Page 1449 of 2893

Î
(#'
)
18-38Rear Suspension
Stabilizer Bar Replacement
B
C
D
A
Except Type S model:
8x1.25mm
22N·m(2.2kgf·m,16lbf·ft)
Type S model:
10x1.25mm
49 N·m
(5.0 kgf·m, 36 lbf·ft)
E
10x1.25mm
39 N·m
(4.0 kgf·m,
29 lbf·ft)
A
1. Raise the rear of the vehicle, and support it with
safety stands in the proper locations (see page
1-11).
2. Remove the rear wheels.
3. Disconnect both stab ilizer links from the stabilizer
bar (see page 18-37).
4. Remove the flange bolts (A) and the bushing holders (B), then remove the bushings (C) and the
stabilizer bar (D).
NOTE: During installation, align the paint marks (E)
on the stabilizer bar with the sides of the bushings.
5. Replace the stabilizer bar bracket (A) if necessary. 6. Install the stabilizer bar in the reverse order of
removal, and note these items:
Note the right and left direction of the stabilizer bar.
Refer to stabilizer link removal/installation to connect the stab ilizer bar to the links (see page
18-37).
Before installing the wheel, clean the mating surfaces of the brake disc and inside of the wheel.
7. Check the wheel alignment, and adjust it if necessary (see page 18-5).
08/08/21 14:57:45 61SNR030_180_0038
ProCarManuals.com
DYNOMITE -2009-
Page 1453 of 2893
(#'
)
Exploded View
18-4218-42 Rear Suspension
Damper Replacement (cont’d) Spring Replacement
A
B
C
10x1.25mm
B C
A
10x1.25mm
29 N·m
(3.0 kgf·m,
22 lbf·ft) SPRING MOUNTING
RUBBER
SPRING
LOWER SPRING SEAT
5. Install the damper mounting bushing (A), the damper mounting washer (B), and the new self-
locking nut (C) on the damper shaft.
6. Tighten the self-locking nut (A) to the specified torque value while holding the damper shaft (B)
with a hex wrench (C).
7. Install the trunk side trim panel (see page 20-80).
8. Clean the mating surfaces of the brake disc and the inside of the wheel, then install the rear wheel.
9. Check the wheel alignment, and adjust it if necessary (see page 18-5).
Replace.
Replace. Check for weakness
and damage.
Check for damage.
Check for deterioration
and damage.
08/08/21 14:58:17 61SNR030_180_0042
ProCarManuals.com
DYNOMITE -2009-
Page 1454 of 2893
(#'
)
Exploded View
18-4218-42 Rear Suspension
Damper Replacement (cont’d) Spring Replacement
A
B
C
10x1.25mm
B C
A
10x1.25mm
29 N·m
(3.0 kgf·m,
22 lbf·ft) SPRING MOUNTING
RUBBER
SPRING
LOWER SPRING SEAT
5. Install the damper mounting bushing (A), the damper mounting washer (B), and the new self-
locking nut (C) on the damper shaft.
6. Tighten the self-locking nut (A) to the specified torque value while holding the damper shaft (B)
with a hex wrench (C).
7. Install the trunk side trim panel (see page 20-80).
8. Clean the mating surfaces of the brake disc and the inside of the wheel, then install the rear wheel.
9. Check the wheel alignment, and adjust it if necessary (see page 18-5).
Replace.
Replace. Check for weakness
and damage.
Check for damage.
Check for deterioration
and damage.
08/08/21 14:58:17 61SNR030_180_0042
ProCarManuals.com
DYNOMITE -2009-
Page 1455 of 2893
Removal
18-43
A
B
6x1.0mm
C
8x1.25mm
AC
12x1.25mm
D
B B
C A
12x1.25mm
A
12x1.25mm
1. Raise the rear of the vehicle, and support it with safety stands in the proper locations (see page
1-11).
2. Remove the rear wheel.
3. Remove the wheel speed sensor (A) from the knuckle (B). Do not disconnect the wheel speed
sensor connector.
4. Remove the brake hose mounting bolt (C) from the bracket.
5. Position a floor jack at the connecting point of the trailing arm (A) and the knuckle (B). Raise the floor
jack until the suspension begins to compress.
6. Remove the flange bolt (C) that connects the trailing arm and the damper (D).
7. Disconnect the stab ilizer link from the trailing arm
(see page 18-37). 8. Remove the flange bolt (A) that connects the
knuckle (B) and the upper arm (C).
9. Remove the trailing arm front m ounting bolts (A).
(cont’d)
Replace. Replace.
Replace.
08/08/21 14:58:18 61SNR030_180_0043
ProCarManuals.com
DYNOMITE -2009-
Page 1458 of 2893
Î
18-46Rear Suspension
Spring Replacement (cont’d)
A
B
6x1.0mm
9.8 N·m
(1.0 kgf·m,
7.2 lbf·ft)
8x1.25mm
22 N·m
(2.2 kgf·m, 16 lbf·ft) (Multipurpose)
9. Install the wheel speed sensor (A), and the brake
hose (B).
NOTE: Apply multipurpose grease to the mating surfaces on the knuckle and the O-ring during
reassembly.
To prevent O-ring damage, the wheel speed sensor must be installed with the guide pin tool
(see step 5 on page 19-175).
10. Clean the mating surfaces of the brake disc and the inside of the wheel, then install the rear wheel.
11. Check the wheel alignment, and adjust it if necessary (see page 18-5).
08/08/21 14:58:20 61SNR030_180_0046
ProCarManuals.com
DYNOMITE -2009-
Page 1477 of 2893

