2006 HONDA RIDGELINE turn signal

Î
Î
Î
Î
Î
Î Î
Î To use the horn, press the pad around the ‘‘H’’ logo.
Only on vehicles equipped with navigation system. Ref er to the navigation system manual. If equipped.
3:
2:
1:
Your Vehicle at a Glance
4
STEERING WHEEL
ADJUSTMENT (P.76)
INSTRUMENT PANEL
BRIGHTNESS
VTM-4 LOCK
SHIFT LEVER
SEAT HEATERS
CRUISE CONTROLS
CRUISE BUTTON
VOICE CONTROL
SWITCHES
Vehicle with navigation system is shown.
VEHICLE STABILITY
ASSIST SYSTEM
OFF SWITCH
HAZARD WARNING
BUTTON
MOONROOF SWITCH
BED LIGHT SWITCH
HEADLIGHT CONTROL
DIAL
INTERIOR LIGHT
CONTROL SWITCH
HORN
(P.105)
(P.72) (P.117)
(P.73)
(P.206)
(P.163) (P.75)
(P.193)
(P.198)
(P.159) (P.163)
(P.76) (P.115) (P.101)SELECT BUTTON
RESET BUTTON
MULTI-CONTROL LEVER
(WINDSHIELD WIPERS/
WASHERS/TURN SIGNALS/
HEADLIGHT HIGH BEAMS) (P.
67)
(P.67)
REMOTE AUDIO
CONTROLS
2
3
2
1
2
——y

y
(yy

Your airbag system includes:Two SRS (Supplemental Restraint
System) f ront airbags. The driver’s
airbag is stored in the center of
the steering wheel; the f ront
passenger’sairbagisstoredinthe
dashboard. Both are marked ‘‘SRS
AIRBAG’’ (see page ).
Two side airbags, one f or the
driver and one f or a f ront
passenger. The airbags are stored
in the outer edges of the seat-
backs. Both are marked ‘‘SIDE
AIRBAG’’ (see page ). An indicator on the instrument
panel that alerts you to a possible
problem with your airbags,
sensors, or seat belt tensioners
(see page ).
An indicator on the instrument
panel that alerts you that the
passenger’s side airbag has been
turned of f (see page ).
Emergency backup power in case
your vehicle’s electrical system is
disconnected in a crash.
Automatic front seat belt
tensioners (see page ).
Sensors that can detect a
moderate to severe front impact,
side impact or rollover.
Height and position sensors that
can detect whether a small
person or child is in the
passenger’s side airbag path and
signal the control unit to turn
the airbag of f (see page ).
A rollover sensor that can detect if
your vehicle is about to roll over
and signal the control unit to
deploy both side curtain airbags
and f ront seat belt tensioners (see
page ).
Two side curtain airbags, one f or
each side of the vehicle. The
airbags are stored in the ceiling
above the side windows. The f ront
and rear pillars on both sides are
marked ‘‘SIDE CURTAIN
AIRBAG’’ (see page ). A sophisticated electronic system
that continually monitors and
records inf ormation about the
sensors, the control unit, the
airbag activators, the seat belt
tensioners, and driver and f ront
passenger seat belt use when the
ignition is in the ON (II) position.
27 28
23
25
26 28
20
26
A irbag System Components
Additional Inf ormation About Your Airbags
22
—
—y

y
(yy

In a moderate to severe side impact,
sensors will detect rapid deceleration
and signal the control unit to
instantly inflate the side curtain
airbag on the driver’s or the
passenger’s side of the vehicle.
If the impact is on the passenger’s
side, the passenger’s side curtain
airbag will inflate even if there are no
occupants on that side of the vehicle.A rollover sensor monitors the
degree and rate your vehicle may roll
over and automatically deploy the
side curtain airbags and activate the
f ront seat belt tensioners (see page
).
In a rollover toward the f ront
passenger’s side of the vehicle, both
side curtain airbags will inf late and
the f ront seat belt tensioners will
activate even if there are no
occupants on that side of the vehicle.
To get the best protection f rom the
side curtain airbags, occupants
should wear their seat belts and sit
upright and well back in their seats.
If the side airbag of f indicator comes
on (see page ), have the
passenger sit upright. Once the
passenger is out of the airbag’s
deployment path, the system will
turn the airbag back on, and the
indicator will go out.
There will be some delay between
the moment the passenger moves
into or out of the airbag deployment
pathandwhentheindicatorcomes
on or goes of f .
A f ront seat passenger should not
use a cushion or other object as a
backrest. It may prevent the cutof f
system f rom working properly.
20
28
In a Rollover
In a Side ImpactHow Your Side Curtain A irbags
Work
Additional Inf ormation About Your Airbags
26
SIDE CURTAIN AIRBAG
—
—y

