2006 SSANGYONG REXTON remote control

RKSTICS
undefined
8710-08
OVERVIEW AND OPERATION PROCESS
1. OVERVIEW
The RKSTICS (REKES + STICS (Super Time & Integrated Control System)) communicates
with the transmitter (remote controller) and other electronic systems to transmit and receive the
data.
The STICS also includes a diagnosis function that can inspect the error for related devices.
2. MAJOR CHANGES
Integration of Auto Light Sensor and Rain Sensor
The auto light sensor integrated rain sensor communicates with STICS.
Auto Washer Coupled Wiper
When pressing the auto washer switch, the washer fluid is sprayed on the windshield and the
wiper sweeps off 4 times, and then the washer fluid is sprayed and the wiper sweeps off 3
times again.
Communication with SPWM
The communication with SPWM is added due to the introduction of easy access function to
SPWM.

undefined
8710-08
RKSTICS
Front/Center Room Lamp Control
The overhead console lamp (front room lamp) comes on when opening the
door(driver's/passenger's) while the door coupled front rooom lamp switch is at the coupled
operating position and the key reminder switch is "OFF".
When the door (Driver's/Passenger's) is opened, the front room lamp comes on.
The room lamp stays on for 2 seconds and then dims out through 3 seconds when closing
the opened door.
The dimming operation must have greater than 32 steps per one second.
The room lamp output should stop immediately after turning on the ignition key during the
dimming operation.
The front room lamp comes on for 30 seconds when receiving the unlock signal from the
remote control key while the doors are closed.
The front room lamp and the center room lamp output period is extended by 30 seconds
when receiving the unlock signal from the remote control key again during output. (The
lamp stays on when unlocked by the remote control key.)
When a door is opened during its extended period, the lamp stays on. If closed, operates as
in step 2.
The room lamp output stops immediately after receiving the lock signal from
driver's/passenger's door lock switches while the driver's and passenger's doors are closed
or entering into the anti-theft mode by pushing LOCK button on the remote control key.
The front room lamp comes on when opening the driver's door or passenger's door and
goes off when closing the opened door while the ignition key is in ON position. 1.
2.
3.
4.
5.
6.
7.
8.
9.

RKSTICS
undefined
8710-08
Front Room LampCenter Room Lamp
Front room lamp (driver's or passenger's) is
turned on and off when pressing the switch (1 o
r
2). However, it comes on when a door is opened
and goes off when the door is closed. The front
room lamp comes on when opening any of front
doors with the front door coupled switch (3)
pressed in.
If the switch is at the door coupled position,
the center room lamp comes on when a rea
r
door is opened. The lamp always comes on
while the switch is at the other position.
Door coupled
switch
Ignition Key Hole Illumination
The ignition key hole illumination comes on when opening the driver's door or passenger's
door when the ignition key is removed.
The ignition key hole illumination stays on for 10 seconds when closing the door after step
1.
The output stops when the ignition key is turned to "ON" position.
The output stops when receiving the lock signal from the remote control key (under anti-
theft mode). 1.
2.
3.
4.
(*1) OPEN : Driver's or Passenger's door = OPEN, CLOSE : Driver's and Passenger's = CLOSE

RKSTICS
undefined
8710-08
Door LOCK/UNLOCK by Remote Control Key
The door lock relay output is "ON" for 0.5 seconds when receiving the remote control lock
signal.
The door unlock relay output is "ON" for 0.5 seconds when receiving the remote control
unlock signal. 1.
2.

undefined
8710-08
RKSTICS
Time Lag Power Window Control
The power window relay output is "ON" when turning on the ignition switch.
The power window relay output is "ON" for 30 seconds when turning off the ignition switch.
The power window relay output is "OFF" when opening the driver's door or the passenger's
door.
The power window relay is turned "OFF" when receiving the remote control key lock signal
(armed mode) during its extended operation period of 30 seconds. 1.
2.
3.
Definition of Terms
DOOR OPEN and DOOR CLOSE
DOOR OPEN: Any of all door switches (including hood and tailgate) is in "OPEN" position.
DOOR CLOSE: All door switches (including hood and tailgate) are in "CLOSE" position. 1.
The door lock/unlock operation does not affect the engine hood.
DOOR LOCK: Indicates that all door lock switches (including tailgate) are in LOCK positions.
DOOR UNLOCK: Indicates that any of all door lock switches (including tailgate) is in UNLOCK
position. 2.

