233 Operation
Driving instructions
After driving on wet or snow-covered
roads, you should apply your brakes firmly
before parking your vehicle. This produces
heat which serves to dry the brake disks.
If the parking brake is released and the red
brake warning lamp in the instrument clus-
ter stays on, there is a malfunction in the
electrohydraulic brake system
(
page 300) or the brake fluid level in the
reservoir is too low.
Brake pad wear or a leak in the system may
be the reason for low brake fluid in the res-
ervoir.
Have the brake system inspected immedi-
ately.All checks and service work on the brake
system should be carried out by qualified
technicians only. Contact an authorized
Mercedes-Benz Center.
Only install brake pads and brake fluid rec-
ommended by Mercedes-Benz.
iThe brake system is designed to decel-
er ate you r S LR f rom hi gh sp ee ds a t the
best possible rate. Depending on the
applied brake force, speed, and ambi-
ent conditions, the brake system may
produce a squeak-type noise when you
apply the brakes at a moderate rate,
e . g . a t c i t y t r a f f i c . I f y o u e x p e r i e n c e t h i s
noise, you should occasionally test the
effectiveness of the brakes by applying
above-normal braking pressure at high
speeds. Please perform this braking
procedure three times. This will also
enhance the grip of the brake pads. If
the noise continuous, contact an au-
thorized Mercedes-Benz Center.
Warning!
G
Make sure not to endanger any other road
users when carrying out these braking
maneuvers.!Refer to the description of the Brake
Assist System (BAS) (
page 81).
Warning!
G
If other than recommended brake pads are
installed, or other than recommended brake
fluid is used, the braking properties of the
vehicle can be degraded to an extent that
safe braking is substantially impaired. This
could result in an accident.
Be certain to read and observe the warning
notices on brake pad replacement
(page 85).
318 Practical hintsWhat to do if ...Left display
Right display
Possible cause/
consequence
Possible solution
2
Brake wear
Visit
workshop
The brake pads have reached
their wear limit.
Have the brake pads replaced immediately.
!Brake pad thickness must be visually
checked by a qualified technician at the
intervals specified in the Maintenance
Booklet.Warning!
G
Have brake pad replacement and other work
on the electrohydraulic brake system car-
ried out by qualified technicians only. Con-
tact your Mercedes-Benz Center for further
information. The electrohydraulic brake sys-
tem must be deactivated prior to working on
the system. High pressure is intermittently
built up in the system as part of its automat-
ic self-test. In addition, the system is auto-
matically activated when the vehicle is
unlocked by remote control, when the driver
or passenger door is opened, when the
SmartKey in the starter switch is turned to
position1, when the brake pedal is de-
pressed or when the parking brake is re-
leased.
Failure to deactivate the system prior to
maintenance will cause brake pistons to ex-
tend and brake fluid to leak, which may re-
sult in injuries (contusions and acid burns),
see “Electrohydraulic brake system”
(page 84).
