2006 LEXUS LX470 power

INTERIOR EQUIPMENT
75
Rear
14X603
The power outlets are designed for power supply for car
accessories.
The ignition key must be in the “ACC” or “ON” position for t\
he
power outlets to be used.
NOTICE
To prevent the fuse from being blown, do not use the
electricity over the total vehicle capacity of 12V/120W
(front and rear outlets together).
 To prevent the battery from being discharged, do not
use the power outlets longer than necessary when
the engine is not running.
Close the power outlet lids when the power outlets
are not in use. Inserting anything other than an
appropriate plug that fits the outlet, or allowing any
liquid to get into the outlet may cause electrical
failure or short circuits.
REAR CONSOLE BOX
14X074
 1
For upper box 2For lower box
To use the rear console box, open as shown in the
illustration.

EXTERIOR EQUIPMENT
95
MOON ROOF
15X016e
 1Open 2Close
To slide open the moon roof, push the “SLIDE” switch on
the rear side. The moon roof will open and stop partway
30 mm (1.2 in.) from the fully opened position. When you
push the switch again, the moon roof will open fully. To
stop partway, push the same switch or push the “TILT”
switch while the moon roof is moving.
As driving with the moon roof opened fully will cause wind
throbs, we recommend you to drive with the moon roof partway
30 mm (1.2 in.) from the fully opened position.
To operate the moon roof, the ignition key must be in the “ON”
position.
The sun shade can be opened or closed manually. However,
if you open the moon roof, the sun shade will be opened with
the moon roof. To close the moon roof, push the switch on the front side.
The moon roof will fully close. To stop partway, push the
same switch or “TILT” switch.
15X017e
 1
Tilt up 2Lower
To tilt up the rear end of the moon roof, push the “TILT”
switch on the “UP” side. The rear end of the moon roof will
tilt up fully. To stop partway, push the same switch or
“SLIDE” switch.
To lower it, push the switch on the opposite side of the
“UP” side. The rear end of the moon roof will fully close.
To stop partway, push the same switch or “SLIDE” switch.
Retained accessory power: Even if the ignition key is turned
to the “ACC” or “LOCK” position with all the doors closed, t\
he
moon roof can be operated until either of the front doors is
opened (or for about 45 seconds).

OCCUPANT RESTRAINT SYSTEMS
133
16x502a
This indicator comes on when the ignition key is turned to
the “ON” position. It goes off after about 6 seconds. This
means the seat belt pretensioners are operating properly.
This warning light system monitors the airbag sensor
assembly, front airbag sensors, side and curtain shield airbag
sensor assemblies, curtain shield airbag sensor assemblies,
driver’s seat position sensor, driver’s seat belt buckle switch,
front passenger occupant classification system and indicator
light, front passenger’s seat belt buckle switch, seat belt
pretensioner assemblies, inflators, roll sensing of curtain
shield airbags off indicator light, interconnecting wiring and
power sources. (For details, see “Service reminder indicators
and warning buzzers” on page 52.) If any of the following conditions occurs, this indicates a
malfunction of the
seat belt pretensioners. Contact your Lexus
dealer as soon as possible.
 The light does not come on when the ignition key is turned
to the “ON” position or remains on for more than 6 seconds
or flashes.
 The light comes on or starts flashing while driving.
 If any seat belt does not retract or cannot be pulled out due
to a malfunction or activation of the relevant seat belt
pretensioner.
 The seat belt pretensioner assembly or surrounding area
has been damaged.
The SRS warning light will come on and front passenger
occupant classification indicator light will indicate “OFF” if
there is a malfunction in the front passenger occupant
classification system.

OCCUPANT RESTRAINT SYSTEMS
134
In the following cases, contact your Lexus dealer as soon as
possible.
The front of the vehicle (shaded in the illustration) was
involved in an accident that was not severe enough to cause
the seat belt pretensioners to operate.
 The seat belt pretensioner assembly or surrounding area is
scratched, cracked, or otherwise damaged.
SRS DRIVER AIRBAG AND FRONT
PASSENGER AIRBAG
16X600
Front airbags
The SRS (Supplemental Restraint System) front airbags
are designed to provide further protection for the driver
and front passenger in addition to the primary safety
protection provided by the seat belts.
Your vehicle is equipped with “ADVANCED AIRBAGS”
designed based on US motor vehicle safety standards
(FMVSS208). The airbag system controls airbag deployment
power for the driver and front passenger. The driver airbag
system consists of the driver s eat’s position sensor, etc. The
front passenger’s airbag system consists of the front
passenger occupant classification sensor, etc.

