2006 DODGE GRAND CARAVAN jump start

Extremely Cold Weather (below
29 ° Cor
20 ° F). To
insure reliable starting at these temperatures, use of an
externally powered electric engine block heater (available
from your dealer) is recommended.
WARNING!Do not attempt to push or tow your vehicle to get it
started. Vehicles equipped with an automatic trans-
mission cannot be started this way. Unburned fuel
could enter the catalytic converter and once the
engine has started, ignite and damage the converter
and vehicle. If the vehicle has a discharged battery,
booster cables may be used to obtain a start from a
booster battery or the battery in another vehicle. This
type of start can be dangerous if done improperly.
See section 6 of this manual for the proper jump
starting procedures and follow them carefully. WARNING!Never pour fuel or other flammable liquid into the
throttle body air inlet opening in an attempt to start
the vehicle. This could result in flash fire causing
serious personal injury.
If Engine Fails to Start
If the engine fails to start after you have followed the
“ NORMAL STARTING ” , “ COLD WEATHER ” or “ HIGH
ALTITUDE ” procedures, it may be flooded. Push the
accelerator pedal all the way to the floor and hold it there
while cranking the engine. This should clear any excess
fuel in case the engine is flooded. STARTING AND OPERATING 305
5

WARNING!Do not attempt to push or tow your vehicle to get it
started. Vehicles equipped with an automatic trans-
mission cannot be started this way. Unburned fuel
could enter the catalytic converter and once the
engine has started, ignite and damage the converter
and vehicle. If the vehicle has a discharged battery,
booster cables may be used to obtain a start from a
booster battery or the battery in another vehicle. This
type of start can be dangerous if done improperly.
See section 6 of this manual for the proper jump
starting procedures and follow them carefully. WARNING!Never pour fuel or other flammable liquid into the
throttle body air inlet opening in an attempt to start
the vehicle. This could result in flash fire causing
serious personal injury.
If Engine Fails to Start
If the engine fails to start after you have followed the
“ NORMAL STARTING ” procedure, it may be flooded.
Push the accelerator pedal all the way to the floor and
hold it there while cranking the engine. This should clear
any excess fuel in case the engine is flooded. STARTING AND OPERATING 307
5

WHAT TO DO IN EMERGENCIESCONTENTS
Hazard Warning Flasher ..................366

If Your Engine Overheats .................367

Jacking And Tire Changing ................368
▫ Jacking Instructions — Stow ’ n Go Seating . . . 369
▫ Jacking Instructions — Non Stow ’ nGo
Seating .............................381

Jump-Starting Procedures If Battery Is Low ....387

Driving On Slippery Surfaces ..............389
▫ Acceleration .........................389 ▫ Traction ............................389

Freeing A Stuck Vehicle ..................390

Towing A Disabled Vehicle ................391
▫ With Ignition Key .....................391
▫ Without The Ignition Key ...............392
▫ Towing This Vehicle Behind Another Vehicle
(Flat Towing With All Four Wheels On The
Ground) ............................392
▫ Towing This Vehicle Behind Another Vehicle
With A Tow Dolly .....................392
6

• For convenience in checking the spare tire inflation,
stow with the valve stem toward the rear of the
vehicle.
• Using the jack handle, rotate the drive nut to the
right until the wheel is drawn into place against the
underside of the vehicle.
• Continue to rotate the nut until you hear the mecha-
nism click three times. It cannot be overtightened.
Push against the tire several times to be sure it is
securely in place.
13. Stow the jack and jack handle.
14. Check the tire pressure as soon as possible. Correct
pressure as required. JUMP-STARTING PROCEDURES IF BATTERY IS
LOW
WARNING!Take care to avoid the radiator cooling fan whenever
the hood is raised. It can start anytime the ignition
switch is on. You can be hurt by the fan. WHAT TO DO IN EMERGENCIES 387
6

WARNING!• Do not attempt to push or tow your vehicle to get it
started. Vehicles equipped with an automatic transmis-
sion cannot be started this way. Unburned fuel could
enter the catalytic converter and once the engine has
started, ignite and damage the converter and vehicle. If
the vehicle has a discharged battery, booster cables may
be used to obtain a start from another vehicle. This type
of start can be dangerous if done improperly, so follow
this procedure carefully.
• Battery fluid is a corrosive acid solution; do not allow
battery fluid to contact eyes, skin or clothing. Don ’ t lean
over battery when attaching clamps or allow the clamps
to touch each other. If acid splashes in eyes or on skin,
flush contaminated area immediately with large quan-
tities of water.
• A battery generates hydrogen gas which is flammable
and explosive. Keep flame or spark away from the vent
holes. Do not use a booster battery or any other booster
source with an output that exceeds 12 volts. 1. Wear eye protection and remove any metal jewelry
such as watch bands or bracelets that might make an
inadvertent electrical contact.
2. When boost is provided by a battery in another
vehicle, park that vehicle within booster cable reach and
without letting the vehicles touch. Set the parking brake,
place the automatic transmission in PARK and turn the
ignition switch to the OFF position for both vehicles.
3. Turn off the heater, radio and all unnecessary electrical
loads.
4. Connect one end of a jumper cable to the positive
terminal of the discharged battery. Connect the other end
of the same cable to the positive terminal of the booster
battery.388 WHAT TO DO IN EMERGENCIES

