2006 Acura TL display

Vents, Heating, and A/C
Features
121
OFF BUTTONWINDSHIELD
DEFROST BUTTON
REAR WINDOW
DEFOGGER BUTTON
FAN CONTROL
BUTTONS
DRIVER’S SIDE
TEMPERATURE
CONTROL BUTTONS
Vehicles with Navigation System
PASSENGER’S SIDE
TEMPERATURE
CONTROL BUTTONS
DUAL BUTTON RECIRCULATION BUTTON AIR CONDITIONING
BUTTON PASSENGER’S SIDE
MODE CONTROL BUTTON
DRIVER’S SIDE MODE
CONTROL BUTTON PASSENGER’S AUTO BUTTON
DRIVER’S AUTO BUTTON TEMPERATURE DISPLAY

Û
Ý
Û
Ý
The climate control system f or your
vehicle can also be operated using
the voice control system. See
NavigationsectioninyourQuick
Start Guide f or an overview of this
system and the Navigation System
manual f or complete details.
When the indicator in the button is
on, air f rom the vehicle’s interior is
recirculated throughout the system.
When the indicator is off, air is
brought in f rom the outside of the
vehicle (fresh air mode).
The outside air intakes f or the
heating and cooling system are at
the base of the windshield. Keep this
area clear of leaves and other debris.
Thesystemshouldbeleftinfresh
air mode under almost all conditions.
Keeping the system in recirculation
mode, particularly with the A/C of f ,
can cause the windows to fog up.
Switch to recirculation mode when
driving through dusty or smoky
conditions, then return to fresh air
mode.
This button turns the rear window
def ogger of f and on (see page ).
The driver’s side temperature and
passenger’s side temperature can be
set separately. Press either side’s
button to increase the temperature
of airf low. Press either side’s
button to decrease it. When you set
the temperature to its lower limit or
its upper limit, it will be displayed as
‘‘Lo’’ or ‘‘Hi’’.
This button turns the air
conditioning on and of f . The A/C
ON indicator comes on in the display
when the A/C is on.
Press the button to increase
the fan speed and airflow. Press the
button to decrease them.
87
Only on models equipped withNavigation System
Airflow Buttons
Voice Control System Recirculation Button
Rear Window Def ogger Button
Temperature Control Buttons
Air Conditioning (A/C) Button
Fan Control Buttons
122

When the AUTO button on the
driver’s side is pressed, the
temperature control buttons on the
passenger’s side are disabled, and
the interior temperature is regulated
to the temperature set on the driver’s
side.WhentheAUTObuttononthe
passenger’s side is pressed,
temperature can be set on the driver’s
side and passenger’s side separately.
The system automatically selects the
proper mix of conditioned and/or
heated air that will, as quickly as
possible, raise or lower the interior
temperature to your pref erence.
When you set the temperature to its
lower or its upper limit, the system
runs at f ull cooling or heating only. It
does not regulate the interior
temperature.
The automatic climate control
system adjusts the f an speed and
airflow levels to maintain the interior
temperature you select.
In the AUTO mode, the vehicle’s
interior temperature is
independently regulated f or the
driver and passenger. If the driver’s
side of the vehicle is getting too
much sun, the system will adjust to a
lower temperature.
Select . The system
automatically switches to f resh air
mode and turns on the A/C. (The
A/C indicator will not come on in
U.S. vehicles, if the A/C was of f to
start with.)
Select .
Set the f an and temperature
controls to maximum level.
Press the AUTO button.
Set the desired temperature with
the temperature control buttons.
You will see AUTO in the system’s
display.
To clear the windshield f aster, you
can close the dashboard corner vents
by rotating the wheel below each
vent. This sends more warm air to
the windshield def roster vents. Once
the windshield is clear, select f resh
air mode to avoid fogging the
windows.
For your saf ety, make sure you have
a clear view through all the windows
bef ore driving. 1.
2.
1.
2.
3.
On models with Navigation System
Climat e Cont rol
T o Cool or Heat A utomatically
Using A utomatic Climate Control
T o Remove Exterior Frost or Ice
From the Windows
Features
125