OCCUPANT RESTRAINT SYSTEMS
142
NOTICE
Do not perform any of the following changes without
consulting your Lexus dealer. Such changes can
interfere with proper operation of the SRS front airbag
system in some cases.
Installation of electronic devices such as a mobile
twoway radio, cassette tape player or CD player.
 Modification of the front end structure.
 Attachment of a grille guard (bull bar, kangaroo bar,
etc.), snowplow, winches or any other equipment to
the front end.
 Repairs made on or near the front fenders, front end
structure, console, steering column, steering wheel,
dashboard near the front passenger airbag or front
seats.
16x502a
This indicator comes on when the ignition key is turned to
the “ON” position. It goes off after about 6 seconds. This
means the SRS front airbags are operating properly.
This warning light system monitors the airbag sensor
assembly, front airbag sensors, side and curtain shield airbag
sensor assemblies, curtain shield airbag sensor assemblies,
driver’s seat position sensor, driver’s seat belt buckle switch,
front passenger occupant classification system and indicator
light, front passenger’s seat belt buckle switch, seat belt
pretensioner assemblies, inflators, roll sensing of curtain
shield airbags off indicator light, interconnecting wiring and
power sources. (For details, see “Service reminder indicators
and warning buzzers” on page 52.)

OCCUPANT RESTRAINT SYSTEMS
155
Failure to follow these instructions can result in death
or serious injury. Consult your Lexus dealer about any
repair and modification.
If you wish to modify your vehicle for a person with a
physical disability, consult your Lexus dealer. It may
dangerously interfere with the SRS side airbags and
curtain shield airbags operation.
NOTICE
Do not perform any of the following changes without
consulting your Lexus dealer. Such changes can
interfere with proper operation of the SRS side airbag
and curtain shield airbag system in some cases.
Installation of electronic devices such as a mobile
twoway radio, cassette tape player or CD player.
 Modification of the side structure of the passenger
compartment.
 Repairs made on or near the console, or front seats.
16x502a
This indicator comes on when the ignition switch is turned
to the “ON” position. It goes off after about 6 seconds.
This means the SRS side airbags and curtain shield
airbags are operating properly.
This warning light system monitors the airbag sensor
assembly, front airba g sensors, side and curtain shield airbag
sensor assemblies, curtain shield airbag sensor assemblies,
driver’s seat position sensor, driver’s seat belt buckle switch,
front passenger occupant classification system and indicator
light, front passenger’s seat belt buckle switch, seat belt
pretensioner assemblies, inflators, roll sensing of curtain
shield airbags off indicator light, interconnecting wiring and
power sources. (For details, see “Service reminder indicators
and warning buzzers” on page 52.)

STEERING WHEEL AND MIRRORS
194
CAUTION
Do not adjust the mirror while the vehicle is moving.
Doing so may cause the driver to mishandle the
vehicle and an accident may occur , resulting in death
or serious injuries.
 Since the mirror surfaces can get hot, do not touch
them when the outside rear view mirror defogger
switch is on.
Power rear view mirror control
16X014f
 1
Control switch 2Master switch
To adjust the power rear view mirror, first place the master
switch at “L” (left) or “R” (right), and push the contro\
l
switch on the desired side.
The power rear view mirrors can be adjusted when the key is
in the “ACC” or “ON” position.

STEERING WHEEL AND MIRRORS
199
CAUTION
Do not adjust the display while the vehicle is moving.
Be sure to adjust the display only when the vehicle is
stopped.
CALIBRATING THE COMPASS (circling calibration)
16x280a
“C” appears on the display in case the circling calibration is
required due to a drastic change in the magnetic field. To
rectify this, follow the calibration procedure below.
16x270
Drive the vehicle slowly (at 8 km/h (5 mph) or lower) in a circle
until the direction is displayed. If there is not enough space to
drive in a circle, drive around the block until the direction is
displayed.
After driving in 1 to 3 circles in the above method, calibration
is complete with the direction shown on the display.
If calibration cannot be performed because of the magnetized
vehicle, etc., take your vehicle to Lexus dealer.
 Do not perform circling calibration of the compass in a place
where the earth’s magnetic field is subject to interference by
artificial magnetic fields (underground parking, under a
steel tower, between buildings, roof parking, near a
crossing, near a large vehicle, etc.).
 During calibration, do not operate electric systems (moon
roof, power windows, etc.) as they may interfere with the
calibration.