169VEHICLE MAINTENANCE
Do not add oil with dif-
ferent specifications from
the oil already in the en-
gine.
ENGINE OIL
Fig. 5:2.0 versions
Fig. 6:2.0 JTD versions
Fig. 7:2.3 JTD versions
Fig. 8: 2.8 JTD - 2.8 JTD POWER
versions
Check engine oil with the vehicle on
level ground and while the engine is
still warm (approximately 10 minutes
after stopping the engine). The oil
level should be included between the
MINand MAXreference lines on
the dipstick.
The gap between MINand MAX
reference lines corresponds to ap-
proximately 2 litres oil.
The oil level must never exceed the
MAXline.If the oil level is near or even below
the MINline, pour in oil through the
filler hole until it reaches the MAX
line.
fig. 5
F0D0063m
fig. 6
F0D0064m
fig. 7
F0D0211m
fig. 8
F0D0183m
Be very careful under the
bonnet: you risk burning
yourself. Remember that when the
engine is hot, the fan can start up
and cause injuries.
WARNINGIMPORTANT After topping up or
changing the oil, let the engine turn
for a few seconds and wait a few min-
utes after stopping it before you check
the level.
170VEHICLE MAINTENANCE
Engine oil consumption
Maximum engine oil consumption is
approx. 450 grams every 1000 Km.
During the beginning of the vehicle’s
life the engine is tuning in. Engine oil
consumption can only be considered
stabilised after the first 5,000 - 6,000
km.
IMPORTANTEngine oil consump-
tion depends on the conditions the ve-
hicle is being used in.ENGINE COOLANT
Check coolant level when the engine
is cold. The level should be included
between the MIN and MAXrefer-
ence lines on the reservoir.
If the level is low, loosen the expan-
sion tank cap A-fig. 9and top up
slowly through the filler with the flu-
id specified in “Fluids and lubricants”
table in section “Technical Specifica-tions”, until the level approaches the
MAX line; contact Fiat Dealership
for this operation.
Coolant mixture gives freeze pro-
tection to – 40°C.
Used engine oil and re-
placed oil filters contain
substances which can
harm the environment. We rec-
ommend you have the vehicle
seen at a Fiat Dealership for the
oil and filter change. It is suitably
equipped for disposing of used oil
and filters in an environmentally-
friendly way that complies with
the law.
fig. 9
F0D0065m
The cooling system is pres-
surised. If necessary, re-
place the cap with a genuine spare
part to avoid compromising the sys-
tem efficiency.
WARNING
Do not remove the reservoir
cap when the engine is hot:
you risk scalding yourself.
WARNING
Top up only with the
same fluid contained in
the cooling circuit.
PARAFLU UP (red) cannot be
mixed with PARAFLU 11 (blue)
or with other fluids. Should this
take place, donot start the engine
and contact Fiat Dealership.
171VEHICLE MAINTENANCE
WINDSCREEN WASHER
FLUID
To add fluid, remove cap A-fig. 10
from the reservoir and slowly pour in
a mixture of water and TUTELA
PROFESSIONAL SC35fluid in the
following concentrations:
– 30% ofTUTELA PROFES-
SIONAL SC35and 70% of water in
summer.
– 50% ofTUTELA PROFES-
SIONAL SC35and 50% of water in
winter.
If the temperature falls below –20°C,
useTUTELA PROFESSIONAL
SC35undiluted.
POWER STEERING
FLUID
Check the oil level when the engine
is cold. It should be slightly under the
reference line on the reservoir.
When the oil is hot, the level can ex-
ceed the reference line.
When topping up, remove the reser-
voir cap A-fig. 11 and make sure that
the oil has the same specifications as
the oil in the system.Oil consumption is ex-
tremely low. If the oil
level needs topping up
again after a short period of
time, have the system checked
for leakage at a Fiat Dealership.
fig. 10
F0D0068m
fig. 11
F0D0066m
Do not let the power steer-
ing fluid come into contact
with hot engine parts. It catches fire
very easily.
WARNINGSome windscreen washer
additives on the market are
flammable. The engine compart-
ment contains hot parts which
could ignite the fluid in the event of
contact.
