2006 MAZDA MODEL MX-5 Owners Manual (in English)

Black plate (97,1)
2. Slide the hood latch to the right and lift
the hood.
3. Grasp the support rod in the padded
area and secure it in the stay hole
indicated by the arrow to hold the hood
open.
Clip
Support rod
qClosing the Hood
1. Check under the hood area to make
certain all filler caps are in place and
all loose items (e.g. tools, oil
containers, etc.) have been removed.
2. Insert the support rod in its clip while
holding up the hood. Verify that the
support rod is secured in the clip before
closing the hood.
3. Close the hood so that it locks securely.
Knowing Your Mazda
Doors and Locks
3-39
MX-5_8U35-EA-05F_Edition1 Page97
Monday, April 18 2005 4:17 PM
Form No.8U35-EA-05F

Black plate (98,1)
Convertible Top
Windshield header
Top latch assembly
Top storage area
The convertible
top's handles
qConvertible Top Precautions
WARNING
Standing in a Moving Vehicle:
Standing in the vehicle, or sitting on
the convertible top storage area or
center console when the vehicle is
moving is a dangerous way to ride.
During a sudden maneuver or
collision you could be seriously
injured or even killed.
Sit in the seat with the seat belt on
when the vehicle is moving.
WARNING
Fastening Mechanisms:
It is dangerous to place your hands or
fingers near the fastening
mechanisms. Your hands or fingers
could be caught and injured by the
mechanism. Always keep your hands
and fingers away from the fastening
mechanisms when moving the top.
CAUTION
Remove leaves that accumulate on and
around the convertible top. If the leaves
are not removed, they may block the
water drainage outlets.
3-40
Knowing Your Mazda
Doors and Locks
MX-5_8U35-EA-05F_Edition1 Page98
Monday, April 18 2005 4:17 PM
Form No.8U35-EA-05F

Black plate (99,1)
lBefore lowering or raising the top, stop
in a safe place off the right-of-way and
park on a level surface.
lMake sure nothing is on the top or near
the back window when raising or
lowering the top.
Even small objects may interfere and
cause damage.
lWhen lowering the top, make sure
objects inside the vehicle aren't blown
away by the wind.
lSecure all loose objects inside before
driving with the top down.
lTo help prevent burglary or vandalism
and to ensure that the passenger
compartment stays dry, close the top
securely and lock both doors when
leaving the vehicle.
lDon't drive through an automatic car
wash; it may damage the top.
lDon't raise or lower the top when the
temperature is below 5 °C (41 °F) ; this
will damage the top material.
lDon't lower the top when it's wet. If the
top dries while folded, it will
deteriorate and shrink.
lLowering the top while it's wet can
also cause water to drip into the
passenger compartment.
lDon't raise or lower the top when the
wind is strong; the wind could damage
the top.
qLowering the Convertible Top
1. Park the vehicle on a level surface and
firmly set the parking brake.
2. Lower the side windows, then turn off
the ignition.3. Remove all objects in the top storage
area.
WARNING
Objects in the Storage Area:
Putting heavy or sharp objects in the
top storage area is dangerous.
During a sudden stop or collision, they
can become projectiles that might hit
and injure passengers.
Don't place heavy or sharp objects in
the top storage area.
4. Push the unlock button and fully
release the top latch.
Unlock button
Top latch
Knowing Your Mazda
Doors and Locks
3-41
MX-5_8U35-EA-05F_Edition1 Page99
Monday, April 18 2005 4:17 PM
Form No.8U35-EA-05F

Black plate (100,1)
5. Pull the top rearward on the front
section of the top to release it from the
windshield header.
Windshield header
NOTE
To lower the convertible top from inside
the vehicle, use the convertible top's
handles.
The convertible
top's handles
6. Fold back the front and carefully lower
it to the storage area.
7. Press down the top so that it locks
securely.
8. If a windblocker is necessary, raise a
windblocker.
NOTE
The windblocker reduces the amount of
wind coming into the cabin from behind
when driving with the top opened.
Refer to Windblocker on page 6-43.
3-42
Knowing Your Mazda
Doors and Locks
MX-5_8U35-EA-05F_Edition1 Page100
Monday, April 18 2005 4:17 PM
Form No.8U35-EA-05F

Black plate (101,1)
qRaising the Convertible Top
1. Park the vehicle on a level surface and
firmly set the parking brake.
2. Lower the side windows, then turn off
the ignition.
3. Pull the unlock lever to release the top.
Unlock lever
4. Grasp the top along the sides towards
the middle and pull the top up and
forward until it's against the windshield
header.
Windshield header
NOTE
To raise the convertible top from inside
the vehicle, use the convertible top's
handles.
The convertible
top's handles
5. Make sure the strikers for the top
latches are securely engaged with the
anchors before pushing up the top latch
lever.
Push the lever of each top latch up with
the palm of your hand until the lock
button clicks and the top latch is
locked.
Striker
Anchor
Knowing Your Mazda
Doors and Locks
3-43
MX-5_8U35-EA-05F_Edition1 Page101
Monday, April 18 2005 4:17 PM
Form No.8U35-EA-05F

