2006 MERCEDES-BENZ G55AMG buttons

214 Controls in detail
Useful features
Exact location and color of the button
may vary by garage door opener brand.
Depending on manufacturer, the “train-
ing” button may also be referred to as
“learn”or “smart” button. If there is dif-
ficulty locating the transmitting button,
refer to the garage door opener opera-
tor’s manual.
Step 9:
Press “training” button on the garage
door opener motor head unit.
The “training light” is activated.
You have 30 seconds to initiate the follow-
ing step.
Step 10:
Firmly press, hold for two seconds and
release the programmed integrated
signal transmitter button (2, 3,
or4).
Step 11:
Press, hold for two seconds and re-
lease same button a second time to
complete the training process.Some garage door openers (or other rolling
code equipped devices) may require you to
perform this procedure a third time to
complete the training.
Step 12:
Confirm the garage door operation by
pressing the programmed integrated
signal transmitter button (2, 3,
or4).
Step 13:
To program the remaining two buttons,
repeat the steps above starting with
step 3.
Gate operator/Canadian programming
Canadian radio-frequency laws require
transmitter signals to “time-out” (or quit)
after several seconds of transmission
which may not be long enough for the inte-
grated signal transmitter to pick up the sig-
nal during programming. Similar to this
Canadian law, some U.S. gate operators
are designed to “time-out” in the same
manner. If you live in Canada or if you are having dif-
ficulties programming a gate operator (re-
gardless of where you live) by using the
programming procedures, replace step 4
with the following:
Step 4:
Continue to press and hold the inte-
grated signal transmitter button (2,
3, or4) while you press and re-press
(“cycle”) your hand-held remote con-
trol transmitter6 every two seconds
until the frequency signal has been
learned. Upon successful training, the
indicator lamp1 will flash slowly and
then rapidly after several seconds.
Proceed with programming step 5 and
step 6 to complete.


215 Controls in detail
Useful features
Operation of integrated remote control
Switch on the ignition (page 35).
Select and press the appropriate inte-
grated signal transmitter button (2,
3, or4) to activate the remote con-
trolled device.
The integrated remote control trans-
mitter continues to send the signal as
long as the button is pressed – up to
20 seconds.
Erasing the integrated remote control
memory
Switch on the ignition (page 35).
Simultaneously hold down the signal
transmitter buttons2 and 4, for ap-
proximately 20 seconds, until the indi-
cator lamp1 blinks rapidly. Do not
hold for longer than 30 seconds.
The codes of all three channels are
erased.Reprogramming a single integrated sig-
nal transmitter button
To program a device using a signal trans-
mitter button previously trained, follow
these steps:
Press and hold the desired signal trans-
mitter button (2, 3, or4). Do not re-
lease the button.
The indicator lamp will begin to flash af-
ter 20 seconds. Without releasing the
integrated signal transmitter button,
proceed with programming starting
with step 3.
Heated steering wheel
The steering wheel heater warms up the
leather area of the steering wheel.
The lever with the heated steering wheel
switch is on the lower left-hand side of the
steering wheel.
1Switching on
2Switching off
3Indicator lampi
If you sell your vehicle, erase the codes
of all three channels.

383 Technical terms
ABS
(A
ntilock Brake System)
Prevents the wheels from locking up
during braking so that the vehicle can
continue to be steered.
Accessory weight
(
page 273)
Air pressure
(
page 273)
Aspect ratio
(
page 273)
BabySmart
TM1 airbag deactivation
system
This system detects if a special system
compatible child restraint seat is in-
stalled on the front passenger seat. The
system will automatically deactivate
the passenger front airbag when such a
seat is properly installed (indicator
lamp7 in the center console
comes on).BabySmart
TM compatible child seats
Special restraint system for children.
The sensor system for the passenger
seat prevents deployment of the pas-
senger front airbag if a BabySmart
TM
compatible child seat is installed. See
an authorized Mercedes-Benz Light
Truck Center for availability.
BAS
(B
rake Assist System)
System for potentially reducing braking
distances in emergency braking situa-
tions. The system is activated when it
senses an emergency based on how
fast the brake is applied.
Bar
(
page 273)
Bead
(
page 273)CAC
(C
ustomer Assistance Center)
Mercedes-Benz customer service cen-
ter, which can help you with any ques-
tions about your vehicle and provide
assistance in the event of a break-
down.
CAN system
(C
ontroller Area Network)
Data bus network serving to control ve-
hicle functions such as door locking or
windshield wiping.
Cockpit
All instruments, switches, buttons and
indicator/warning lamps in the passen-
ger compartment needed for vehicle
operation and monitoring.
Cold tire inflation pressure
(
page 273)
1BabySmartTM is a trademark of Siemens
Automotive Corp.

