2006 Hyundai Accent engine oil

6
OWNER MAINTENANCE
7
Petrol engine
Diesel engine
G030D02A-EAT ENGINE OIL REPLENISHMENT
If the indicated oil level is at or below the lower mark of the dipstick, oil should be added until the level is at or below the upper mark.To add oil to the engine, remove the filler cap by rotating in an counterclock- wise direction and pour engine oil intothe engine. Before checking the level again, allow several minutes for the oil to drain into the sump. Replace the oilfiller cap rotating it in a clockwise direc- tion until tight. The quantity of oil required to raise the level from the minimum to maximum level is approximately 1 litre (PetrolEngine)/ 1.2 litres (Diesel Engine).ZG030E1-A ENGINE OIL CONSUMPTION Function of engine oil Engine oil has the primary function of lubricating and cooling the inside of theengine. Engine oil consumption It is normal that an engine should con- sume some engine oil while normal driving. The cause of oil consumption in a normal engine are as follows;
o Engine oil is used to lubricate pis-
tons, piston rings and cylinders. A thin film of oil is left on the cylinder wall when a piston moves down- wards in the cylinder. High negativepressure generated during engine operation sucks some of the oil into the combustion chamber.This oil with some oil of the cylinder wall is burned by the high tempera- ture combustion gases during thecombustion process.
G030D03A
G030D02A

6OWNER MAINTENANCE
8
HTB222
Oil filler cap
Drain plug Oil filter
ENGINE OIL AND FILTER REPLACEMENT
o The engine oil consumption is strongly effected by the viscosity and quality of oil, engine rpm and driving condi- tion etc. More engine oil may be consumedunder severe driving conditions such as high speeds, frequent accelera- tion and deceleration, compared tonormal driving. G040A04A-EAT
The engine oil and filter must be changedat the time or mileage interval specifiedin the maintenance schedule. If the vehicle is operated under severe or adverse conditions, the oil and filtermust be replaced more frequently. To replace the oil and filter, proceed as follows:
1. Ensure that the engine is at normaloperating temperature and park the vehicle on level ground with the park- ing brake securely applied and the engine turned off.
2. Open the bonnet and remove the oil filler cap.
Petrol Engine (1.3/1.5 SOHC) Petrol Engine(1.6 DOHC)
Diesel Engine
F040A02TB
Oil filler cap Drain plug
Oil filter
.........
G040C01A-1Engine oil drain plug
Oil filter
Oil filler cap

6
OWNER MAINTENANCE
9ENGINE COOLANT CHECK-
ING AND REPLACING
CAUTION:
The oil being drained from the en- gine will be hot. Care should beexercised to prevent scalding.
!
3. Prepare a suitable receptacle to col-
lect the displaced oil and remove the drain plug from the sump.
!
4. When the oil has drained from thesump, replace the drain plug using a new washer ensuring that the plug isnot over tightened. Tightening torque is: 3.5 ~ 4.5 kgf.m
5. Remove the oil filter by rotating coun- terclockwise, using a proprietary oil filter removal tool if necessary. Note that the oil filter will contain approxi-mately 0.3 litres of oil and this should be collected in a suitable receptacle.
6. Install a new oil filter having smeared the sealing ring with clean oil androtating clockwise until the filter con- tacts the mounting and then a furtherone half turn. Do not over-tighten. WARNING:
Prolonged and repeated contact with used engine oils may result in seri- ous skin disorders including derma-titis and cancer. Avoid contact with skin as far as possible and always wash thoroughly after any contact.Keep used oils out of reach of chil- dren. It is illegal to pollute drains, water courses and soil. Use onlyauthorized waste collection facili- ties including civic amenity sites and garages for the disposal of usedoil and oil filters. If in doubt, contact the local authority for disposal in- structions. Tightening torque:
Petrol -
1.2 ~ 1.6 kgf.m
Diesel - 2.3 ~ 2.5 kgf.m
7. Pour the specified quantity of the recommended oil into the engine and replace the filler cap. Start the en- gine and ensure that no oil leaksexist. Turn off the engine and after a couple minutes, recheck the oil level.
!
SG050A1-E
WARNING:
Do not remove the radiator cap when the engine is hot, since the system is pressurized and coolant may beejected from the radiator resulting in scalding.

6OWNER MAINTENANCE
14WINDSCREEN WIPER BLADES
CAUTION:
Engine coolant anti freeze must not be used in the windscreen washersystem since damage to the paintwork may result. Undiluted windscreen washer addi-tive must not be allowed to come into contact with the paintwork. If spillage occurs, flush the affectedarea immediately with water. Do not operate the windscreen washer for more than 15 seconds continuouslyor when the reservoir is empty since damage to the washer pump will result.
!
The level of windscreen washer fluid available should be checked on a daily basis. The level of fluid will be visible through the side of the reservoir. Whenthe fluid is to be replenished, only a proprietary screen wash additive should be used and in the concentration rec-ommended by the manufacturer. The windscreen washer reservoir has a total capacity of 3 litres.
SG090A2-E
G080A01A-EAT The wiper blades should be carefully inspected from time to time and cleanedto remove accumulations of road film or other debris. To clean the wiper blades and arms, use a clean sponge or clothwith a mild soap or detergent and water. If the wipers continue to streak or smear the glass, replace them with genuineHyundai replacement. NOTE:
o Do not operate the wipers on dry
glass since rapid wear and damage to the windscreen glass may result.
o Keep the blade rubber out of con-
tact with petroleum products suchas engine oil, petrol, etc.
HEF119 HLC5007
WINDSCREEN WASHER RES- ERVOIR REPLENISHMENT

