2006 HONDA RIDGELINE child restraint

µ
This section gives you important
inf ormation about how to protect
yourself and your passengers. It
shows you how to use seat belts. It
explains how your airbags work. And
it tells you how to properly restrain
inf ants and children in your vehicle.
.........
Important Safety Precautions .6
.......
Your Vehicle’s Saf ety Features .7
.......................................
Seat Belts .8
...........................................
Airbags .9
.........
Protecting Adults and Teens .11
.....
1. Close and Lock the Doors .11
...........
2. Adjust the Front Seats .11
............
3. Adjust the Seat-Backs .12
...
4. Adjust the Head Restraints .13
5. Fasten and Position the
.............................
Seat Belts .14
6. Maintain a Proper Sitting ................................
Position .16 .....
Advice f or Pregnant Women .16
...
Additional Safety Precautions .17
Additional Inf ormation About Your .................................
Seat Belts .19
..
Seat Belt System Components .19
......................
Lap/Shoulder Belt .19
Automatic Seat Belt
...............................
Tensioners .20
...............
Seat Belt Maintenance .21
Additional Inf ormation About ...........................
Your Airbags .22
......
Airbag System Components .22
How Your Front Airbags
.........................................
Work .23
...
How Your Side Airbags Work .25
How your Side Curtain Airbags
.........................................
Work .26
..
How the SRS Indicator Works .27
How the Side Airbag Of f
......................
Indicator Works .28
.............................
Airbag Service .28
...
Additional Safety Precautions .29
Protecting Children General ................................
Guidelines .30
All Children Must Be ...............................
Restrained .30 All Children Should Sit in a
.................................
Back Seat .31
The Passenger’s Front Airbag ................
Poses Serious Risks .31
If You Must Drive with Several ...................................
Children .33
If a Child Requires Close ..................................
Attention .33
...
Additional Safety Precautions .34
Protecting Inf ants and Small ...................................
Children .35
.......................
Protecting Inf ants .35
.........
Protecting Small Children .36
.....................
Selecting a Child Seat .37
....................
Installing a Child Seat .38
...............................
With LATCH .39
.........
With a Lap/Shoulder Belt .42
..............................
With a Tether .44
...........
Protecting Larger Children .47
...............
Checking Seat Belt Fit .47
..................
Using a Booster Seat .48
When Can a Larger Child Sit in
.........................................
Front .49
...
Additional Safety Precautions .50
.............
Carbon Monoxide Hazard .51
...................................
Saf ety Labels .52
Driver and Passenger Saf ety
Driver and Passenger Saf ety
5
—
—y

y
(y
y

For added protection, the f ront seat
belts are equipped with automatic
seat belt tensioners. When activated,
the tensioners immediately tighten
the belts to help hold the driver and
a f ront passenger in place.If a side curtain airbag deploys
during a side impact, the tensioner
on that side of the vehicle will also
deploy.
The tensioners can also be activated
during a collision in which the f ront
airbags . In this case, the
airbags would not be needed, but the
additional restraint could be helpf ul.
All seat belts have an emergency
locking retractor. In normal driving,
the retractor lets you move f reely in
your seat while it keeps some
tension on the belt. During a collision
or sudden stop, the retractor
automatically locks the belt to help
restrain your body.
To deactivate the locking
mechanism, unlatch the buckle and
let the seat belt f ully retract. To
ref asten the seat belt, pull it out only
as f ar as needed. If the shoulder part of the belt is
pulled all the way out, the locking
mechanism will activate. The belt
will retract, but it will not allow the
passenger to move f reely. The seat belts in all seating positions
except the driver’s have an additional
locking mechanism that must be
activated to secure a child seat (see
page ).
The tensioners are designed to
activate in any collision severe
enough to cause the f ront airbags to
deploy, or if a sensor detects your
vehicle is about to rollover (see page). When the tensioners are activated,
the seat belts will remain tight until
they are unbuckled in the normal
manner.
If the f ront seat belt tensioners ever
activate, they must be replaced as
the belts will no longer retract
properly.
26
42
do not deploy
A utomatic Seat Belt T ensioners
Additional Inf ormation About Your Seat Belts
20
—
—y

y
(yy

Your airbag system includes:Two SRS (Supplemental Restraint
System) f ront airbags. The driver’s
airbag is stored in the center of
the steering wheel; the f ront
passenger’sairbagisstoredinthe
dashboard. Both are marked ‘‘SRS
AIRBAG’’ (see page ).
Two side airbags, one f or the
driver and one f or a f ront
passenger. The airbags are stored
in the outer edges of the seat-
backs. Both are marked ‘‘SIDE
AIRBAG’’ (see page ). An indicator on the instrument
panel that alerts you to a possible
problem with your airbags,
sensors, or seat belt tensioners
(see page ).
An indicator on the instrument
panel that alerts you that the
passenger’s side airbag has been
turned of f (see page ).
Emergency backup power in case
your vehicle’s electrical system is
disconnected in a crash.
Automatic front seat belt
tensioners (see page ).
Sensors that can detect a
moderate to severe front impact,
side impact or rollover.
Height and position sensors that
can detect whether a small
person or child is in the
passenger’s side airbag path and
signal the control unit to turn
the airbag of f (see page ).
A rollover sensor that can detect if
your vehicle is about to roll over
and signal the control unit to
deploy both side curtain airbags
and f ront seat belt tensioners (see
page ).
Two side curtain airbags, one f or
each side of the vehicle. The
airbags are stored in the ceiling
above the side windows. The f ront
and rear pillars on both sides are
marked ‘‘SIDE CURTAIN
AIRBAG’’ (see page ). A sophisticated electronic system
that continually monitors and
records inf ormation about the
sensors, the control unit, the
airbag activators, the seat belt
tensioners, and driver and f ront
passenger seat belt use when the
ignition is in the ON (II) position.
27 28
23
25
26 28
20
26
A irbag System Components
Additional Inf ormation About Your Airbags
22
—
—y