WARNING
Do not travel with the wind-
screen washer reservoir
empty. The windscreen washer is
fundamental for improving visibility.
WARNING
241TECHNICAL SPECIFICATIONS
FLUIDS AND LUBRICANTS
PRODUCTS WHICH MAY BE USED AND THEIR SPECIFICATIONS
Use
Lubricants
for petrol
engines (❐)
Lubricants
for diesel
engines
(❐) For particularly cold temperatures use SELENIA PERFORMER MULTIPOWER SAE 5W-30Applications
F0D0146m
Fluid and lubricant specifications
for correct vehicle operations
Synthetic-based oil, grade SAE 10W-40 that passes
ACEA A3, API SL specifications
Synthetic-based oil, grade SAE 5W-30 that passes
ACEA A1, ACEA A5, API SL and FIAT 9.55535
specifications.
Synthetic-based oil, grade SAE 5W-40 that passes ACEA B4,
API CF and FIAT 9.55535 specificationsRecommended
fluids and lubricants
SELENIA 20K
SELENIA
PERFORMER
MULTIPOWER
SELENIA WR
242TECHNICAL SPECIFICATIONS
Use
Lubricants and grease
for transmission
Products for brakes
Radiatorantifreeze
Diesel fuel
additive
Windscreen/
rear window/
headlight washer fluid
(*) IMPORTANTThese two fluids cannot be mixed with each other. Contact Fiat Dealership for topping up.
Recommended
fluids and lubricants
TUTELA CAR
MATRYX
TUTELA GI/A
TUTELA HP 20
TUTELA
W 90/M-DA
TUTELA TOP 4
PARAFLU 11 (*)
or
PARAFLU UP (*)
DIESEL MIX
TUTELA
PROFESSIONAL
SC 35 Fluid and lubricant specifications
for correct vehicle operation
Fully synthetic lubricant SAE 75W-85 meeting API GL-4,
FIAT 9.55550
Lubricant for transmissions with ATF DEXRON II D LEV
properties
ATF DEXRON III oil type
Lubricant, grade SAE 80W-90 that passes API GL5, MIL-L-
2105 D, IVECO 18-1804, FIAT 9.55550 and FIAT 9.55523
specifications
Synthetic fluid, FMVSS n° 116 DOT 4, ISO 4925,
SAE J-1704, CUNA NC 956 - 01
Protective with antifreeze action based on
inhibited monoethylen glycol, CUNA NC 956-16
Protective with antifreeze action (red colour) based on inhib-
ited monoethylen glycol, with O.A.T. formulation, that passes
CUNA NC 956-16, ASTM D 3306 specifications.
Diesel fuel additive providing diesel engine protection
Mixture of alcohol and surfactants CUNA NC 956 -IIApplications
Mechanical
transaxles developping
high temperatures
Power steering system
Automatic gearbox
EP oil for standard and
self-locking differentials
Hydraulic brake and
clutch controls
Cooling circuits.
Proportion: 50% down
to -35° C Not to be
mixed with products
having different
formulas.
