2006 Hyundai Accent headrest

1
FEATURES OF YOUR HYUNDAI
15
!!WARNING:
To minimize risk of severe injury in the event of a collision or a sudden stop, both the driver and passenger seatbacks should always be in anupright position while the vehicle is in motion. The protection provided by the seat belts and airbags in afrontal collision may be reduced sig- nificantly when the seatbacks are reclined. There is greater risk thatthe driver and passenger will slide under the seat belt which may result in serious injury if a crash occurswhen the seatbacks are reclined. The seat belt cannot provide full protec- tion to an occupant if the seatback isreclined. B080D02A-AAT Adjustable Headrests
Headrests are designed to help reduce the risk of neck injuries. To raise the headrest, pull it up. To lower it, push it down while pressing thelock knob. To remove the headrest, raise it as far as it can go then press the lock knob while pulling upward. WARNING:
o For maximum effectiveness in case of an accident, the headrest shouldbe adjusted so the top of the head-rest is at the same height as the top of the occupant's ears. The use of a cushion that holds thebody away from the seatback is not recommended.
B080D01A-1
Lock Knob
o Do not operate the vehicle with the
headrests removed as severe in- jury to an occupant may occur in the event of an accident. Head- rests may provide protectionagainst severe neck injuries when properly adjusted. B080D01JM

1FEATURES OF YOUR HYUNDAI
16
B100A01A-GAT SEAT WARMER (If Installed)
The seat warmer is provided to warm the front seats during cold weather. With the ignition key in the "ON" posi- tion, push either of the switches on therear console to warm the driver's seat or the passenger's seat. During mild weather or under conditionsthat the operation of the seat warmer is not needed, keep the switches in the "OFF" position. B100A01A
B080F01S-AAT Seat Cushion Height Adjustment (Driver's Seat Only) (If Installed)
To raise or lower the front part of the seat cushion, turn the front knob for- ward or rearward. To raise or lower the rear part of the seat cushion, turn therear knob forward or rearward.
HLC2028
B080E01O-AAT Lumbar Support Control
(Driver's Seat Only) (If Installed) To adjust the lumbar support, turn the handle on the outboard or left side of theseat. To increase the amount of lumbar support, pull the lever forward. To de- crease it, push the lever toward therear.
HLC2029
o Do not adjust the headrest hejght
while the vehicle is in motion.

1FEATURES OF YOUR HYUNDAI
18
!
!WARNING:
o For maximum effectiveness in case of an accident, the headrest should be adjusted so the top of the head- rest is at the same height as the
top of the occupant's ears. Theuse of a cushion that holds the body away from the seatback is not recommended.
o Do not operate vehicle with the headrests removed as severe in-jury to an occupant may occur inthe event of an accident. Head- rests may provide protection against severe neck injuries whenproperly adjusted. B110A03A-AAT Folding Rear Seatbacks (If Installed)
WARNING:
The purpose of the fold-down rear seatbacks is to allow you to carry longer objects than could otherwise be accommodated. Never allow pas-sengers to sit on top of the folded- down seatback while the car is mov- ing as this is not a proper seatingposition and no seat belts are avail- able for use when the seatbacks are folded down. This could result in B110A01A
Lock Knob
B090A01A-GAT REAR SEAT Adjustable Headrests(If Installed) Headrests are designed to help reduce the risk of neck injuries. To raise the headrest, pull it up. To lower it, push it down while pressing thelock knob. To remove the headrest, raise it as far as it can go then press the lock knob while pulling up ward. B090A01A-1

1
FEATURES OF YOUR HYUNDAI
19
serious injury or death in case of an accident or a sudden stop. Objects carried on the folded-down seatback should not extend higher than thetop of the front seats. This could allow cargo to slide forward and cause injury or damage during sud-den stops.
B110A02A
For greater convenience, the entire seat-back may be folded down or the seat-backs may be folded down individually.
!
B140A01A
B140A01S-AAT REAR SEAT WARNING For the safety of all passengers, lug- gage or other cargo should not be piled higher than the top of the seatback. In addition, do not place objects on therear shelf as they may move forward during braking or in an accident and strike vehicle passengers.
WARNING:
o When you return the rear seatback to its upright position after being folded down, be careful not to damage the seatbelt webbing or buckle. In addition, do not allow the seatbelt webbing or buckle toget caught or pinched in the rear seat.
o When you return the rear seatback to its upright position, be sure it islocked into position to attempt move it.
o Never attempt to fold or return seat while the vehicle is moving.
o Make sure that the headrests are properly fixed in place to mini- mize the risk of severs injury in case of an accident.
o To unlock the seatback, pull up the
seatback locking knob, then pushforward on the seatback panel.
o When you return the seatback to its
upright position, always be sure it haslocked into position by pulling and pushing on the top of the seatback.

