2006 INFINITI G35 engine

CAUTIONOil level should be checked regularly. Oper-
ating the engine with an insufficient amount
of oil can damage the engine, and such dam-
age is not covered by warranty.
CHANGING ENGINE OIL AND FILTER Change the engine oil and filter according
to the maintenance intervals shown in the
INFINITI Service and Maintenance Guide.
Vehicle set-up 1. Park the vehicle on a level surface and
apply the parking brake.
2. Run the engine until it reaches operat-
ing temperature.
3. Turn the engine off and wait more
than 10 minutes.
4. Raise and support the vehicle using a
suitable floor jack and safety jack
stands.
O Place the safety jack stands under
the vehicle jack-up points.
O A suitable adapter should be at-
tached to the jack stand saddle. 5. Remove the plastic engine undercover.
a. Remove the small plastic clip at the
center point of the undercover.
b. Then remove the other bolts that
hold the undercover in place.
CAUTION Make sure the correct lifting and support
points are used to avoid vehicle damage.
Engine oil and filter 1. Place a large drain pan under the
drain plug.
2. Remove the oil filler cap.
3. Remove the drain plug
q A
with a
wrench and completely drain the oil.
CAUTION Be careful not to burn yourself, as the engine
oil is hot. SDI1520B
Maintenance and do-it-yourself
8-11
w 06.1.4/V35-D/V5.0
X

O Waste oil must be disposed of prop-
erly.
O Check your local regulations.
4. Loosen the oil filter with an oil filter
wrench
q B
. Remove the oil filter by
turning it by hand.
5. Wipe the engine oil filter mounting
surface with a clean rag.
Be sure to remove any old rubber
gasket remaining on the mounting sur-
face of the engine.
6. Coat the gasket on the new filter with
clean engine oil.
7. Screw in the oil filter clockwise until a
slight resistance is felt, then tighten
additionally more than 2/3 turn.
Oil filter tightening torque:
11 to 15 ft-lb
(14.7 to 20.5 N z m)
8. Clean and re-install the drain plug
with a new washer. Securely tighten
the drain plug with a wrench.
Drain plug tightening torque:
22 to 29 ft-lb
(29 to 39 N z m)
Do not use excessive force. 9. Refill engine with recommended oil
and install the cap securely.
CAUTION The dipstick must be inserted in place to pre-
vent oil spillage from the dipstick hole while
filling the engine with oil.
See ªCapacities and recommended
fuel/lubricantsº in the ª9. Technical
and consumer informationº section for
drain and refill capacity. The drain and
refill capacity depends on the oil tem-
perature and drain time. Use these
specifications for reference only. Al-
ways use the dipstick to determine the
proper amount of oil in the engine.
CAUTION When filling oil, do not pull out the dipstick.
10. Start the engine and check for
leakage around the drain plug and
the oil filter. Correct as required. 11. Turn the engine off and wait more
than 10 minutes. Check the oil level
with the dipstick. Add engine oil if
necessary.
After the operation 1. Install the engine undercover into po-
sition as the following steps.
a. Pull the center of the small plastic
clip out.
b. Hold the engine undercover into
position.
c. Insert the clip through the under-
cover into the hole in the frame,
then push the center of the clip in
to lock the clip in place.
d. Install the other bolts that hold the
undercover in place. Be careful not
to strip the bolts or over-tighten
them.
2. Lower the vehicle carefully to the
ground.
3. Dispose of waste oil and filter prop-
erly.
8-12 Maintenance and do-it-yourself
w 06.1.4/V35-D/V5.0
X

WARNINGO Prolonged and repeated contact with
used engine oil may cause skin cancer.
O Try to avoid direct skin contact with used
oil. If skin contact is made, wash thor-
oughly with soap or hand cleaner as
soon as possible.
O Keep used engine oil out of reach of
children. When checking or replacement is re-
quired, we recommend an INFINITI dealer
for servicing.
CAUTION O Use only Genuine NISSAN Matic J ATF. Do
not mix with other fluids.
O Using automatic transmission fluid
other than Genuine NISSAN Matic J ATF
will cause deterioration in driveability
and automatic transmission durability,
and may damage the automatic trans-
mission, which is not covered by the
INFINITI new vehicle limited warranty.
The specified automatic transmission
fluid is also described on caution labels
located in the engine compartment. Check the fluid level in the reservoir.
The fluid level should be checked using
the HOT range (
q 1
: HOT MAX.,
q 2
: HOT
MIN.) at fluid temperatures of 122 to 176ÉF
(50 to 80ÉC) or using the COLD range (
q 3
:
COLD MAX.,
q 4
: COLD MIN.) at fluid tem-
peratures of 32 to 86ÉF (0 to 30ÉC). SDI1765A
AUTOMATIC TRANSMISSION FLUID POWER STEERING FLUID
Maintenance and do-it-yourself
8-13
w 06.1.4/V35-D/V5.0
X

