GENERAL INFORMATION
REAR SUSPENSION34-3
SPECIFICATIONS
SUSPENSION SYSTEM
ItemSpecification
Suspension typeTorsion beam suspension
WHEEL ALIGNMENT
ItemSpecification
Camber−1°
Toe-inAt the centre of tyre tread mm3
Toe-angle (per wheel)0°09'
COIL SPRING
Item4A94G1
Wire diameter mm1011
Average outside diameter mm75 − 107 − 75111
Free length mm301283
GENERAL INFORMATION
FRONT SUSPENSION33-4
SPECIFICATIONS
SUSPENSION SYSTEM
ItemSpecification
Suspension typeMacPherson strut with coil spring
WHEEL ALIGNMENT
ItemSpecification
Camber − 0 °30'
Caster 4A92°35'
4G12°40'
Kingpin inclination 13°20'
Toe-inAt the centre of tyre tread mm0
Toe-angle (per wheel)0°
COIL SPRING
<4A9>
ItemSpecification
Wire diameter mm12
Average outside diameter mm133 − 149 − 154
Free length mmCVT331
5MT301
<4G1>
ItemSpecification
Wire diameter mm13
Average outside diameter mm133 − 150 − 154
Free length mm300
CONSTRUCTION DIAGRAM
ACTIVE STABILITY CONTROL SYSTEM (ASC)35C-16
DIAGNOSIS CODE READING METHOD
There are 55 diagnosis items. The diagnosis code
can be checked using M.U.T.-III.
HOW TO ERASE DIAGNOSIS CODE
MEMORY
Diagnosis code can be erased using M.U.T.-III.
Data list output
The following items input to ASC-ECU can be read
using M.U.T.-III.
NOTE: For service data items, refer to Workshop
Manual.
Actuator test
By forcibly operating the actuator using M.U.T.-III,
the following operations can be performed.
•Forced ABS activation for each wheel
•Forced TCL (brake control) activation for each
wheel
•Forced TCL (engine control) activation
NOTE: .
•When ASC-ECU is disabled, the actuator test
cannot be performed.
•M.U.T.-III uses the ABS data list.
•For the actuator test specification, refer to Work-
shop Manual.
CALIBRATION
When the following operations are performed, the
steering wheel sensor needs to be calibrated using
the M.U.T.-III*.
•Front wheel alignment adjustment
•Steering wheel sensor replacement
NOTE: .
•M.U.T.-III uses the ABS data list.
•*: For calibration, refer to Workshop Manual.
