2006 LEXUS LX470 inflation pressure

STARTING AND DRIVING
305
Replacing tires and wheels
When replacing the tires and wheels, be sure to install tire
pressure warning valves and transmitters. ID codes on the tire
pressure warning valves and transmitters are registered on the
tire pressure warning ECU. When replacing a tire pressure
warning valve and transmitter, it is necessar y to register the ID
code of tire pressure warning valve and transmitter. Have the
ID code registered by your Lexus dealer.
If the ID code is not registered, the system will not work
properly. After about 1 hour, the tire pressure warning light
blinks to indicate a system malfunction.
NOTICE
When the tires or tire pressure warning valves and
transmitters must be replaced, have them replaced by
your Lexus dealer. The tire pressure warning valves
and transmitters will be affected by the installation or
removal of tires.
Tire pressure warning reset switch
31x612
When initializing the system, the present tire inflation pressure
is stored as standard. The tire pressure warning system
determines decreased air pressure by comparing the present
and the standard tire inflation pressures. When you change
the set tire inflation pressure, it is necessary to initialize the tire
pressure warning system.
 When rotating the tires on vehicles differing with front and
rear tire inflation pressures.
 When changing the tire inflation pressure by changing
traveling speed or load weight, etc.
 When changing the tire size.

STARTING AND DRIVING
306To initialize the system, perform the following:
1. Park the vehicle in a safe place and turn the ignition switch
to the “OFF” position.
2. Adjust the pressure of all the installed tires to the specified
cold tire inflation pressure level. (See “Tire and wheels” on
page 420.)
3. Turn the ignition switch to the “ON” position.
4. Push and hold the tire pressure warning reset switch until
the tire pressure warning light blinks slowly three times.
5. Wait for a few minutes with the ignition switch “ON”, and
then turn the ignition switch to the “OFF” position.
If you push the tire pressure reset switch while the vehicle is
moving, initialization is not performed.
If you push the tire pressure reset switch accidentally and
initialization is performed, adjust the tire inflation pressure to
the specified level and initialize the system again.
31x609
If the tire pressure warning light does not blink slowly three
times when you push and hold the reset switch, initialization
has failed and the tire pressure warning system may not work
properly. In this case, initialize the system again. If
initialization
cannot be performed, have the system checked at
your Lexus dealer.
CAUTION
Do not push the reset switch without first adjusting the
tire inflation pressure to the specified level. Otherwise,
the tire pressure warning light may not come on even if
the tire inflation pressure is low, or it may come on when
the tire inflation pressure is actually normal.

DRIVING TIPS
322
Brakes and safety chains
Lexus recommends trailers with brakes that conform to
any applicable federal and state/provincial regulations.
 A safety chain must always be used between the towing
vehicle and the trailer. Leave sufficient slack in the
chain for turns. The chain should cross under the
trailer tongue to prevent the tongue from dropping to
the ground in case it becomes damaged or separated.
For correct safety chain procedures, consult your
Lexus dealer.
CAUTION
If the total trailer weight exceeds 453 kg (1000 lb.),
trailer brakes are required.
 Never tap into your vehicle’s hydraulic system as it
will lower its braking effectiveness.
 Never tow a trailer without using a safety chain
securely attached to both the trailer and the vehicle.
If damage occurs to the coupling unit or hitch ball,
there is possible danger of the trailer wandering over
into another lane.
Tires
Ensure that your vehicle’s tires are properly inflated. Adjust
the tire inflation pressure to the recommended cold tire
inflation pressure indicated below:
Tire inflation pressure, kPa (kgf/cm
2 or bar, psi)
Front 220 (2.2, 32)
Rear 240 (2.4, 35)
 The trailer tires should be inflated to the pressure
recommended by the trailer manufacturer in respect to the
total trailer weight.

DRIVING TIPS
327
HOW TO SAVE FUEL AND MAKEYOUR VEHICLE LAST LONGER
Improving fuel economy is easy − just take it easy. It will help
make your vehicle last longer, too. Here are some specific tips
on how to save money on both fuel and repairs:
 Keep your tires inflated at the correct pressure. Check
the pressure every two weeks, or at least once a month.
Underinflation causes tire wear and wastes fuel.
 Do not carry unneeded weight in your vehicle. Excess
weight puts a heavier load on the engine, causing greater
fuel consumption.
 Avoid lengthy warmup idling. Once the engine is
running smoothly, begin driving − but gently. Remember,
however, that on cold winter days this may take a little
longer.
 Accelerate slowly and smoothly. Avoid jackrabbit starts.
 Avoid long engine idling. If you have a long wait and you
are not in traffic, it is better to turn off the engine and start
again later.
 Avoid engine overrevving. Use a gear position suitable
for the road on which you are traveling. 
Avoid continuous speeding up and slowing down.
Stop−and−go driving wastes fuel.
 Avoid unnecessary stopping and braking. Maintain a
steady pace. Try to time the traf fic signals so you only need
to stop as little as possible or take advantage of through
streets to avoid traffic lights. Keep a proper distance from
other vehicles to avoid sudden braking. This will also
reduce wear on your brakes.
 Avoid heavy traffic or traffic jams whenever possible.
 Do not rest your foot on the brake pedal. This causes
premature wear, overheating and poor fuel economy.
 Maintain a moderate speed on highways. The faster you
drive, the greater the fuel consumption. By reducing your
speed, you will cut down on fuel consumption.
 Keep the front wheels in proper alignment. Avoid hitting
the curb and slow down on rough roads. Improper
alignment not only causes faster tire wear but also puts an
extra load on the engine, which, in turn, wastes fuel.
 Keep the bottom of your vehicle free from mud, etc.
This not only lessens weight but also helps prevent
corrosion.