ÛTheclimatecontrolsystemhastwo
sensors. A sunlight sensor is in the
top of the dashboard, and a
temperature sensor is next to the
steering column. Do not cover the
sensors or spill any liquid on them.
When you press a f an control button,
the fan is taken out of AUTO mode
and starts to run at its lowest speed.
Press the button to make
the fan run faster.
You can manually select various
f unctions of the climate control
system when it is in f ully automatic
mode. All other f eatures remain
automatically controlled. Making any
manual selection causes the word
AUTO in the display to go out.
Press the OFF button. However, a
lack of airf low can cause the
windowstofogup.Youshouldkeep
the fan on at all times so stale air and
moisture do not build up in the
interior and cause f ogging.
Climat e Cont rol
Sunlight and T emperature
Sensors
Semi-automatic Operation
To Turn Everything Off
126
SUNLIGHT SENSOR TEMPERATURE SENSOR

µ´µ
µ
µ The SEEK f unction
searches up and down from the
current f requency to f ind a station
with a strong signal. To activate it,
press the or SEEK button, then
release it.
The SCAN function
samples all stations with strong
signals on the selected band. To
activate it, press the SCAN button, or
touch the SCAN icon (models with
navigation system), then release it.
You will see SCAN in the display.
The system will scan f or a station
with a strong signal. When it f inds
one, it will stop and play that station
f or about 5 seconds.
If you do nothing, the system will
scan f or the next strong station and
play it f or 5 seconds. When it plays a
station you want to listen to, press
the SCAN button again.
The band and f requency that the
radio was last tuned to is displayed.
To change bands, press the AM/FM
button (AM or FM button on
Canadian model). On the FM band,
ST will be displayed if the station is
broadcasting in stereo. Stereo
reproduction on AM is not available.
You can use any of f ive methods to
f ind radio stations on the selected
band:
the
preset buttons, and .
Use the TUNE knob to
tune the radio to a desired f requency.
Turn the knob right to tune to a
higher f requency, or lef t to tune to a
lower f requency.
The ignition switch must be in the
ACCESSORY (I) or ON (II) position.
Turn the system on by pushing the
VOL/PWR knob or the AM/FM
button (AM or FM button on
Canadian model). Adjust the volume
by turning the same knob. The audio system f or your vehicle
can also be operated using the voice
control system. See Navigation
section in your Quick Start Guide f or
an overview of this system and the
Navigation System manual f or
complete details.
Only on models equipped with
Navigation System
Playing the AM/FM Radio
SEEK
SCAN
To Select a Station
TUNE,SEEK,SCAN, AUTO SELECT
TUNE
To Play the AM/FM Radio Voice Control System
128

µµEach of the six preset
buttons or preset icons (on models
with navigation system) can store
one f requency on AM (LW, MW)
and two f requencies on FM.
Usethetune,seek,orscan
function to tune the radio to a
desired station.
Repeat steps 1 through 3 to store a
total of six stations on AM and
twelve stations on FM. If you are
traveling far from home and can no
longer receive your preset stations,
you can use the auto select feature to
find stations in the local area.
Press the A. SEL button or the
AUTO SELECT icon (models with
navigation system). ‘‘A.SEL’’ (AUTO
SEL) f lashes in the display, and the
system goes into scan mode f or
several seconds. It stores the
f requencies of six AM, and twelve
FM stations in the preset buttons. press the
A.SEL button (AUTO SELECT icon).
This restores the presets you
originally set.
Select the desired band, AM or
FM. FM1 and FM2 let you store
two f requencies with each preset
button (icon).
Pick a preset button (icon), and
hold it until you hear a beep.
You will see a ‘‘0’’ displayed or see no
station number on the preset icons
af ter pressing a preset button (icon)
if auto select cannot f ind a strong
station f or every preset button. If you do not like the stations auto
select has stored, you can store
other f requencies on the preset
buttons (icons). Use the TUNE,
SEEK, or SCAN f unctions to f ind
stations, then store them in the
preset buttons (icons) as previously
described.
1.
2.
3.
4.
To turn of f Auto Select,
CONT INUED
Preset A UT O SEL ECT
Playing the AM/FM Radio
Features
129