384 Technical terms
COMAND
(C
ockpit Management and Data
System)
Information and operating center for
vehicle sound and communications
systems, including the radio and the
navigation system, as well as other op-
tional equipment (CD changer, tele-
phone, etc.).
Control system
The control system is used to call up
vehicle information and to change
component settings. Information and
messages appear in the multifunction
display. The driver uses the buttons on
the multifunction steering wheel to
navigate through the system and to ad-
just settings.
Differential locks
On slippery surfaces, differential locks
prevent one wheel of an axle from spin-
ning while the other wheel stands still,
resulting in driving force no longer be-
ing transferred.Cruise control
Driving convenience system that auto-
matically maintains the vehicle speed
set by the driver.
Curb weight
(
page 273)
DOT
(D
epartment of Transportation)
(
page 274)
Engine number
The number set by the manufacturer
and placed on the cylinder block to
uniquely identify each engine pro-
duced.
Engine oil viscosity
Measurement for the inner friction (vis-
cosity) of the oil at different tempera-
tures. The higher the temperature an
oil can tolerate without becoming thin,
or the lower the temperature it can tol-
erate without becoming viscous, the
better the viscosity.ESP
(E
lectronic Stability Program)
Improves vehicle handling and direc-
tional stability.
ETD
(E
mergency Tensioning Device)
Device which deploys in certain frontal
and rear collisions exceeding the sys-
tem’s threshold to tighten the seat
belts.
->SRS
FSS (Canada vehicles)
(F
lexible Service System)
Maintenance service indicator in the
speedometer display that informs the
driver when the next vehicle mainte-
nance service is due. FSS evaluates en-
gine temperature, oil level, vehicle
speed, engine speed, distance driven
and the time elapsed since your last
service, and calls for the next mainte-
nance service accordingly.

401 Index
Mirrors
Activating exterior rear view mirror
parking position 164
Adjusting 41
Auto-dimming for rear view
mirror 163
Exterior rear view mirror 41
Exterior rear view mirror parking
positions 144
Interior rear view mirror 41
Storing exterior rear view mirror park-
ing position 109
MON 240
MON (Motor Octane Number) 386
Monitoring reach
Rear Parking Assist* 185
Mph or km/h in speedometer
setting 137
Multicontour seat* 104
Multifunction display 123, 386
Selecting language 137
Standard display 127Multifunction display messages
ABS 300
BAS 300
Battery 304, 305
Brake fluid 305
Brake pads 305
Check engine 294
Coolant 307, 308, 309
Cruise control 310
Display 322
Doors 310
Engine 294
Engine air filter 310
Engine oil 311
ESP 302
Fuel reserve tank 313
Hood 313
Key 313
Lamps 314, 316
Parking brake 306
Sunroof 321
Tailgate 322
Tele Aid 321
Telephone* 322
Washer fluid 322Multifunction steering wheel 26, 124
Buttons 124
N
Navigation system
Operating 130
See separate COMAND operating in-
structions
Night security illumination 113
Setting 140
Normal occupant weight 274
O
Occupant distribution 274
Occupant safety 62
Airbags 63
Children in the vehicle 72
Fastening the seat belt 43
Infant and child restraint systems 72
LATCH child seat anchors 77
Seat belts 43, 66
Odometer, main 25

407 Index
Snow chains 279
Spare parts see Parts service
Spare wheel 325
Mounting 349
Speed
Setting current 182
Speed settings
Cruise control 183
Speedometer 25
Setting units 137
Speedometer display mode
Selecting 137
Split rear bench seat 188
SRS 70, 387
Indicator lamp 296
Standing lamp, front
Replacing bulbs 338
Standing lamps
Replacing bulbs 336
Standing water
Driving instructions 226
Starter switch 23, 35
Positions 35
Starting difficulties 49
Starting position 35
Starting the engine 48Station (radio)
Search 129
Station selection
Setting 142
Steep terrain 230
Steering column
Adjusting in /out 40
Adjusting up/down 40
Steering wheel
Adjusting 40
Adjusting in/out 40
Adjusting up/down 40
Buttons 26
Cleaning 287
Heated 215
Stolen vehicle
Stolen Vehicle Recovery
services 210
Stopping
Tilt/sliding sunroof 179
Windows 175
Storage bags
In rear passenger compartment 198Storage compartments 194
Armrest 195
Below armrest 195
Cup holders 196, 197
Glove box 194
In front of armrest 195
Parcel net in front passenger
footwell 197
Storage bags 198
Storage spaces
Cup holders 195
Storing (memory function)
Positions into memory 108
Storing tires 254
Submenus
Convenience 143
For settings 125
In control system 127
Instrument cluster 136
Lighting 138
Resetting functions in Control
system 133
Selecting 133
Settings menu 133
Vehicle 142
Summer opening feature 176