1
FEATURES OF YOUR HYUNDAI
29
B230C03A-GAT Securing a Child Restraint Sys- tem with "Tether Anchorage"System(4 Door) Three child restraint hook holders are located on the rear seat package tray.
1. Open the tether anchor cover on the
rear seat package tray.
B230C01ATether Anchor Cover Child Restraint Hook Holder
3. Connect the tether strap hook to the
child restraint hook holder and tighten to secure the seat.
B230E03A-GAT Securing a Child Restraint Sys- tem with "Tether Anchorage" System(3/5 Door) Three child restraint hook holders are located on the vertical back panel. (behind rear bumper bar)
1. Route the child restraint seat strap over the seatback. For vehicles with adjustable head-rests, route the tether strap under the headrest and between the head- rest posts, otherwise route the tether strap over the top of the seatback.
2. Route the child restraint seat strap
over the seatback. For vehicles with adjustable head- rests, route the tether strap under the headrest and between the headrestposts, otherwise route the tether strap over the top of the seatback.
B230C02A-E
Front of Vehicle
Child Restraint Hook Holders
Tether Strap Hook
!WARNING:
Do not mount more than one child restraint to a single tether or to a child restraint lower anchorage point.
The improper increased load may cause the anchorage points or tether anchor to break, causing seriousinjury or death.

1CONTROLS AND EQUIPMENT
4RUNNING IN YOUR NEW HYUNDAI
B020A01FC-EAT (Petrol Engine) The longevity and performance of the vehicle are greatly affected by the careexercised during the first 1,000 miles of motoring. Because of modern manu- facturing techniques, rigid guidelinesregarding maximum road speeds have become unnecessary. However, cer- tain precautions should be observed inorder to obtain the best possible perfor- mance and useful life from the vehicle.
1) Do not race the engine without a load
(i.e revving the engine in neutral).
2) During the first 500 miles the maxi- mum engine speed should be re- stricted to 3,000 rpm and gradually increased thereafter.
3) Avoid prolonged constant speed op- eration. The internal components ofthe engine will become runin morequickly if the operation speed is var- ied during the running-in period.
4) Never allow the engine to labour. Use the gearbox freely and avoid largethrottle openings when the engine speed is below 1,500 rpm. 5) Avoid rapid acceleration and maxi-
mum throttle openings.
6) Avoid harsh braking during the first 100 miles of urban motoring or 1,000miles of motorway driving to allowthe friction facings of the brake pads and shoes to bed against the discs and drums properly.
7) No trailer towing should be under- taken during the running-in period.
B020B01FC-EAT (Diesel Engine) The longevity and performance of the vehicle are greatly affected by the care exercised during the first 1,000 miles of motoring. Because of modern manu-facturing techniques, rigid guidelines regarding maximum road speeds have become unnecessary. However, cer-tain precautions should be observed in order to obtain the best possible perfor- mance and useful life from the vehicle.AFTER ENTERING THE VEHICLE
YB020B1-E
o Ensure that all occupants fasten and
correctly adjust seat belts.
o Ensure that seat and headrestraint
positions are adjusted for optimum safety, control and comfort.
o Adjust interior and exterior rear view
mirrors.
o Verify correct operation of lamps,
horn and other electrical equipment.
o Ensure that warning lamps illumi- nate when ignition is turned on.
NOTE: Fluid levels such as engine oil, en- gine coolant, brake and windscreen washer fluid should be checked daily or at each refuelling, whichever oc-curs sooner.

1CONTROLS AND EQUIPMENT
14
!
SB070D2-E Head Restraint Adjustment To raise the head restraint, pull it up. To lower it, push it down whilst pressingthe lock knob. For maximum effective- ness in the event of an accident, the restraint must be adjusted so that therestraint is approximately at the level of the seat occupant's ears. The restraint must never be so adjusted that it iscentred about the level of the seat occupant's neck. WARNING:
o For maximum effectiveness in case of an accident, the head restraint should be adjusted so the top ofthe head restraint is at the same height as the top of the occupant's ears. The use of a cushion thatholds the body away from the seatback is not recommended.
o Do not operate the vehicle with the head restraint removed as severeinjury to an occupant may occur in the event of an accident. Headrestraint may provide protection against severe neck injuries when properly adjusted.
B080D01A
Lock knob
HLC2029-D
SB070E1-E Lumbar Support Adjustment (Driver's seat only)(Not all models) Some models are fitted with adjustable driver seat lumbar support which may be used to increase the amount oflumbar support offered by the seat back. Adjustment is performed by moving the handle at the side of the backrest in aforward direction to increase the sup- port.

1CONTROLS AND EQUIPMENT
16
!WARNING:
o For maximum effectiveness in case of an accident, the headrest should be adjusted so the top of the head- rest is at the same height as the
top of the occupant's ears. Theuse of a cushion that holds the body away from the seatback is not recommended.
o Do not operate vehicle with the headrests removed as severe in-jury to an occupant may occur inthe event of an accident. Head- rests may provide protection against severe neck injuries whenproperly adjusted. B110A03A-EAT Folding Rear Seatbacks
B110A02A
To raise the head restraint, pull it up. To lower it, push it down whilst pressingthe lock knob. For maximum effective- ness in the event of an accident, the restraint must be adjusted so that therestraint is approximately at the level of the seat occupant's ears. The restraint must never be so adjusted that it iscentred about the level of the seat occupant's neck.
!WARNING:
The purpose of the fold-down rear seatbacks is to allow you to carrylonger objects than could otherwise be accommodated. Do not allow pas- sengers to sit on top of the folded-down seatback whilst the car is mov- ing as this is not a proper seating position and no seat belts are avail-able for use when the seatbacks are folded down. This could result in serious injury or death in case of anaccident or a sudden stop. Objects
SB070D2-E REAR SEAT Head Restraint Adjustment(Not all models)
!WARNING:
Passengers sitting in the rear seat should be careful not to accidentally press the foot lever (2) whilst thevehicle is moving. As this may cause the seatback to move forward and injure a front seat occupant.