2006 LEXUS LX470 audio

AUDIO
244(a) When the radio mode is selected
”
“ or
”“switch: Push this switch for seek tuning or to
select a station.
 To select a preset station, push the switch briefly. Do this
again to select the next preset station.
 To seek a station, push and hold the switch until you hear
a beep. Do this again to find the next station. If you push
the switch on either side of the
”
“or
”“ during the
seek mode, seeking will be cancelled.
 To step up or down the frequency, push and hold the switch
even after you hear a beep. When you release from the
switch, the radio will begin seeking up or down for a station.
Do this again to find the next station.
XM satellite radio*—
To select a preset channel, push the
”
“or
”“ side of the
switch. Repeat until a desired channel is found.
*: Use of satellite radio requires XM tuner and service. Contact
your Lexus dealer for details.
(b) When the “TAPE” mode is selected
”
“ or
”“switch: Push this switch to fast forward or
rewind the tape or for automatic program selection.
 Push this switch until you hear a beep to fast forward or
rewind the tape. To stop fast forwarding or rewinding, push
the same side on the switch until you hear a beep.
 Push this switch briefly for automatic program selection.
When automatically selecting a program, you can skip up to
9 programs at a time. See page 237 for details. (c) When the “CD” or “DVD” mode is selected
”
“ or
”“switch:
Use this switch to select a desired
track or CD.
 Push this switch briefly to select a desired track.
 To select a desired CD, push and hold this switch until the
desired number of the CD appears and you hear a beep.
CAUTION
Operate the switches with due care while you are
driving to avoid accidents.

AUDIO
245
Rear seat audio system
In the rear seat, you can enjoy a different mode from the
one used on the front audio system, using headphones.
21x571a
(a) Turning the system on and off
“ON/SOURCE” button: Use this button to turn the system on
when the system is off. When the system is turned on, the
mode changes by pushing this button.
“OFF” button: Use this button to turn off the system.
“Volume adjusting” knob: Use this knob to adjust the
volume. (b) When the radio mode is selected
“
CH” button: Push this button to
select a station preset
on the preset button of the front audio system. Each push of
the button changes to the station with higher numbered preset
button.
“
TUNE” button: Push this button for manual tuning or
seek tuning.
 Push this button briefly. Each time you push the button, the
radio will step up or down to another frequency.
 Push this button and hold it until you hear a beep. The radio
will begin seeking up or down for a station, and will stop on
reception. Each time you push the button, the stations will
be searched out one after another.
(c) When the “TAPE” mode is selected
“
PROG” button: Push this button to select the other side
of a cassette tape.
“
TRACK” button: Push the left or right side to skip
forward or backward to locate the song you want to hear. For
details, see “Automatic program selection” on page 236.

AUDIO
246(d) When the “CD” or “DVD” mode is selected
“
DISC”
Use this button to search a desired CD.
“
TRACK” button: Use this button to search a desired
track or push this button and hold it to fast forward or reverse.
(e) Some basics
This system cannot be used if the audio system is not turned
on.
You cannot select “AM” or “FM” mode in the rear seat if the
“FM” or “AM” mode is used on the front seats side.
If you select the same mode as the front seats side, operating
the controller will affect the mode on the front seats side.
Vehicles with navigation system only:
 When the XM satellite radio* is selected in the front seat, the
“CD” or “DVD” mode cannot be selected in the rear seat.
 When the “CD” or “DVD” mode is selected in the rear seat,
selecting the XM satellite radio* in the front seat will
automatically change the “CD” or “DVD” to “AM” mode in the
rear seat.
CAUTION
This system is not designed for a driver. So, the driver
should not use this system while driving.
Audio system operating hints
NOTICE
To ensure correct audio system operations:
 Be careful not to spill beverages over the audio
system.
 Do not put anything other than a cassette tape or CDs
into the cassette tape slot or CD slot.
 The use of a cellular phone inside or near the vehicle
may cause a noise from the speakers of the audio
system which you are listening to. However, this
does not indicate a malfunction.

