3-12
E
INSP
ADJ
POWER UNIT
NOTE:
The new valve pad number is only an
approximation. The valve clearance must
be measured again and the above steps
should be repeated if the measurement is
still incorrect.
Install the new valve pad 5
and the valve
lifter 6
.
NOTE:
Lubricate the valve pad with molybdenum
disulfide grease.
Lubricate the valve lifter with molybdenum
disulfide oil.
The valve lifter must turn smoothly when
rotated by hand.
Install the valve lifter and the valve pad in
the correct place.
Install the exhaust and intake camshafts,
timing chain, and camshaft caps.
T R..
Camshaft cap bolt:
10 N m (1.0 kgf m, 7.2 ft lb)
NOTE:
Refer to “Camshaft installation — CAM-
SHAFTS” in Chapter 5.
Lubricate the camshafts, camshaft lobes,
and camshaft journals.
Install the exhaust camshaft first.
Align the camshaft marks with the cam-
shaft cap marks.
Turn the crankshaft clockwise several full
turns to seat the parts.
Measure the valve clearance again.
If the valve clearance is still out of specifi-
cation, repeat all of the valve clearance
adjustment steps until the specified clear-
ance is obtained.
6
5
ProCarManuals.com
E
HULL
HOOD
1
2
3
4
5
6
7
8
9
REMOTE CONTROL CABLES AND SPEED SENSOR LEAD .................... 8-23
EXPLODED DIAGRAM ........................................................................... 8-23
REMOVAL AND INSTALLATION CHART .............................................. 8-23
SERVICE POINTS .................................................................................. 8-26
Remote control cables inspection ..................................................... 8-26
Steering cable (jet pump end) installation ......................................... 8-26
Steering cable stopper installation .................................................... 8-26
Shift cable (jet pump end) installation (Deluxe model only) .............. 8-27
Shift cable (shift lever end) installation (Deluxe model only)............. 8-27
Remote control cables adjustment .................................................... 8-27
SEAT AND HAND GRIP................................................................................ 8-28
EXPLODED DIAGRAM ........................................................................... 8-28
REMOVAL AND INSTALLATION CHART .............................................. 8-28
SERVICE POINTS .................................................................................. 8-30
Seat lock assembly inspection .......................................................... 8-30
EXHAUST SYSTEM ...................................................................................... 8-31
EXPLODED DIAGRAM ........................................................................... 8-31
REMOVAL AND INSTALLATION CHART .............................................. 8-31
SERVICE POINTS .................................................................................. 8-34
Exhaust system inspection................................................................ 8-34
Exhaust component parts sub-assembly .......................................... 8-34
Exhaust system installation ............................................................... 8-35
DECK AND HULL.......................................................................................... 8-36
EXPLODED DIAGRAM ........................................................................... 8-36
REMOVAL AND INSTALLATION CHART .............................................. 8-36
ENGINE MOUNT ........................................................................................... 8-38
EXPLODED DIAGRAM ........................................................................... 8-38
REMOVAL AND INSTALLATION CHART .............................................. 8-38
ProCarManuals.com