2006 Hyundai Accent recommended oil

6
OWNER MAINTENANCE
9ENGINE COOLANT CHECK-
ING AND REPLACING
CAUTION:
The oil being drained from the en- gine will be hot. Care should beexercised to prevent scalding.
!
3. Prepare a suitable receptacle to col-
lect the displaced oil and remove the drain plug from the sump.
!
4. When the oil has drained from thesump, replace the drain plug using a new washer ensuring that the plug isnot over tightened. Tightening torque is: 3.5 ~ 4.5 kgf.m
5. Remove the oil filter by rotating coun- terclockwise, using a proprietary oil filter removal tool if necessary. Note that the oil filter will contain approxi-mately 0.3 litres of oil and this should be collected in a suitable receptacle.
6. Install a new oil filter having smeared the sealing ring with clean oil androtating clockwise until the filter con- tacts the mounting and then a furtherone half turn. Do not over-tighten. WARNING:
Prolonged and repeated contact with used engine oils may result in seri- ous skin disorders including derma-titis and cancer. Avoid contact with skin as far as possible and always wash thoroughly after any contact.Keep used oils out of reach of chil- dren. It is illegal to pollute drains, water courses and soil. Use onlyauthorized waste collection facili- ties including civic amenity sites and garages for the disposal of usedoil and oil filters. If in doubt, contact the local authority for disposal in- structions. Tightening torque:
Petrol -
1.2 ~ 1.6 kgf.m
Diesel - 2.3 ~ 2.5 kgf.m
7. Pour the specified quantity of the recommended oil into the engine and replace the filler cap. Start the en- gine and ensure that no oil leaksexist. Turn off the engine and after a couple minutes, recheck the oil level.
!
SG050A1-E
WARNING:
Do not remove the radiator cap when the engine is hot, since the system is pressurized and coolant may beejected from the radiator resulting in scalding.

6
OWNER MAINTENANCE
15CHECKING THE TRANSAXLE OIL
!
SG100A1-E MANUAL TRANSAXLE LUBRICANT The manual transaxle lubricant must be checked and or changed at the inter- vals specified in the maintenance sched- ule. Only those lubricants specifiedshould be used in order to prevent gear shifting difficulties or transaxle dam- age. WARNING:
The transaxle lubricant level shouldonly be checked when the engine is cold to preclude the possibility of personal injury by contact with hotcomponents.
HXGS506
Drain plug
Filler plug
Recommended Oil Use only the approved transaxle lubri- cant. The recommended lubricants are complete in themselves and the use of additives is neither required nor recom-mended. The use of additives may invalidate the vehicle warranty. Ensure that the vehicle is parked on level ground with the parking brakefirmly applied and the engine cool. Re- move the level plug from the transaxle when lubricant should begin to drip fromthe level hole. If the level is low and no lubricant is seen to drip, add the re- quired quantity of lubricant and replacethe plug.
Transaxle Lubricant Level Checking
G100B01L

6OWNER MAINTENANCE
28HEADLIGHT AIMING ADJUSTMENT
!
1. Loosen the drain plug at the bottom
of the fuel filter.
2. Tighten the drain plug when water no longer comes out.
3. Check to be sure that the warning light illuminates when the ignition key is turned to "ON", and that it goes off when the engine is started.If in doubt, consult your nearest au- thorized HYUNDAI dealer.
NOTE: It is recommended that water accu- mulated in the fuel filter should be removed by an authorized Hyundaidealer. WARNING:
Be sure to carefully wipe away any water drained out in this manner, because the fuel mixed in the watermight be ignited and result in a fire. G290A03A-EAT Before performing aiming adjustment, make sure of the following.
1. Keep all tyres inflated to the correct
pressure.
2. Place the vehicle on level ground
and press the front bumper and rear bumper down several times. Place the vehicle at a distance of 118 in. (3,000 mm) from the test wall.
3. See that the vehicle is unloaded (except for full levels of coolant,engine oil and fuel, and spare tyre,jack, and tools). Have the driver or equivalent weight placed in driver's seat.
4. Clean the head lights lens and turn on the headlight (low beam).
G300B01A

9VEHICLE SPECIFICATIONS
4
Oil & Grease Standard
API SJ, SL or ABOVE SAE 5W-20, 5W-30
ILSAC GF-3 or ABOVE SAE 10W-30 (ABOVE -18°C) SAE 15W-40 (ABOVE -13°C) SAE 20W-50 (ABOVE -7°C)
API CF-4 SAE 30 [32°F ~ 104°F(0°C ~ 40°C)]
or ABOVE, SAE 20W-40 [ABOVE 14°F(-10°C)]
ACEA B4 SAE 15W-40 [ABOVE 5°F(-15°C)]
or ABOVE SAE 10W-30 [-4°F ~ 104°F(-20°C ~ 40°C)] SAE 5W-30 [-13°F ~ 50°F(-25°C ~ 10°C)] SAE 0W-30 [BELOW 50°F(10°C)] *1, *2
*1. Restricted to driving condition and vehicle destination*2. Not recommended for sustained high speed vehicle operationNormal driving condition Severe driving condition HYUNDAI GENUINE PARTS MTF 75W/85 (API GL-4)Hyundai Genuine ATF S III, Diamond ATF SP III or other brands approved by Hyundai Motor Co. PSF-3 or Dexron 2DOT 3, DOT 4 or equivalent Ethylene glycol base for aluminium radiatorLUBRICATION CHART
Manual T/A Automatic T/AItem
Engine Oil Petrol Diesel
Engine Oil Consumption Transaxle Power Steering
Brake Fluid Coolant
J080A09A-EAT
Q'ty (Imp.qts)(Litre)
Drain and refill (with oil filter) : 2.9(3.3) Drain and refill (with oil filter) : 4.2(4.8) MAX. 1L / 1,500 Km MAX. 1L / 1,000 Km 1.86(2.15) 5.3(6.1) (Petrol Engine only) As required As required1.3/1.5L:4.8, 1.6L:5.2 Diesel:4.7 1.3/1.5L:5.2, 1.6L:4.8
Manual Automatic