DRIVING TIPS
328
Keep your vehicle tunedup and in top shape. A dirty air
cleaner, improper valve clearance, dirty plugs, dirty oil and
grease, brakes not adjusted, etc. all lower engine
performance and contribute to poor fuel economy. For
longer life of all parts and lower operating costs, keep all
maintenance work on schedule, and if you often drive under
severe conditions, see that your vehicle receives more
frequent maintenance. (For scheduled maintenance
information, please refer to the “Owner’s Manual
Supplement / Scheduled Maintenance”.)
CAUTION
Never turn off the engine to coast down hills. Your
power steering and brake booster will not function
without the engine running. Also, the emission control
system operates properly only when the engine is
running.
VEHICLE LOAD LIMITS
Vehicle load limits include total load capacity, seating
capacity, towing capacity and cargo capacity . Follow the
load limits shown below. Total load capacity and seating
capacity are also described on the tire and loading
information label. For location of the tire and loading
information label, see “Checking tire inflation pressure”
on page 424.
Total load capacity: 545 kg (1200 lb.)
Total load capacity means combined weight of
occupants, cargo and luggage. To ngue load is included
when trailer towing.
Seating capacity: Total 8 (Front 2, Rear 6)
Seating capacity means the maximum number of
occupants whose estimated average weight is 68 kg
(150 lb.) per person. Depending on the weight of each
person, the seating capacity given may exceed the total
load capacity.
NOTICE
Even if the number of occupants are within the
seating capacity, do not exceed the total load
capacity.

MAINTENANCE
389
Accelerator pedal
Check
the pedal for smooth operation and uneven pedal ef fort
or catching.
Brake pedal
Check the pedal for smooth operation and the proper
clearance and free play. Check the brake booster function.
Brakes
In a safe place, check that the brakes do not pull to one side
when applied.
Parking brake
Check that the lever has the proper travel and that, on a safe
incline, your vehicle is held securely with only the parking
brake applied.
Automatic transmission “Park” mechanism
Check the lock release button of the selector lever for proper
and smooth operation. On a safe incline, check that your
vehicle is held securely with the selector lever in “P” position
and all brakes released.
Vehicle exterior
Items listed below should be performed from time to time,
unless otherwise specified.
Wheel nuts
When checking the tires, make sure to check the nuts for
looseness. Tighten them if necessary.
Fluid leaks
Check underneath for leaking fuel, oil, water or other fluid after
the vehicle has been parked for a while. If you smell fuel fumes
or notice any leak, have the cause found and corrected
immediately.
Doors and engine hood
Check that all doors and back door, operate smoothly and all
latches lock securely. Make sure the engine hood secondary
latch secures the hood when the primary latch is released.
Tire inflation pressure
Check the pressure with a gauge every two weeks, or at
least once a month and adjust as shown on the tire and
loading information label. See page 424 for additional
information.
Tire surface
Check the tires carefully for cuts, damage or excessive
wear. See page 438 for additional information.

SECTION 6 – 3
417
SERVICE PROCEDURES AND
SPECIFICATIONS
Chassis
Specifications418
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .\
. . . . . .
Checking brake fluid 421
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .\
.
Checking power steering fluid 422
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Checking suspension fluid AHC 423
. . . . . . . . . . . . . . . . . . . . . . . . . . . .
Checking tire inflation pressure 424
. . . . . . . . . . . . . . . . . . . . . . . . . . . .
Tire information 428
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .\
. . . . .
Types of tires 436
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .\
. . . . . . .
Rotating tires 437
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .\
. . . . . . .
Checking and replacing tires 438
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Installing snow tires and chains 440
. . . . . . . . . . . . . . . . . . . . . . . . . . . .
Replacing wheels 442
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .\
. . .
Aluminum wheel precautions 443
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Suspension and chassis 443
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

CHASSIS
420– STEERING
Free play
Less than 40 mm (1.6 in.)
Power steering fluidAutomatic transmission fluid DEXRONII or III
– SUSPENSION
Fluid type
Suspension fluid AHC
– TIRES AND WHEELS
Tire sizeP275/60R18 111H
Tire inflation pressure
Recommended cold tire inflation pressure
Normal driving
Trailer towing
Front 200 kPa (2.0 kgf/cm2 or bar, 29 psi)
Rear 220 kPa (2.2 kgf/cm2 or bar, 32 psi)
Spare 220 kPa (2.2 kgf/cm2 or bar, 32 psi)
Front 220 kPa (2.2 kgf/cm
2 or bar, 32 psi)
Rear 240 kPa (2.4 kgf/cm2 or bar, 35 psi)
Spare 240 kPa (2.4 kgf/cm2 or bar, 35 psi)
Wheel size18 x 8J
Wheel nut torque131 N·m (13.4 kgf·m, 97 ft·lbf.)
NOTE:
For complete information on tires (e.g. replacing tires or replacing wh\
eels), see “Checking tire inflation pressure”
through “Aluminum wheel precautions” on page 424 through 443.