2006 SKODA FABIA technical data

Seats and Stowage83
Using the systemSafetyDriving TipsGeneral MaintenanceBreakdown assistanceTechnical Data
Removing ashtray
– Remove the ashtray ⇒fig. 66 upwards. When removing do not
hold the ashtray at the cover - risk of breakage.
Replacing ashtray
– Insert the ashtray vertically.
WARNING
Never lay flammable objects in the ashtray basin - risk of fire!
Cigarette lighter* and power sockets*
Cigarette lighter
You can also use the socket on the cigarette lighter for other
electrical appliances.
Using the cigarette lighter
– Press in the button of the cigarette lighter ⇒fig. 68.
– Wait until the button jumps forward.
– Remove the cigarette lighter immediately and use it.
– Insert the cigarette lighter again into the socket.
Using the power socket
– Take out the cigarette lighter.
Fig. 68 Centre console: Cigarette lighter
NKO A05Fabia 20.book Page 83 Tuesday, September 26, 2006 8:38 AM

Seats and Stowage85
Using the systemSafetyDriving TipsGeneral MaintenanceBreakdown assistanceTechnical Data
Storage compartments on the front passenger side*
Certain model versions are equipped without lid for the storage
compartments.
Opening and closing the storage compartments on the front
passenger side
– Pull or press the handle of the lid in the direction of arrow ⇒fig. 69
and fold open the lid.
– Raise the lid until it is heard to engage.
A pin holder is loca ted inside the lid.
WARNING
The storage compartment must always be closed when driving for safety reasons.
Cooling of storage compartment on front passenger side*
The storage compartment can be fitted for vehicles with an
air-conditioning system with a closable inlet for cooled air.
– You can switch the cooling system on or off using the control dial
⇒ fig. 70.
Opening the air inlet when the air conditioning system is on causes fresh or interior air to flow into the storage compartment.
The storage compartment is only cooled in the cooling mode. We recommend that you switch off the cooling (opening concealed) if it is operating in the heating mode or if you are not using the cooling system for the storage compartment.
Fig. 69 Dash panel: Storage compartments on the front passenger side
Fig. 70 Storage compartment: Using cooling system
NKO A05Fabia 20.book Page 85 Tuesday, September 26, 2006 8:38 AM

Seats and Stowage87
Using the systemSafetyDriving TipsGeneral MaintenanceBreakdown assistanceTechnical Data
Stowage compartment in centre console
Unlocable compartment in the centre console.
Storage compartment in the front seat*
The storage compartment is foreseen for storing small objects of up to
1 kg. in weight.
– Tilt the lock to open the flap and pull out the flap ⇒fig. 74.
– Tilt the lock to close the flap and press flap close.
Fig. 73 Centre console: Storage compartmentFig. 74 Front seat: Storage compartment
NKO A05Fabia 20.book Page 87 Tuesday, September 26, 2006 8:38 AM

Seats and Stowage89
Using the systemSafetyDriving TipsGeneral MaintenanceBreakdown assistanceTechnical Data
A bottle holder is located in the area of the storage compartment for the front doors.
WARNING
Use the area ⇒fig. 77 of the storage compartment only for storing objects which do not project so that th e effectiveness of the side airbag is not impaired.
Removeable storage compartments in the luggage
compartment*
A removeable storage compartment* ⇒fig. 78 is located on both sides in the side trim panel of the luggage compartment.
The removeable storage compartments* are intended for storing small objects of up to 2.5 kg in weight.
Flexible storage compartment*
A flexible storage compartment is located on the right side of the
luggage compartment. The flexible storage compartment is foreseen
for storing small objects of up to 8 kg. in weight.
Removing
– Take hold of the flexible storage compartment at both upper
corners.
– Press the upper corners to the inside and release the storage
compartment by pulling upwards.
– Remove by pulling towards you.
AB
AA
Fig. 78 Removeable storage compartments
Fig. 79 Flexible storage compartment
NKO A05Fabia 20.book Page 89 Tuesday, September 26, 2006 8:38 AM

Heating and air conditioning system91
Using the systemSafetyDriving TipsGeneral MaintenanceBreakdown assistanceTechnical Data
Heating and air conditioning system
Heating
Using the system
The heating system delivers air into the interior of the vehicle
and warms it as required.
Setting temperature
– Turn the control dial ⇒fig. 81 to the right in order to increase
the temperature.
– Turn the control dial to the left in order to increase the temper-
ature.
Controlling blower
– Turn the blower switch into one of the positions, 1 to 4, in order
to switch the blower on.
– Turn the blower switch into position 0 in order to switch the
blower off.
– Pressing button causes the recirculating air system ⇒ to be
switched on.
Control for air distribution
– You can adjust the direction of the inlet air flow ⇒page 93 using
air distribution regulator .
The air inlet in front of the windscreen must be free of ice, snow or leaves in order to ensure that the heating and ventilation systems operate properly.
All controls apart from the control dial can be set to any desired interme- diate position.
The heating effect is dependent upon th e coolant temperature, thus full heat output only occurs when the engine has reached its operating temperature.
The blower should aways be on to prevent the windows from misting up.
WARNING
You should not leave recirculated air mode on over a longer period of time, as “stale” air may result in fatigue in the driver and occupants, divert your attention and also cause the windows to mist up. The risk of having an accident increases. Switch recirculated air mode off as soon as the windows begin misting up.
Fig. 81 Heating: Control elements
AA
AA
AB
AB
A1
AC
AB
NKO A05Fabia 20.book Page 91 Tuesday, September 26, 2006 8:38 AM