To be mixed with
diesel fuel
(25 cc every 10 litres)
To be used pure
or diluted
247INDEX
I I
N N
D D
E E
X X
Bodywork ..................................... 181
- maintenance ............................ 181
- tips for keeping the body
in good conditions ................. 182
- versions .................................... 187
- warranty ................................... 182
Bodywork paint identification
plate ............................................. 186
Bodywork versions ..................... 187
Bonnet ........................................... 84
Bottle holder ................................ 74
Brake fluid level ........................... 172
Brake light replacement ............. 146
Brakes
- handbrake ......................... 108-216
- service and
emergency brake ................... 216
Bulb replacement ........................ 141
Bulb types ..................................... 142
Bump starting ............................... 137Capacities ................................... 239
Ceiling light .................................... 71
Cellular phone set-up ................ 100
Central door locking system .... 83
Changing a wheel ........................ 137
Cheap running that respects
the environment ....................... 127
Checking fluid levels ................... 167
Child restraint systems .............. 22
Cigar lighter ................................. 77
Cleaning seats and fabrics ......... 184
Cleaning the plastic parts .......... 184
Climate control system ............. 57
Clutch ............................................ 216
Controls ........................................ 71
Consumption
- engine oil .................................. 170
- fuel ............................................. 243
Coolant temperature gauge ..... 30ABS .............................................. 88
Additional heater ........................ 58
Adjusting the headlight beam ... 86
Airbags (front and side) ............. 90
Air cleaner .................................... 173
Air vents ........................................ 54
Annual inspection schedule ...... 165
Ashtray .......................................... 77
ASR system ................................... 96
At the filling station .................... 102
Automatic electronic gearbox .. 110
Battery ........................................ 174
- battery cut out ....................... 73
- checking the charge ............... 175
- jump starting .................... 136-157
- recharging ................................ 157
- replacement ............................ 174
- useful advice ............................ 175
248INDEX
Cruise Control ............................ 68
Current socket ............................ 76
Dashboard ................................. 5
Demisting ...................................... 56
Diesel fuel filter ........................... 173
Differential .................................... 216
Digital clock .................................. 32
Dimensions ........................... 222-224
Dipped beam headlights ............ 65
- bulb replacement ................... 143
Direction indicators ................... 66
- front bulb replacement ......... 145
- rear bulb replacement .......... 146
- side bulb replacement ........... 145
Doors ............................................ 79
- 270° opening ........................... 82
- central door locking .............. 83
- driver’s cab doors .................. 79
- rear door ................................. 81
- remote control ....................... 9- side sliding door ..................... 80
- window regulators ................ 83
Driving style affecting fuel
consumption .............................. 124
Electric windows ....................... 83
Electronic alarm .......................... 11
Electronic automatic gearbox .. 110
Electronic control units ............. 177
- speed limiter ........................... 177
Emergency starting .............. 107-135
Emission control devices ........... 128
Engine ............................................ 214
- starting diesel engines ........... 106
- starting petrol engines .......... 105
- stopping the engine ............... 108
- supply/ignition ......................... 215
- warming up the engine ......... 107
Engine/bodywork codes ............ 187
Engine compartment .................. 183
Engine coolant gauge .................. 30
Engine coolant level .................... 170Engine marking ............................ 185
Engine oil ....................................... 169
- consumption ........................... 170
Engine oil level ............................. 169
Engine oil level gauge ................. 32
EOBD system .............................. 95
Fiat Code (system) ................... 7
First aid kit .................................... 161
Flashing the headlights ............... 66
Fluids and lubricants ................... 241
Front/rear ceiling light
replacement ............................... 148
Front fog light replacement ...... 145
Fuel cut-off switch ...................... 72
Fuel gauge ..................................... 31
Fuses (replacement) ................... 149
Getting to know
your vehicle............................ 5
Getting the best out of
your vehicle............................ 105
The engine of your car is factory filled with Selenia,
a range of lubricants which satisfies the most advanced
international specifications. Specific tests and high technical
characteristicss allow the Seleniarange to guarantee
theoptimumandtop quality performanceof your engine.
SELENIA 20K
API SL lubricant ,which guarantees optimum
performance and maximum wear protection to
aspirated, turbocharged or multivalve petrol engines.
SELENIA PERFORMER
Is particularly ideal for the protection of new
generation petrol engines,
Very effective even in the most severe weather
conditions. It guaranteees a reduction in fuel
consumption (Energy conserving ). SELENIA TD
Oil for aspirated turbocharged or multivalve diesel
engines, guarantees maximum engine cleanliness
and stability at high temperatures.
SELENIA WR
Oil which has been specifically designed for use in
common rail andMultijet diesel engines. Effective dur-
ing cold starts it offers maximim wear protection,
hydraulic tappets control, consumption reduction
and stability at high temperatures.
Oil change? The experts reccomend Selenia.
The Selenia range includes a number of of technologically advanced products:
For further information on Selenia products, please visit the website www.flselenia.com. The complete Selenia range also includes Selenia 20K Alfa Romeo, Selenia Performer 5W-40, Selenia Racing and Selenia Digitech.