AUDIO
247
Radio reception
Usually, a problem with radio reception does not mean there
is a problem with your radio
− it is just the normal result of
conditions outside the vehicle.
For example, nearby buildings and terrain can interfere with
FM reception. Power lines or telephone wires can interfere
with AM signals. And of course, radio signals have a limited
range. The farther you are from a station, the weaker its signal
will be. In addition, reception conditions change constantly as
your vehicle moves.
Here are some common reception problems that probably do
not indicate a problem with your radio:
FM
Fading and drifting stations − Generally, the effective range
of FM is about 40 km (25 miles). Once outside this range, you
may notice fading and drifting, which increase with the
distance from the radio transmitter. They are often
accompanied by distortion.
Multipath − FM signals are reflective, making it possible for
two signals to reach your antenna at the same time. If this
happens, the signals will cancel each other out, causing a
momentary flutter or loss of reception. Static
and fluttering − These occur when signals are blocked
by buildings, trees, or other large objects. Increasing the bass
level may reduce static and fluttering.
Station swapping − If the FM signal you are listening to is
interrupted or weakened, and there is another strong station
nearby on the FM band, your radio may tune in the second
station until the original signal can be picked up again.
AM
Fading − AM broadcasts are reflected by the upper
atmosphere − especially at night. These reflected signals can
interfere with those received directly from the radio station,
causing the radio station to sound alternately strong and weak.
Station interference − When a reflected signal and a signal
received directly from a radio station are very nearly the same
frequency, they can interfere with each other, making it dif ficult
to hear the broadcast.
Static − AM is easily affected by external sources of electrical
noise, such as high tension power lines, lightening, or electrical
motors. This results in static.

AUDIO
248Caring for your cassette player and tapes
For the best performance for your cassette player and tapes:
Clean the tape head and other parts regularly.

A dirty tape head or tape path can decrease sound quality
and tangle your cassette tapes. The easiest way to clean
them is by using a cleaning tape. (A wet type is
recommended.)
Use high− quality cassettes:
 Low −quality cassette tapes can cause many problems,
including poor sound, inconsistent playing speed, and
constant auto− reversing. They can also get stuck or
tangled in the cassette player.
 Do not use a cassette if it has been damaged or tangled or
if its label is peeling off.
 Do not leave a cassette in the player if you are not listening
to it, especially if it is hot outside.
 Store cassettes in their cases and out of direct sunlight.
 Avoid using cassettes with a total playing time longer than
100 minutes (50 minutes per side). The tape used in these
cassettes is thin and could get stuck or tangled in the
cassette player. Caring for your CD player and CDs

Your CD player is intended for use with 12 cm (4.7 in.) CDs
only.
 Extremely high temperature can keep your CD player from
working. On hot days, use air conditioning to cool the
vehicle interior before you listen to a CD.
 Bumpy roads or other vibrations may make your CD player
skip.
 If moisture gets into your CD player, you may not hear any
sound even though your CD player appears to be working.
Remove the CD from the player and wait until it dries.
CAUTION
CD players use an invisible laser beam which could
cause hazardous radiation exposure if directed outside
the unit. Be sure to operate the player correctly.

AUDIO
249
20L037
Use only CDs marked as s hown above. The following
products may not be playable on your CD player.
Copy− protected CD
CD− R (CD− Recordable)
CD−RW (CD− Re−writable)
CD−ROM
22sv01
 Special shaped CDs
21z017
Transparent/translucent CDs

AUDIO
250
22sv02
Low quality CDs
22sv03
Labeled CDs
NOTICE
Do not use special shaped, transparent/translucent, low
quality or labeled CDs such as those shown in the
illustrations. The use of such CDs may damage the
player or changer, or it may be impossible to eject the
CD.

AUDIO
251
20L038
Correct Wrong
 Handle CDs carefully, especially when you set them into the
magazine. Hold them on the edge and do not bend them.
Avoid getting fingerprints on them, particularly on the shiny
side.
 Dirt, scratches, warping, pin holes, or other CD damage
could cause the player to skip or to repeat a section of a
track. (To see a pin hole, hold the CD up to the light.)
20L039
To clean a CD: Wipe it with a soft, lint− free cloth that has been
dampened with water. Wipe in a straight line from the center
to the edge of the CD (not in a circle). Do not use a
conventional record cleaner or anti −static device.