2006 Acura TL ignition

This indicator normally comes on f or
a f ew seconds when you turn the
ignition switch to the ON (II)
position.This indicator has three f unctions.
Itcomesonasareminderthatyou
have turned off the vehicle
stability assist (VSA) system.
It flashes when VSA is active (see
page ).
It comes on along with the VSA
system indicator if there is a
problem with the VSA system.
This indicator normally comes on f or
a f ew seconds when you turn the
ignition switch to the ON (II)
position. See page f or more
inf ormation on the VSA system. This indicator comes on when you
set the cruise control. See page
f or inf ormation on operating the
cruise control. This indicator comes on when you
turn on the cruise control system by
pressing the master button (see page ).
If itcomesonandstaysonatany
other time, or if it does not come on
when you turn the ignition switch to
the ON (II) position, there is a
problem with the VSA system. Take
your vehicle to a dealer to have it
checked. Without VSA, your vehicle
still has normal driving ability, but
will not have VSA traction and
stability enhancement. See page f or more inf ormation on the
VSA system. 1.
2.
3.
202
202 202153
153
Vehicle Stability Assist
(VSA ) System Indicator
VSA A ctivation Indicator
Cruise Main Indicator
Cruise Control Indicator
Instrument Panel Indicators
62

This indicator reminds you that the
exterior lights are on. It comes on
when the light switch is in either theor position. If you turn the
ignition switch to the ACCESSORY
(I) or the LOCK (0) position without
turning of f the light switch, this
indicator will remain on. A reminder
chime will also sound when you open
the driver’s door.
The lef t or right turn signal indicator
blinks when you signal a lane change
or turn. If an indicator does not blink
or blinks rapidly, it usually means
one of the turn signal bulbs is
burned out (see page ). Replace
the bulb as soon as possible, since
other drivers cannot see that you are
signaling.
When you press the hazard warning
button, both turn signal indicators
blink. All turn signals on the outside
of the vehicle should f lash.
This indicator also comes on with
reduced brightness when the
daytime running lights (DRL) are on
(see page ). This indicator comes on with the
high beam headlights. See pagef or inf ormation on the headlight
controls. If this indicator comes on when the
ignition switch is turned to the ON
(II) position and the parking brake is
released, it means there is a problem
in a circuit. Have your vehicle
checked by your dealer.
228
8484Canadian models only
Instrument Panel Indicators
Turn Signal and
Hazard Warning
Indicators ‘‘Daytime Running
Lights’’ Indicator
Lights On Indicator
High Beam Indicator
Inst rument s and Cont rols
63

This indicator also blinks several
times when you turn the ignition
switch f rom the ON (II) position to
the ACCESSORY (I) or the LOCK
(0) position.This indicator comes on when you
turn on the fog lights. See page
f or inf ormation on f og light
operation.
This indicator comes on f or a f ew
seconds when you turn the ignition
switch to the ON (II) position. It then
goes of f if you have inserted a
properly-coded ignition key. If it is
not a properly-coded key, the
indicator will blink and the engine
will not start (see page ).
This indicator is in the f uel gauge. It
comesonasareminderthatyou
must ref uel soon. When the indicator
comes on, there is about 1.2 U.S. gal
(4.5
) of f uel remaining in the tank
bef ore the needle reaches E. There
is a small reserve of f uel remaining
in the tank when the needle does
reach E.
91
85
U.S. models only
Immobilizer System
Indicator
L ow Fuel Indicator
Fog L ight Indicator
Instrument Panel Indicators
64
LOW FUEL INDICATOR

This indicator normally comes on f or
a f ew seconds when you turn the
ignition switch to the ON (II)
position. If it comes on while driving,
it means that one or more of your
vehicle’s tires are extremely low on
pressure. You will also see a
‘‘CHECK TIRE PRESSURE’’
message on the multi-inf ormation
display. The multi-inf ormation
display will show you which tire has
lost the pressure and how much
pressure it has lost (see page ).This indicator normally comes on f or
a f ew seconds when you turn the
ignition switch to the ON (II)
position.
If this indicator comes on and stays
on at any other time, or if it does not
come on when you turn the ignition
switch to the ON (II) position, there
is a problem with the TPMS. You will
also see ‘‘CHECK TPMS SYSTEM’’
message on the multi-information
display. With this indicator on, the
low tire pressure indicator will not
come on, and the tire pressure
monitor on the multi-inf ormation
display will not be displayed.
If this happens, pull to the side of the
road when it is saf e, check which tire
has lost the pressure on the multi-
inf ormation display, and determine
the cause. If it is because of a flat tire,
replace the flat tire with the compact
spare (see page ), and have the
f lat tire repaired as soon as possible.
If two or more tires are underinf lated,
call a prof essional towing service.
For more inf ormation, see page .
245
204 204
Low Tire Pressure
Indicator
Tire Pressure Monitoring
System (T PMS) Indicator
Instrument Panel Indicators
65