6
OWNER MAINTENANCE
15CHECKING THE TRANSAXLE OIL
!
SG100A1-E MANUAL TRANSAXLE LUBRICANT The manual transaxle lubricant must be checked and or changed at the inter- vals specified in the maintenance sched- ule. Only those lubricants specifiedshould be used in order to prevent gear shifting difficulties or transaxle dam- age. WARNING:
The transaxle lubricant level shouldonly be checked when the engine is cold to preclude the possibility of personal injury by contact with hotcomponents.
HXGS506
Drain plug
Filler plug
Recommended Oil Use only the approved transaxle lubri- cant. The recommended lubricants are complete in themselves and the use of additives is neither required nor recom-mended. The use of additives may invalidate the vehicle warranty. Ensure that the vehicle is parked on level ground with the parking brakefirmly applied and the engine cool. Re- move the level plug from the transaxle when lubricant should begin to drip fromthe level hole. If the level is low and no lubricant is seen to drip, add the re- quired quantity of lubricant and replacethe plug.
Transaxle Lubricant Level Checking
G100B01L

6OWNER MAINTENANCE
28HEADLIGHT AIMING ADJUSTMENT
!
1. Loosen the drain plug at the bottom
of the fuel filter.
2. Tighten the drain plug when water no longer comes out.
3. Check to be sure that the warning light illuminates when the ignition key is turned to "ON", and that it goes off when the engine is started.If in doubt, consult your nearest au- thorized HYUNDAI dealer.
NOTE: It is recommended that water accu- mulated in the fuel filter should be removed by an authorized Hyundaidealer. WARNING:
Be sure to carefully wipe away any water drained out in this manner, because the fuel mixed in the watermight be ignited and result in a fire. G290A03A-EAT Before performing aiming adjustment, make sure of the following.
1. Keep all tyres inflated to the correct
pressure.
2. Place the vehicle on level ground
and press the front bumper and rear bumper down several times. Place the vehicle at a distance of 118 in. (3,000 mm) from the test wall.
3. See that the vehicle is unloaded (except for full levels of coolant,engine oil and fuel, and spare tyre,jack, and tools). Have the driver or equivalent weight placed in driver's seat.
4. Clean the head lights lens and turn on the headlight (low beam).
G300B01A

6OWNER MAINTENANCE
30REPLACING LIGHT BULBS
G270A03A-EAT Headlight Bulb
1. Allow the bulb to cool. Wear eyeprotection.
2. Open the engine bonnet.
3. Always grasp the bulb by its plastic
base, avoid touching the glass.
4. Using a spanner, remove the head- light assembly mounting bolts. 5. Disconnect the power cord from the
bulb base in the back of the head-light.
6. Remove the dust cover.
G260A03A-EAT In the event of bulb failure being expe- rienced, ensure that the relative lighting circuit is turned off prior to attempting to replace the bulb. The illustrations onthe following page will assist in locating and removing the various bulbs. En- sure that the replacement bulb has thesame cap configuration and wattage as the original. See page 6-34 for the wattage descrip-tions.
!
CAUTION:
Keep the lamps out of contact with petroleum products, such as oil, petrol, etc. HLC5033
HLC5009
HLC5034-1

9VEHICLE SPECIFICATIONS
4
Oil & Grease Standard
API SJ, SL or ABOVE SAE 5W-20, 5W-30
ILSAC GF-3 or ABOVE SAE 10W-30 (ABOVE -18°C) SAE 15W-40 (ABOVE -13°C) SAE 20W-50 (ABOVE -7°C)
API CF-4 SAE 30 [32°F ~ 104°F(0°C ~ 40°C)]
or ABOVE, SAE 20W-40 [ABOVE 14°F(-10°C)]
ACEA B4 SAE 15W-40 [ABOVE 5°F(-15°C)]
or ABOVE SAE 10W-30 [-4°F ~ 104°F(-20°C ~ 40°C)] SAE 5W-30 [-13°F ~ 50°F(-25°C ~ 10°C)] SAE 0W-30 [BELOW 50°F(10°C)] *1, *2
*1. Restricted to driving condition and vehicle destination*2. Not recommended for sustained high speed vehicle operationNormal driving condition Severe driving condition HYUNDAI GENUINE PARTS MTF 75W/85 (API GL-4)Hyundai Genuine ATF S III, Diamond ATF SP III or other brands approved by Hyundai Motor Co. PSF-3 or Dexron 2DOT 3, DOT 4 or equivalent Ethylene glycol base for aluminium radiatorLUBRICATION CHART
Manual T/A Automatic T/AItem
Engine Oil Petrol Diesel
Engine Oil Consumption Transaxle Power Steering
Brake Fluid Coolant
J080A09A-EAT
Q'ty (Imp.qts)(Litre)
Drain and refill (with oil filter) : 2.9(3.3) Drain and refill (with oil filter) : 4.2(4.8) MAX. 1L / 1,500 Km MAX. 1L / 1,000 Km 1.86(2.15) 5.3(6.1) (Petrol Engine only) As required As required1.3/1.5L:4.8, 1.6L:5.2 Diesel:4.7 1.3/1.5L:5.2, 1.6L:4.8
Manual Automatic