WARNINGAntifreeze is poisonous and should be
stored carefully in marked containers out of
the reach of children.
CAUTIONDo not substitute engine anti-freeze coolant
for window washer solution. This may result
in damage to the paint.
O Do not fill the window washer reservoir
tank with washer fluid concentrates at
full strength. Some methyl alcohol
based washer fluid concentrates may
permanently stain the grille if spilled
while filling the window washer reser-
voir tank.
O Pre-mix washer fluid concentrates with
water to the manufacturer's recom-
mended levels before pouring the fluid
into the window washer reservoir tank. Do not use the window washer reservoir
tank to mix the washer fluid concen-
trateand water. O Keep the battery surface clean and
dry. Any corrosion should be washed
off with a solution of baking soda and
water.
O Make certain the terminal connections
are clean and securely tightened.
O If the vehicle is not to be used for 30
days or longer, disconnect the (þ)
negative battery terminal cable to pre-
vent discharging it.
Coupe
CAUTION When the battery cable is removed from the
battery terminal, do not close either of front
doors. The automatic window adjusting func-
tion will not work, and the side roof panel
may be damaged.
To disconnect the negative (þ) battery ter-
minal, perform the procedure in the follow-
ing order. Otherwise, the window and the
side roof panel may contact and be dam-
aged.
1. Close the windows.BATTERY
8-16 Maintenance and do-it-yourself
w 06.1.4/V35-D/V5.0
X

Check the fluid level in each cell. It
should be between the UPPER LEVEL
q 1
and LOWER LEVEL
q 2
lines.
If it is necessary to add fluid, add only
distilled water to bring the level to the in-
dicator in each filler opening. Do not over-
fill.
1. Remove the cell plugs
q A
.
2. Add distilled water up to the UPPER
LEVEL
q 1
. If the side of the battery is not visible,
the electrolyte level can be checked
through each filler opening as illus-
trated.
3. Tighten cell plugs
q A
.
Vehicles operated in high temperatures or
under severe conditions require frequent
checks of the battery fluid level. JUMP STARTING If jump starting is necessary, see ªJump
startingº in the ª6. In case of emergencyº
section. If the engine does not start by
jump starting, the battery may have to be
replaced. Contact an INFINITI dealer.DI0137MA SDI1480
8-18 Maintenance and do-it-yourself
w 06.1.4/V35-D/V5.0
X

1. Power steering fluid pump
2. Fan
3. Alternator
4. Crankshaft pulley
5. Air conditioner compressor
D : Tension checking points WARNING Be sure the ignition key is in the OFF or LOCK
position. The engine could rotate unexpect-
edly.
1. Visually inspect each belt for signs of
unusual wear, cuts, fraying, oil adhe-
sion or looseness. If the belt is in poor
condition or loose, have it replaced or
adjusted by an INFINITI dealer.
2. Have the belts checked regularly for
condition and tension in accordance
with the maintenance schedule in the
INFINITI Service and Maintenance
Guide.
WARNING Be sure the engine and ignition switch are
off and that the parking brake is engaged se-
curely.
CAUTION Be sure to use the correct socket to remove
the spark plugs. An incorrect socket can
damage the spark plugs.SDI1389
DRIVE BELTS SPARK PLUGS
Maintenance and do-it-yourself
8-19
w 06.1.4/V35-D/V5.0
X

REPLACING SPARK PLUGS If replacement is required, see an INFINITI
dealer for servicing.
Platinum-tipped spark plugs It is not necessary to replace the
platinum-tipped
q A
spark plugs as fre-
quently as the conventional type spark
plugs since they will last much longer.
Follow the maintenance schedule in the
INFINITI Service and Maintenance Guide,
but do not reuse them by cleaning or re-
gapping. Always replace with recommended
platinum-tipped spark plugs. If maintenance is required, see an INFINITI
dealer for servicing.
The filter element should not be cleaned
and reused. Replace it according to the
maintenance intervals. See the INFINITI
Service and Maintenance Guide. When re-
placing the filter, wipe the inside of the
air cleaner housing and the cover with a
damp cloth.
WARNING O Operating the engine with the air cleaner
removed can cause you or others to be
burned. The air cleaner not only cleans
the air, it stops the flame if the engine
backfires. If it is not there, and the en-
gine backfires, you could be burned. Do
not drive with the air cleaner removed,
and be careful when working on the en-
gine with the air cleaner removed.
O Never pour fuel into the throttle body or
attempt to start the engine with the air
cleaner removed. Doing so could result
in serious injury.SDI0145D
AIR CLEANER
8-20 Maintenance and do-it-yourself
w 06.1.4/V35-D/V5.0
X

CAUTIONO After wiper blade replacement, return
the wiper arm to its original position.
Otherwise it may be damaged when the
engine hood is opened.
O Make sure the wiper blades contact the
glass, otherwise the arms may be dam-
aged from wind pressure.
O Worn windshield wiper blades can
damage the windshield and impair driver
vision.
CLEANING If your windshield is not clear after using
the windshield washer or if a wiper blade
chatters when running, wax or other ma-
terial may be on the blade or windshield.
Clean the outside of the windshield with a
washer solution or a mild detergent. Your
windshield is clean if beads do not form
when rinsing with clear water.
Clean the blade by wiping it with a cloth
soaked in a washer solution or a mild de- tergent. Then rinse the blade with clear
water. If your windshield is still not clear
after cleaning the blades and using the
wiper, replace the blades.
WINDSHIELD WIPER BLADES
Maintenance and do-it-yourself
8-21
w 06.1.4/V35-D/V5.0
X