(#'
)
µ
µ µ
µ
µ
µ
DTC 21, 22, 23, 24:
YES
NO
DTC Tire Pressure Sensor Number YES
NO
YES
NO
18-64TPMS
DTC Troubleshooting (cont’d)
Tire Pressure Sensor
Abnormally High Temperature
1. Turn the ignition switch to LOCK (0).
2. Make sure the tires have cooled down.
NOTE: An abnormal rise in the internal temperature
of the tires can be caused by Excessive braking
Failure to release the parking brake (rear tires only)
Leaving the vehicle r unning while parked (front
tires only)
Improper assembly of a wheel and tire
3. Test-drive the vehicle at 45 km/h (28 mph) or more for at least 1 minute.
The system is OK at this time. Clear the DTC
with the HDS.
Go to step 4.
4. Check for DTCs with the HDS.
5. Note the tire pressure sensor(s) number by the indicated DTC.
21 No. 1
22 No. 2
23 No. 3
24 No. 4 6. Do the tire pressure sensor location procedure to
determine the affected tire location and relate it to
the tire pressure sensor number (see page 18-53).
7. Check the TIRE 1, TIRE 2, TIRE 3, or TIRE 4 AIR TEMPERATURE in the TPMS DATA LIST with the
HDS.
Replace the appropriate tire pressure sensor
(see page 18-76).
Go to step 8.
8. Clear the DTC with the HDS.
9. Test-drive the vehicle at 45 km/h (28 mph) or more for at least 1 minute.
10. Check for DTCs with the HDS.
Check for loose terminals and poor
connections at the TPMS control unit. If necessary,
substitute a known-good TPMS control unit
(see page 18-75), and recheck.
If any other DTCs are indicated, troubleshoot
the appropriate DTC. If no DTC are indicated, the
system is OK at this time.
Does t he T PM S i nd i cat or go of f ? I s 80 ° C ( 17 6 ° F ) or mor e i nd i cat ed ?
Is DT C 21, 22, 23, or 24 indicated?
08/08/21 14:58:59 61SNR030_180_0064
ProCarManuals.com
DYNOMITE -2009-
Page 1492 of 2893

(#'
/)
Brakes
Conventional Brake Components......................
......................
ABS (Anti-lock Brake System)
Components (’06-07 Models) . 19-47
......................
......................
VSA (Vehicle Stability Assist) System
Components (’07-09 Models) . 19-95
................................................................
.....................................................................
........................................
............................................................... ................
............................................... ...................
.......................................... ..................................... ..........
........................................ ...................................
..................................... ....................................
.........................................
...................................................... ....................................... ...........
......................................... ....................................
......................................
........................................... .................................
............................................ .............................
............................................................ ................................
................................................................
.....................................................................
........................................
............................................................... ................
............................................... ...................
.......................................... ..................................... ..........
........................................ ...................................
..................................... ....................................
.........................................
...................................................... ....................................... ...........
......................................... ....................................
......................................
........................................... .................................
............................................ .............................
............................................................ ................................
Special Tools . 19-2
Component Location Index . 19-3
Brake System Inspection and Test . 19-4
Symptom Troubleshooting . 19-5
Brake Pedal and Brake Pedal Position Switch
Adjustment . 19-6
Parking Brake Inspection and Adjustment . 19-7
Brake System Bleeding . 19-9
Brake System Indicator Circuit Diagram . 19-10
Parking Brake Switch Test . 19-11
Brake Fluid Level Switch Test . 19-11
Front Brake Pad Inspection and Replacement . 19-12
Front Brake Disc Inspection . 19-19
Front Brake Disc Replacement . 19-21
Front Brake Caliper Overhaul . 19-22
Master Cylinder Replacement . 19-24
Master Cylinder Inspection . 19-25
Brake Booster Test . 19-26
Brake Booster Replacement . 19-27
Rear Brake Pad Inspection and Replacement . 19-29
Rear Brake Disc Inspection . 19-32
Rear Brake Disc Replacement . 19-34
Rear Brake Caliper Overhaul . 19-35
Brake Pedal Replacement . 19-36
Brake Hose and Line Inspection . 19-37
Brake Hose Replacement . 19-38
Parking Brake Cable Replacement . 19-40
Parking Brake Lever Grip and Cover Replacement . 19-41
Brake Pedal Cover Replacement . 19-45
08/08/21 15:00:43 61SNR030_190_0001
ProCarManuals.com
DYNOMITE -2009-
Page 1493 of 2893
(#'
%)Ref. No. Tool Number Description Qty
19-2
Conventional Brake Components
Special Tools
07AAE-SEPA101
Brake Caliper Piston Compressor 1
07AAG-SVBA100 Guide PinTool 1
08/08/21 15:00:44 61SNR030_190_0002
ProCarManuals.com
DYNOMITE -2009-