Heating and air conditioning system93
Using the systemSafetyDriving TipsGeneral MaintenanceBreakdown assistanceTechnical Data
Recirculated air mode
In recirculated air mode air is sucked out of the interior of the
vehicle and then fed back into the interior.
Recirculated air mode prevents polluted air outside the vehicle from
getting into the vehicle, for example when driving through a tunnel or
when standing in a traffic jam.
Switching recirculated air mode on
– Press button , the button symbol  lights up ⇒page 91,
fig. 81 .
Switching recirculated air mode off
– Press button again, the button symbol  goes out.
The recirculated air mode is switched of f automatically if the air distribution control is in position  ⇒page 91, fig. 81. You can also switch recirculated air mode on again from this setting by repeatedly pressing button .
WARNING
You should not leave recirculated air mode on over a longer period of time, as “stale” air may result in fatigue in the driver and occupants, divert your attention and also cause the windows to mist up. The risk of having an accident increases. Switch recirculated air mode off as soon as the windows begin misting up.
Air outlet vents
Fig. 82 Air outlet vents
Open air outlet vents
– Turn the rotary knob into the upper position.
Close air outlet vents
– Turn the rotary knob into the lower position.
Redirecting air flow
– The horizontal as well as the vertic al direction of the air flow is set
with the handle in the middle of the air outlet vents.
You can set the air supply to the individual vents with the air distribution control ⇒page 91, fig. 81. Air outlet vents 3 and 4 can also be opened or closed individually.
Unwarmed or cooled air will flow out of the opened air outlet vents according to the setting of the control dial ⇒page 91, fig. 81 and according to atmos- pheric conditions.


AC
AC
AA
NKO A05Fabia 20.book Page 93 Tuesday, September 26, 2006 8:38 AM

Heating and air conditioning system95
Using the systemSafetyDriving TipsGeneral MaintenanceBreakdown assistanceTechnical Data
Using the system
Setting temperature
– Turn the control dial ⇒fig. 83 to the right in order to increase
the temperature.
– Turn the control dial to the left in order to increase the temper-
ature.
Controlling blower
– Tur n the blo wer switch into o ne of the po sitio ns, 1 to 4, in order
to switch the blower on.
– Turn the blower switch into position 0 in order to switch the
blower off.
– Pressing button causes th e recirculating air system ⇒page 97
to be switched on.
Control for air distribution
– You can adjust the direction of the inlet air flow ⇒page 97 using
air distribution regulator .
switching cooling on and off
– Press the button . The symbol  in the switch comes on.
– When you again press the swit ch , the cooling system is
switched off. The symbol  in the button is no longer illuminated.
The set temperature will be automatically maintained other than when the control dial is on the extrem e right or extreme left position:
Extreme right position - full heating.
Extreme left position - full cooling.
The controls and can be set to any desired intermediate position.
The blower should aways be on to prevent the windows from misting up.
Note
•The whole heat output will be needed to unfrost the windscreen and side windows. No warm air will be fed to the footwell. This can lead to restriction of the heating comfort.
•The used air streams out through the air removal openings in the luggage compartment.
•If the cooling system has not been switched on for a lengthy period, odours may be produced at the evaporator beca use of deposits. Switch the air condi- tioning system on at least once a month for approximately 5 minutes at the highest blower stage - also during the co ld season of the year - in order to remove such odours. Also open a window for a short time.
•Please refer to the information regarding recirculated air mode ⇒page 97.
•Have the air conditioning system cleaned by a specialist workshop.
Fig. 83 Climatic: Controls
AA
AA
AB
AB

AC
AC
AC
AAAC
NKO A05Fabia 20.book Page 95 Tuesday, September 26, 2006 8:38 AM

Heating and air conditioning system97
Using the systemSafetyDriving TipsGeneral MaintenanceBreakdown assistanceTechnical Data
Recirculated air mode
In recirculated air mode air is sucked out of the interior of the
vehicle and then fed back into the interior.
Recirculated air mode prevents polluted air outside the vehicle from
getting into the vehicle, for example when driving through a tunnel or
when standing in a traffic jam.
Switching recirculated air mode on
– Press switch ⇒page 95, fig. 83 the switch symbol  lights up.
Switching recirculated air mode off
– Press button again, the button symbol  goes out.
The recirculated air mode is switched of f automatically if the air distribution control is in position  ⇒page 95, fig. 83. You can also switch recirculated air mode on again from this setting by repeatedly pressing button .
WARNING
You should not leave recirculated air mode on over a longer period of time, as “stale” air may result in fatigue in the driver and occupants, divert your attention and also cause the windows to mist up. The risk of having an accident increases. Switch recirculated air mode off as soon as the windows begin misting up.
Air outlet vents
Fig. 84 Air outlet vents
Open air outlet vents
– Turn the rotary knob into the upper position.
Close air outlet vents
– Turn the rotary knob into the lower position.
Redirecting air flow
– The horizontal as well as the vertic al direction of the air flow is set
with the handle in the middle of the air outlet vents.
You can set the air supply to the individual vents with the air distribution control ⇒page 95, fig. 83. Air outlet vents 3 and 4 can also be opened or closed individually:
Unwarmed or cooled air will flow out of the air outlet vents according to the setting of control dial ⇒page 95, fig. 83 and the atmospheric conditions.


AC
AC
AA
NKO A05Fabia 20.book Page 97 Tuesday, September 26, 2006 8:38 AM