This shows the temperature of the
engine’s coolant. During normal
operation, the pointer should rise to
about the middle of the gauge. In
severe driving conditions, the pointer
may rise to the upper zone. If it
reaches the red (hot) mark, pull
safely to the side of the road. Turn to
page f or instructions and
precautions on checking the engine’s
cooling system.
This shows how much f uel you have.
It may show slightly more or less
than the actual amount. Driving
uphill or making turns can cause the
needle to f luctuate or the low f uel
indicator to come on early. The
needle returns to the bottom after
you turn of f the ignition.254
Temperature Gauge
Fuel Gauge
Gauges
Inst rument s and Cont rols
66
FUEL GAUGE
TEMPERATURE GAUGE
SPEEDOMETER
TACHOMETER
Avoid driving with an extremely low f uel level. Running out of f uel could cause
the engine to misf ire, damaging the catalytic converter.

The multi-inf ormation display in the
instrument panel displays various
inf ormation and messages when the
ignition switch is in the ON (II)
position. Some of the messages help
you operate your vehicle more
comf ortably.
Others help to keep you aware of the
periodic maintenance your vehicle
needs f or continued trouble-f ree
driving.Driver 1 or 2 Detected
Door and Trunk Open
Fasten Seat Belt
Release Parking Brake
Odometer
Trip Meter
Outside Temperature
Engine Oil Lif e Maintenance Messages
Auto door lock conditions
Auto door unlock conditions
Whenever unlocking (driver’s
door, or all doors)
Keyless lock acknowledgment
conditions
Security relock timer
Headlight auto of f timer
Interior light dimming time
To customize these control settings,
see page .
Low Windshield Washer Fluid
Level (Canada only)
Here is a list of the messages you
can see. The f ollowing pages give
you more inf ormation on these
messages.
Tighten Fuel Cap With the multi-information display
and the two buttons next to it, you
can also customize these vehicle
control settings to your liking.Language Selection (Canada only) HandsFree Link
Keyless Memory Settings
Trip Computer
Tire Pressure
76
Multi-Inf ormation Display
67
SELECT/
RESET
BUTTON
INFO
BUTTON
TMTM

¼»
With the ignition switch in the ON
(II) position, the basic display
changes, as shown in the illustration,
each time you press the side of
the INFO button. If you press the
side of the INFO button, the display
returns to the previous message.
On Canadian models, the language in
the multi inf ormation display can be
set to English or French. To change
the language see page .
81
Multi-Inf ormation Display
Inst rument s and Cont rols
68
(CANADIAN MODELS ONLY)

If you start driving without releasing
the parking brake, the multi-
inf ormation display interrupts the
current display and shows
‘‘RELEASE PARKING BRAKE.’’
This message continues, and a
chime sounds, until you release the
parking brake, or the vehicle speed
slows down to less than 0.5 mph (0.8
km/h).If the f uel f ill cap is missing or not
tightened properly, you will see
‘‘TIGHTEN FUEL CAP’’. Make sure
the f uel cap is installed and tightened
properly at least once.The TIGHTEN FUEL CAP message
should go of f af ter tightening the
f uel cap, turning the ignition switch
of f and on, then driving over 30 mph
(48 km/h) f or at least 45 seconds.
Due to dif f erent driving conditions, it
may take a few driving trips to make
the message go of f .
If a loose or missing f uel cap was not
the cause of the TIGHTEN FUEL
CAP message coming on, the
message will turn of f and the
malf unction indicator lamp will come
on. If this happens, have your vehicle
checked by a dealer as soon as
possible.
Release Parking Brake
Tighten Fuel Cap
Multi-Inf ormation Display
Inst rument s and Cont rols
70