Prod. (OM35871U)
The following illustrations show how to
gain access to the bulbs. When replacing
a bulb, make sure the ignition switch and
light switch are off. Use bulbs with the
wattage ratings given in the table.
CAUTION
To prevent burning yourself, do not
replace the light bulbs while they
are hot.
Halogen bulbs have pressurized gas
inside and require special handling.
They can burst or shatter if
scratched or dropped. Hold a bulb
only by its plastic or metal case.
Do not touch the glass part of a
bulb with bare hands.
NOTICE
Only use a bulb of the listed type.
The inside of the lens of exterior lights
such as headlights may temporarily fog up
when the lens becomes wet in the rain or
in a car wash. This is not a problem
because the fogging is caused by the
temperature difference between the outside
and inside of the lens, just like the
windshield fogs up in the rain. However, if
there is a large drop of water on the
inside of the lens, or if there is water
pooled inside the light, contact your
Toyota dealer.Light bulbsBulb
No.WTy p e
Headlights (high
and low beam)—60/55A
Front fog lights914542B
Par k i ng and fr ont
side marker lights—5D
Front turn signal
lights4157NAK27/8D
Rear turn signal
lights3157A27/8D
Stop/tail and rear
side marker lights315727/8C
Back −up lights92118C
License plate
lights1685C
High mounted
stoplight1685C
Interior light—5E
Personal lights1685C
Replacing light bulbs—
3842006 TACOMA from Jan.’06 Prod. (OM35871U)
LS73007
3. Install the rubber cover as shownand fit it securely on the boss. Then
plug in the connector.
Make sure the rubber cover fits securely
on the bulb base and the mounting body.
Aiming is not necessary after replacing
the bulb. When aiming adjustment is nec-
essary, contact your Toyota dealer.
LS73020
1. Turn the bulb base counterclockwise and remove it.
If the connector is tight, wiggle it.
LS73021
2. Pull the bulb out of the base. Install a new bulb.
—Front fog lights