y
(yy

To install a LATCH-compatible child
seat:Make sure there are no objects
near the anchors that could
prevent a secure connection
between the child seat and the
anchors.
Your vehicle is equipped with
LATCH (Lower Anchors and
Tethers f or Children) at each rear
seating position.
The lower anchors are located
between the seat-back and seat
bottom, and are to be used only with
a child seat designed f or use with
LATCH.
The location of each lower anchor is
indicated by a small button above the
anchor point.
Whenever using the center tether
anchor point, make sure to push
down the head restraint to the lowest
position, route the strap over the
seat-back, then around the upper
guide bef ore attaching the tether
strap hook to the center tether
anchor (see page ).
When using the tether strap on
the child seat, attach the tether
strap hook to the center tether
anchor bef ore installing the child
seat to the lower anchors f or the
LATCH system, because the
center tether anchor is positioned
behind the child seat.
If needed, move the seat belt
buckle or tongue away f rom the
lower anchors.
1.
2. 3.
44
CONT INUED
On the center seating position
Installing a Child Seat
Installing a Child Seat with
LATCH
Driver and Passenger Saf ety
39
BUTTON UPPERGUIDE
CENTER TETHER ANCHOR
LATCH
ANCHOR
POINTS
—
—y


y
(yy

Make sure the head restraint is in
the lowest position. Lif t the cover,
then route the tether strap around
the upper guide. Route the tether
strap downward properly, making
sure the strap is not twisted, then
attach the strap hook to the center
tether anchor.Place the child seat on the vehicle
seat, then attach the seat to the
lower anchors according to the
child seat maker’s instructions.
Some LATCH-compatible seats
have a rigid-type connector as
shown above.Other LATCH-compatible seats
have a f lexible-type connector as
shown above.
Whatever type you have, f ollow
the child seat maker’s instructions
f or adjusting or tightening the f it.
5.
4.
Installing a Child Seat
40
Flexible type
Rigid type
—
—y

y
(yy

Lif t the head restraint (see page), then route the tether strap
over the seat-back and through
the head restraint legs.
Lift the cover, then route the
tether strap around the upper
guide. Route the tether strap
downward properly, making sure
the strap is not twisted, then
attach the strap hook to the tether
anchor on the outside of the seat
bottom (see page ). Push and pull the child seat
f orward and f rom side to side to
verify that it is secure. Tighten the strap according to the
seat maker’s instructions.
6. 7.
8.
99
44
On the outer seating position
Installing a Child Seat
Driver and Passenger Saf ety
41
UPPERGUIDE
Outer Position UPPER
GUIDE
Center Position TETHER ANCHOR
TETHER ANCHOR
—
—y

y
(yy

When not using the LATCH system,
all child seats must be secured to the
vehicle with the lap part of a lap/
shoulder belt.With the child seat in the desired
seating position, route the belt
through the child seat according
to the seat maker’s instructions,
then insert the latch plate into the
buckle.To activate the lockable retractor,
slowly pull the shoulder part of the
belt all the way out until it stops,
then let the belt f eed back into the
retractor.
Af ter the belt has retracted, tug on
it. If the belt is locked, you will not
be able to pull it out. If you can pull
thebeltout,itisnotlocked,and
you will need to repeat these steps.
In addition, the lap/shoulder belts in
all seating positions except the
driver’s have a locking mechanism
that must be activated to secure a
child seat.
If you place the child seat in the rear
center seating position and use the
tether strap for additional security,
make sure to push down the head
restraint to the lowest position and
hook the tether strap hook to the
anchor bef ore securing the child seat
with the lap/shoulder belt. Refer to
page for how to route the tether
strap properly.
1. 2.
3.
44
Installing a Child Seat with a L ap/
Shoulder Belt
Installing a Child Seat
42
—
—y
y
(yy

When using the tether anchor,
always hook the tether strap through
the upper guide to route it properly.
Since a tether can provide additional
security to the lap/shoulder belt
installation, we recommend using a
tether whenever one is required or
available.
Each outer seating position has the
tether anchor at the outside of the
seat bottom. The center seating
position has the tether anchor
between the lower anchors f or the
LATCH-compatible child seat. Each
anchor point is shown above. A child seat with a tether can be
installed in any seating position in
the rear seat. Lif t the cover, then hook the
tether strap through the upper
guide as shown. Af ter properly securing the child
seat (see page ), lif t the head
restraint, then route the tether
strap over the seat-back and
through the head restraint legs.
1.
2. 42
Installing a Child Seat
Installing a Child Seat with a
TetherUsing an Out er T et her A nchor
44
COVER
UPPER
GUIDE UPPER
GUIDE
CENTER
TETHER
ANCHOR
OUTER
TETHER
ANCHOR OUTER TETHER ANCHOR
——y

y
(yy