5. Connect the other cable, first to the negative terminal
of the booster battery and then to the engine of the
vehicle with the discharged battery. Make sure you have
a good contact on the engine.
6. Start the engine in the vehicle which has the booster
battery, let the engine idle a few minutes, then start the
engine in the vehicle with the discharged battery.
7. When removing the jumper cables, reverse the above
sequence exactly. Be careful of the moving belts and fan.
DRIVING ON SLIPPERY SURFACES
Acceleration
Rapid acceleration on snow covered, wet, or other slip-
pery surfaces may cause the front wheels to pull errati-
cally to the right or left. This phenomenon occurs when
there is a difference in the surface traction under the front
(driving) wheels. WARNING!Rapid acceleration on slippery surfaces is danger-
ous. Unequal traction can cause sudden pulling of
the front wheels. You could lose control of the
vehicle and possibly have an accident. Accelerate
slowly and carefully whenever there is likely to be
poor traction (ice, snow, wet mud, loose sand, etc.).
Traction
When driving on wet or slushy roads, it is possible for a
wedge of water to build up between the tire and road
surface. This is known as hydroplaning and may cause
partial or complete loss of vehicle control and stopping
ability. To reduce this possibility, the following precau-
tions should be observed:
1. Slow down during rainstorms or when roads are
slushy. WHAT TO DO IN EMERGENCIES 389
6

Interlock System ....................... 310
Reset Mode .......................... 311
Selection Of Lubricant ................ 425,445
Shifting ............................. 311
Special Additives ...................... 427
Automatic Transmission ................... 424
Adding Fluid ......................... 426
Fluid and Filter Changes ................. 427
Fluid Change ......................... 427
Fluid Level Check ...................... 426
Fluid Type ........................ 425,445
Ball Joints ............................. 412
Battery ............................... 409
Gas Caution .......................... 409
Jump Starting ......................... 387
Keyless Transmitter Replacement (RKE) ....... 25
Saving Feature (Protection) ............... 145
Bearings .............................. 428 Belts, Drive ............................ 405
Body Mechanism Lubrication ............... 413
B-Pillar Location ........................ 324
Brake Fluid ............................ 445
Brake, Parking .......................... 313
Brake System ........................ 314,421
Anti-Lock (ABS) ....................... 315
Fluid Check .......................... 423
Hoses .............................. 422
Warning Light ........................ 205
Brakes ............................. 314,421
Brake/Transmission Interlock ............... 310
Break-In Recommendations, New Vehicle ........ 82
Bulb Replacement ....................... 438
Bulbs, Light ............................ 437
Calibration, Compass ..................... 159
Capacities, Fluid ........................ 443 INDEX 483
10

Door Locks ............................. 17
Door Locks, Automatic .................... 19
Door Opener, Garage ..................... 167
Drive Belts ............................ 405
Drive Shaft Universal Joints ................ 413
Driving
On Slippery Surfaces .................... 389
Electric Remote Mirrors .................... 92
Electrical Power Outlets ................... 175
Electronic Speed Control (Cruise Control) ...... 155
Electronic Vehicle Information Center (EVIC) .... 163
Emergency, In Case of
Hazard Warning Flasher ................. 366
Jacking ........................ 368,369,381
Jump Starting ......................... 387
Overheating .......................... 367
Emission Control System Maintenance ...... 399,448
Engine ............................ 396,397 Air Cleaner .......................... 407
Air Cleaner Filter ...................... 406
Block Heater ......................... 309
Break-In Recommendations ................ 82
Checking Oil Level ..................... 401
Compartment ...................... 396,397
Coolant (Antifreeze) .................... 444
Cooling ............................. 416
Exhaust Gas Caution .................. 37,345
Fails to Start ....................... 305,307
Fuel Requirements .................. 342,443
Oil ........................... 401,443,444
Oil Change Interval .................... 403
Oil Disposal .......................... 405
Oil Filler Cap ......................... 404
Oil Filter Disposal ...................... 405
Oil Selection ....................... 403,443
Oil Synthetic ......................... 405
Overheating .......................... 367486 INDEX