2006 CHEVROLET SILVERADO automatic transmission

[x] Cancel search: automatic transmission

Page 482 of 594

CHEVROLET SILVERADO 2006 1.G Owners Manual Tire Terminology and De�nitions
Air Pressure:The amount of air inside the tire pressing
outward on each square inch of the tire. Air pressure
is expressed in pounds per square inch (psi) or
kilopascal

Page 498 of 594

CHEVROLET SILVERADO 2006 1.G Owners Manual Changing a Flat Tire
If a tire goes �at, avoid further tire and wheel damage by
driving slowly to a level place. Turn on your hazard
warning �ashers. SeeHazard Warning Flashers on
page 3-6for more inf

Page 536 of 594

CHEVROLET SILVERADO 2006 1.G Owners Manual Fuses Usage
SEO B2 Off-Road Lamps
4WS Not Used
AUX PWRAuxiliary Power
Outlet — Console
PCM 1 Powertrain Control Module
ETC/ECMElectronic Throttle Control,
Electronic Brake
Controller-Gasoline Engine

Page 540 of 594

CHEVROLET SILVERADO 2006 1.G Owners Manual Engine Speci�cations
Engine VIN Code Transmission Spark Plug Gap
VORTEC™ 4.3L V6 XAutomatic
Manual0.060 inches (1.52 mm)
VORTEC™ 4.8L V8 VAutomatic
Manual0.040 inches (1.01 mm)
VORTEC™ 5.3L V8 Z

Page 547 of 594

CHEVROLET SILVERADO 2006 1.G Owners Manual Additional Required Services (Gasoline Engine)
This maintenance section applies to vehicles with a gasoline engine. If your vehicle has a diesel engine, see the
maintenance schedule section in the DUR

Page 548 of 594

CHEVROLET SILVERADO 2006 1.G Owners Manual Additional Required Services (cont’d)
Service and Miles (Kilometers)25,000
(40 000)50,000
(80 000)75,000
(120 000)100,000
(160 000)125,000
(200 000)150,000
(240 000)
Except Allison Transmission
®:

Page 550 of 594

CHEVROLET SILVERADO 2006 1.G Owners Manual (e)Make sure the safety belt reminder light and all your
belts, buckles, latch plates, retractors, and anchorages
are working properly. Look for any other loose or
damaged safety belt system parts. If

Page 551 of 594

CHEVROLET SILVERADO 2006 1.G Owners Manual (k)Inspect system. Check all fuel and vapor lines and
hoses for proper hook-up, routing, and condition. Check
that the purge valve works properly, if equipped.
Replace as needed.
(l)Change clutch �uid