Special Vehicle Option Auxiliary Fuse Box - Later Installation (Right Hand Drive
Shown)
DescriptionItem
Special Vehicle Option Auxiliary Fuse Box1
Mounting Bracket2
Standard Relay Box3
Ground Point (GP15)15
See Recommended Engine Run Connection Circuit and Special Vehicle Option Auxiliary Fuse
Box
C1-C7
The Fuse Box (Ford Part number 6C1V-14517-D_)
is available as factory-fitted Special Vehicle Option
and can be retrofitted.
The Auxiliary Fuse Box must be installed using
the appropriate Ford bracket and power feed
harness. The bracket is to be fitted to the cross
car beam fixing bolts, which must be re-fastened
to the appropriate torque value. see figure
E75087
The Auxiliary Fuse Box takes power from the
customer connection points using the power
harness, which consists of two 60 amp fused
feeds.
see diagram E75088 - Recommended Engine
Run Connection Circuit and Special Vehicle
Option Auxiliary Fuse Box
Provision is made in the Auxiliary Fuse Box for the
following:
•Ten (F1-F10) fused take-off points
•One standard power relay (Normally Open),
70A
•Six standard micro relays (Change Over), 20A
Fuse ratings of 2, 3, 5, 7.5, 10, 15, 20 are available
for use at continuous loads; a fuse rating of 25
should only be used for intermittent loads.
FordTransit 2006.5 (April 2006–)
Date of Publication: 12/2006
4 Electrical
122E88173132
5.5 Seats
5.5.1 Rear Seat Fixings Positions
- Kombi
CAUTION: Do not install seats in the
rear cargo area of a Van.
the following figure shows the second and third
row seat fixing in the floor. These holes and
positions are independent of the wheelbase.
Refer to: 5.6 Glass, Frames and Mechanisms
(page 211).
Rear Floor Seat Fixing Positions
DescriptionItem
Front Axle Center Line1
Floor Height Step on Front wheel Drive Vehicles2
Second Row Seat3
Third Row Seat4
Rear Floor Seat Fixing Position Dimensions (mm)
GFEDCBA
7521048434131284913721787
Cab Van Floor
NOTE: Cab Van Floor Models are currently only
available for use in Motor Caravan applications
Rear seats, if assembled at a Vehicle Converter
/ Modifier, need to be tested according to ECE
R14, 77/541/EEC and ECE R17 by them. It is
recommended to fix the seat frame at three
locations as shown in the following Figure
E74532 which shows the typical design principle
for Cab Van Floor seat frame fixings on top and
underneath the floor. Fixings should be carried
out as U-type bracket clinching the cross beam.
FordTransit 2006.5 (April 2006–)
Date of Publication: 12/2006
5 Body and Paint
2091E74531234ABCDFGE