RKSTICS
undefined
8710-08
Power Sleep Mode
1. Entering Condition
1) When all the doors including the hood are closed.
2) When the ignition key is in "OFF" position.
3) When there is no key in the driver's/passenger's door key cylinder.
4) The system enters into the sleep mode for saving power if there is any change for 6
seconds while the driver's/passenger's/rear doors and tailgate are locked with the above
three conditions met.
2. The sleep mode is deactivated immediately if any of them is out of the specified
conditions (wake-up mode).
Also, the sleep mode is deactivated when receiving the UNLOCK signal from the remote
control key.
3. During the sleep mode, the sleep mode is deactivated for 30 seconds when room
lamp, key hole illumination, tail lamp or power window is operated or after the
system receives the UNLOCK signal from the remote control key.
However, if the lamps and power window mentioned above are "OFF" and the conditions in
item (1) are met, the system enters into the sleep mode again.

undefined
8710-08
RKSTICS
Description of Burglar Alarm Function
1. Armed mode activation requirements
1) The "LOCK" output is "ON" when receiving the "LOCK" signal from transmitter while the
ignition key is removed and all doors are closed. The armed mode is activated when the doo
r
lock switch is locked (hazard relay output: twice).
2) The theft deterrent horn and hazard relay outputs are "ON" when receiving the "LOCK"
signal from the remote control key again in armed mode (hazard relay output: twice).
3) When receiving "LOCK" signal from the remote control key while any of doors is not closed,
only the "LOCK" output can be done and then activates the armed ready mode (without hazard
warning flasher). At this moment, if the ignition key is in the ignition switch, the door unlock
switch is turned "ON" or the door lock switch is unlocked, it cancels the armed mode and
activates the normal mode. However, when closing and locking the opened door, the hazard
warning lamps flash twice.
4) When the door is not opened or the ignition key is not inserted into ignition switch for 30
seconds after receiving "UNLOCK" signal, it outputs "LOCK" and then activates armed mode
(RELOCK operation). Also, at this moment, the system outputs the hazard warning flashe
r
twice.
5) The armed mode will not be activated except above conditions.
Ex) The armed mode will not be activated when the door is locked by the ignition key.

RKSTICS
undefined
8710-08
2. Armed mode cancellation requirements
1) Unlocking by remote control key
2) Door unlocking by the driver's and passenger's key cylinder switch
3) The armed mode is cancelled when turning the ignition key "ON". The siren is deactivated in
27 seconds.
3. Warning operation requirements
1) When opening the door in armed mode
2) When unlocking the door lock switch in armed mode
3) When closing and then opening the door after completion of warning (27 seconds)
4. Warning operation
1) The siren and hazard warning flasher output is "ON" for 27 seconds with the interval of 1
second.
5. Warning cancellation requirements
1) Cancels warning by using any signal from the remote control key (LOCK, UNLOCK, PANIC)
during warning operation.
2) Cancels warning after 27 seconds (remaining period) while the ignition key is turned to "ON"
position.
3) If the ignition switch is turned to ON position when the warning is activated in armed mode,
the warning is canceled immediately and the warning buzzer stops after 27 seconds (remaining
time).
4) When unlocking the doors by the driver's/passenger's door key cylinder in armed mode, the
armed mode is cancelled.
6. Operation when warning is cancelled
1) The siren and hazard warning flasher outputs are "OFF".