y
(y
y

When you press the hazard warning
button, both turn signal indicators
blink. All turn signals on the outside
of the vehicle should f lash.This monitor includes two f unctions;
the door open indicator and the
tailgate open indicator. This monitor
works with the ignition switch in any
position.
The specif ic door indicator comes on
in this monitor if any door is not
closed tightly.
Thetailgateindicatorcomeson
whenthetailgateisswungopenorif
it is not closed completely af ter you
swing it closed.If the tailgate is swung open or is not
closed tightly, you will hear six beeps
and see the indicator blinking when
you turn the ignition switch to the
ON (II) position. The beeper also
sounds and the indicator blinks when
you move the shif t lever out of Park
or neutral position.
The tailgate open indicator does not
monitor the tailgate when it is
dropped open.
If the driver does not f asten the seat
belt and the tailgate is swung open,
the seat belt reminder alarm will
sound at first, then the tailgate open
reminder beeper will sound.
For more inf ormation on the tailgate,
see page .
The lef t or right turn signal indicator
blinks when you signal a lane change
or turn. If an indicator does not blink
or blinks rapidly, it usually means
one of the turn signal bulbs is
burned out (see pages and ).
Replace the bulb as soon as possible,
since other drivers cannot see that
you are signaling.
91
246
247
Turn Signal and
Hazard Warning
Indicators
Door and T ailgate Open Monitor
Instrument Panel Indicators
Inst rument s and Cont rols
61
——y


y
(yy

Î
Î
Î
Î
Î
Î To use the horn, press the pad around the ‘‘H’’ logo.
If equipped.
1:
2:
Controls Near the Steering Wheel
Inst rument s and Cont rols
71
HAZARD WARNING
BUTTON
(P.76)
SHIFT LEVER
VEHICLE STABILITY
ASSIST SYSTEM
OFF SWITCH
CRUISE BUTTON
CRUISE
CONTROLS
HORN
STEERING WHEEL
ADJUSTMENT VTM-4LOCK
Vehicle with navigation system is shown. BED LIGHT SWITCH MULTI-CONTROL LEVER
(WINDSHIELD WIPERS/
WASHERS/TURN SIGNALS/
HEADLIGHT HIGH BEAMS)
MOONROOF SWITCH
SEAT HEATERS
INTERIOR LIGHT
CONTROL SWITCH
(P.105)
(P.72) (P.117)
(P.206)
(P.163)
(P.159) (P.76)(P.163)
(P.115)
INSTRUMENT PANEL
BRIGHTNESS
(P.75)
(P.193) (P.198)
(P.101)
HEADLIGHT CONTROL
DIAL
(P.73) RESET BUTTON
SELECT BUTTON (P.67)
(P.67)
REMOTE AUDIO
CONTROLS
1
2
2
2
——y


y
(yy

µ
µ
OFF
INT: Intermittent
INT TIME ring
LO: Low speed
HI: High speed
MIST
Windshield washers
Turn signal
High beams
Flashhighbeams The multi-control lever has many
f unctions, including windshield
wipers and washers, turn signals,
headlight high beams, and headlight
high beam f lashing.
To select a position, turn the rotary
switch,pushthebuttonontheendof
the lever, or push the lever up, down,
f orward, or backward.
The wipers are not activated.
The length of the wiper interval is varied
automatically according to the
vehicle’s speed.
Vary the delay by turning the
INT TIME ring. If you turn it
to the shortest delay, the
wipers change to low speed
when the vehicle speed
exceeds 12 mph (20 km/h). The wipers run at low speed.
The wipers run at high speed. The wipers run at high speed
until you release the lever.
Push the
buttonontheendof the
multi-control lever. The
washers spray until you
release the button. The
wipers run at low speed, then
complete one more sweep
after you release the button.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10. OFF:
INT :LO
HI
MIST :
Windshield Washer:
Multi-Control L ever
72
——y

y
(yy

µµ
OFF
Parking and indicator lights
Headlights
Push down on the
multi-control lever to signal a lef t
turn and up to signal a right turn. To
signal a lane change, push lightly on
the lever and hold it. The lever will
return to center when you release it
or complete a turn.
To turn on the high
beams, push the multi-control lever
f orward until you hear a click. The
blue high beam indicator will come
on (see page ). Pull the lever back
to return to the low beams.
To f lash the high beams, pull the
lever back lightly, then release it.
The high beams will stay on as long
as you hold the lever back.
Your vehicle has heating wires at the
bottom of the windshield to help
heat the wiper blades and the
windshield. If the outside
temperature is near f reezing, the
heater turns on automatically when
you turn the ignition switch to ON
(II). The heater turns of f
automatically when the outside
temperature is above f reezing.
This f unction helps to increase wiper
perf ormance when the wiper arms
sit in the parked position in snowy or
icy conditions.
1.
2.
3.
62
CONT INUED
Multi-Control L ever, Headlights
Headlight Control Dial
Turn Signal
High BeamsAutomatic Heated Wiper Zone
Inst rument s and Cont rols
73
—
—y
y
(yy

Push the lever up to lock the
steering wheel in position.
Make sure you have securely
locked the steering wheel in place
by trying to move it up and down.
Make any steering wheel adjustment
bef ore you start driving.
Pushtheredbuttontoturnonthe
hazard warning lights (f our-way
flashers). This causes all four
outside turn signals and both turn
indicators in the instrument panel to
f lash. Use the hazard warning lights
if you need to park in a dangerous
area near heavy traffic, or if your
vehicle is disabled. Move the steering wheel so it
points toward your chest, not
toward your f ace. Make sure you
can see the instrument panel
gauges and indicators. Push the lever on the lef t side of
the steering column all the way
down.3.
4.
1.
2.
Hazard Warning Button, Steering Wheel A djustment
Steering Wheel A djustment
Hazard Warning Button
76
Adjusting the steering wheel
position while driving may
cause you to lose control of the
vehicle and be seriously injured
inacrash.
Adjust the steering wheel only
when the vehicle is stopped.
—
—y
y
(y
y