µµ µ
On models without Navigation System
Eachmodeisshowninthedisplayas
it changes. Turn the TUNE/SOUND
knob to adjust the setting to your
liking. When the level reaches the
center, you will see ‘‘C’’ in the display.
The system will automatically return
the display to the selected audio
mode about 5 seconds af ter you stop
adjusting a mode.
Use the TREB/
BASS modes to adjust the tone to
your liking.
These two
modes adjust the strength of the
sound coming f rom each speaker.
BAL adjust the side-to-side strength,
and FADE adjusts the f ront-to-back
strength. These two
modes adjust the strength of the
sound coming f rom the center
speaker and the subwoof er speaker.
If you turn the TUNE/SOUND knob
all the way to the lef t, you will see
‘‘OFF’’inthedisplay,andthecenter
speaker and/or subwoof er speaker
will be of f .
Bass, treble, balance, and fader are
each adjustable. In addition, you can
adjust the strength of the sound
coming from the center and the
subwoof er speakers.
Press the TUNE/SOUND knob
repeatedly to display the bass
(BASS), treble (TREB), balance
(BAL), f ader (FADE), center
(CNTR) and subwoofer (SUBW)
setting. Adjusting the Sound
Treble/Bass
Balance/FaderCenter/Subwoof er
Playing the AM/FM Radio
130
ADJUSTMENT LEVEL

µ
µ
µ
On models with Navigation System
To adjust them, enter the sound grid
by touching the SOUND icon on the
display or pressing the TUNE/
SOUND knob.
To see the audio screen when you
are f inished adjusting the sound,
touch the RETURN icon, or wait 5
seconds.
Bass, treble, lef t/right balance, and
front/rear fader are each adjustable.
In addition, you can adjust the
strength of the sound coming f rom
the center and the subwoofer
speakers.
These modes adjust
the strength of the sound coming
f rom each speaker. Lef t/right
balance adjust the side-to-side
strength, while f ront/rear f ader
adjust the f ront-to-back strength. To
adjust the left/right balance, touch
the lef t or right icon on the sound grid. When you touch an icon, the
yellow bars on the grid turn orange
and move toward the icon, changing
the balance left or right. At this point,
you can also use the TUNE/SOUND
knob to adjust the balance. To
equalize the balance, touch the lef t
or right icon until each side has an
orange bar at the center of the sound
grid.
To adjust the front/rear fader, touch
the f ront or rear icon on the sound
grid. When you touch an icon, the
yellow bars on the grid turn orange
and move toward the icon, changing
the fader to the front or rear. At this
point, you can also use the TUNE/
SOUND knob to adjust the balance.
To equalize the f ader, touch the
f ront or rear icon until each side has
an orange bar at the center of the
sound grid.
To adjust the treble
and bass, touch or on each
side of the treble or bass adjustment
bar. Then continue pressing or , or turn the TUNE/SOUND
knob. The adjustment bar shows you
the current setting.
To adjust the
sound f rom the subwoof er or center
speaker, touch or icon on
each side of the subwoof er or center
adjustment bar. Then continue
pressing or , or turn the TUNE/SOUND knob. The
adjustment bar shows you the
current setting.
Playing the AM/FM Radio
L ef t/Right Balance, and Front/
Rear Fader
Treble/Bass
Subwoof er/Center
Features
131
FADER ADJUST ICON
CENTER ADJUST ICON SUBWOOFER
ADJUST ICONBALANCE
ADJUST
ICON
TREBLE
ADJUST
ICON
BASS ADJUST
ICON