Black plate (102,1)
CAUTION
Driving with the convertible top not
fully locked could damage the top.
If the red indicator is visible on the
unlock button, the top is not locked.
After locking the top, verify that the red
indicator is not visible.
Locked position
Unlocked position
Red indicator
NOTE
Make sure the top is securely locked by
pushing up on it. If it still sounds loose
(rattles) after being locked by the top
latch, have it inspected at an Authorized
Mazda Dealer.
qTaking Care of the Top
Refer to convertible top maintenance
(page 8-51) for information on taking care
of the top.
3-44
Knowing Your Mazda
Doors and Locks
MX-5_8U35-EA-05F_Edition1 Page102
Monday, April 18 2005 4:17 PM
Form No.8U35-EA-05F

Black plate (103,1)
Immobilizer System (with
Advanced Key)
The immobilizer system allows the engine
to start only with an advanced key the
system recognizes.
If someone attempts to start the engine
with an unrecognized key, the engine will
not start, thereby helping to prevent the
theft of your vehicle.
CAUTION
lChanges or modifications not
expressly approved by the party
responsible for compliance could
void the user's authority to operate
the equipment.
lTo avoid damage to the key, do not:
lDrop the key.lGet the key wet.lExpose the key to any kind of
magnetic field.
lExpose the key to high
temperatures on places such as the
dashboard or hood, under direct
sunlight.
CAUTION
Do not allow the following when
starting the engine with the auxiliary
key due to an advanced key dead
battery or other malfunction. Otherwise
the signal from the auxiliary key will
not be received correctly and the engine
may not start.
lMetal parts of other keys or metal
objects touch the key grip.
lSpare auxiliary keys or keys for
other vehicles equipped with an
immobilizer system touch or come
near the auxiliary key.
lEquipment containing electronic
components or cards with magnetic
strips such as credit cards come near
the auxiliary key.
NOTE
l(U.S.A.)
This device complies with Part 15 of
the FCC Rules. Operation is subject
to the following two conditions: (1)
this device may not cause harmful
interference, and (2) this device must
accept any interference received,
including interference that may cause
undesired operation.
l(CANADA)
This device complies with RSS-210
of Industry CANADA. Operation is
subject to the following two
conditions: (1) this device may not
cause interference, and (2) this
device must accept any interference,
including interference that may cause
undesired operation of the device.
Knowing Your Mazda
Security System
3-45
MX-5_8U35-EA-05F_Edition1 Page103
Monday, April 18 2005 4:17 PM
Form No.8U35-EA-05F

Black plate (104,1)
qOperation
Arming
The system is armed when the ignition
switch is turned from the ON position to
the ACC or LOCK position. The security
indicator light in the instrument cluster
flashes every 2 seconds until the system is
disarmed.
Disarming
The system is disarmed when the ignition
switch is turned to the ON position with
the registered advanced key.
The security indicator light illuminates for
about 3 seconds and goes out.
If the engine doesn't start with the correct
ignition key, and the security indicator
light keeps illuminating or flashing, the
system may have a malfunction. Consult
an Authorized Mazda Dealer.
NOTE
lThe engine may not start and the
security indicator light may
illuminate or flash if the advanced
key is placed in an area where it is
difficult for the system to detect the
signal, such as on the dashboard, or
in the glove box. Move the advanced
key to another place, turn the
ignition switch to the LOCK
position, and then restart the engine.
lSignals from a TV or radio station, or
from a transceiver or a mobile
telephone could interfere with your
immobilizer system. If you are using
the proper advanced key and the
engine fails to start, check the
security indicator light. If the
indicator light is flashing, turn the
ignition switch to the ACC or LOCK
position and wait for a while, then
restart the engine. If it doesn't start
after 3 or more tries, contact an
Authorized Mazda Dealer.
lIf the security indicator light flashes
continuously while you are driving,
don't shut off the engine. Go to an
Authorized Mazda Dealer and have
it checked. If the engine is shut off
while the indicator light is flashing,
you won't be able to restart it.
lSince the electronic codes are reset
when repairing the immobilizer
system, the advanced key (including
auxiliary key) are needed. Bring all
the advanced keys (including
auxiliary keys) to an Authorized
Mazda Dealer.
3-46
Knowing Your Mazda
Security System
MX-5_8U35-EA-05F_Edition1 Page104
Monday, April 18 2005 4:17 PM
Form No.8U35-EA-05F