2006 GREAT WALL SO COOL wheel bolt torque

[x] Cancel search: wheel bolt torque

Page 142 of 484

GREAT WALL SO COOL 2006  Service Manual SA-31
2. Mount on the inner race and roller assembly of front hub
bearing (outer).
After coating 4 to 5 mm lithium base grease on the outer race
of bearing, put in the inner race and roller assembly o

Page 143 of 484

GREAT WALL SO COOL 2006  Service Manual SA-32
(h) Bend one tooth of the lock plate inside and other teeth
outside to lock the steering knuckle nut.
5. Mount on the liner and the steering knuckle outer flange
cap.
Fastening torque(23-29)Nm

Page 145 of 484

GREAT WALL SO COOL 2006  Service Manual SA-34
7. Tear down the lower ball stud assembly from the steering
knuckle.
Inspection on and Change of Steering
Knuckle
1. Check the steering knuckle.
Check the steering knuckle with the dye penetrati

Page 146 of 484

GREAT WALL SO COOL 2006  Service Manual SA-35
(c) Mount on the upper ball stud and the groove nut that are
screwed up according to the specified torque, and then
split pin.
Fastening torque(132-152)Nm
3. Mount the stabilizer rod on the lo

Page 154 of 484

GREAT WALL SO COOL 2006  Service Manual SA-43
Mount of Upper Arm
1. Screw up the axle nut of upper arm according to the
specified torque;
Fastening torque(225)Nm
2. Mount on the upper arm;
Screw up the three bolts of the upper swing arm

Page 155 of 484

GREAT WALL SO COOL 2006  Service Manual SA-44
Front Wheel Hub and Steering Knuckle
Element Figure
Suspension System and Automobile Axle (SF/4WD)Front Wheel Hub and Steering Knuckle
lock ring
cushion block nut
lock ring
cushion
block
shock

Page 157 of 484

GREAT WALL SO COOL 2006  Service Manual SA-46
5. Tear down the front hub, the oil seal and the inner race
of front hub bearing (inner)
(a) Prize out the oil seal.
(b) Take out the inner race of front hub bearing (inner).
6. Inspection on an

Page 159 of 484

GREAT WALL SO COOL 2006  Service Manual SA-48
(e) Hold the bolt of front wheel hub with the spring-tension meter
and drag slowly in the direction of the spot tangent line.
Suitable tension range(29-54)N
The nut should be screwed up again w
Page:   < prev 1-8 9-16 17-24 25-32 33-40 next >