2005 YAMAHA VX110 remote control

7-53
E
–+ELEC
Display function (Deluxe model only)
1. Check:
Display function
Does not operate → Replace the multi-
function meter.
1Remote control unit
2Buzzer
3Speed sensor
4ECM
5Fuel senderB: Black
Gy : Gray
P: Pink
R: Red
W: White
Y : Yellow
B/G : Black/greenB/L : Black/blue
B/Y : Black/yellow
L/B : Blue/black
L/R : Blue/red
L/Y : Blue/yellow
R/W : Red/white
INDICATION SYSTEM
B/LB
L/R
B/YR/WB/Y
PB/G
R/W
YY
RR
WW
B
B
B/G
P L/R
R
BR
1
2
3
4
5
Gy
L/B
L/R
L/Y
L/B
B/L
ProCarManuals.com

7-58
E
–+ELEC
REMOTE CONTROL SYSTEM
(DELUXE MODEL ONLY)
REMOTE CONTROL SYSTEM (DELUXE MODEL ONLY)
WIRING DIAGRAM
WBrBRFREE
PUSHBWFREE
PUSH
Br BrFREE
PUSHBW
BrBrBrBrR
R
10A
10A
3A
30A20A
RR
BBR
BBr
BBr
WW
WLR
Y
Y
Y
WR/Y
B
B
Pu/RPu/B
Pu/GPu/Y
W/B
GyB
B
BBBBBB
R
Y
R/Y
R/Y
B/LL/YL/B
R/YPu/G
Pu/Y
Pu/B
Pu/RR/Y
R/YR/YR/YR/YR/Y
YY
LR
BBB
B
BR
BGyRW
B/LL/R
L/RL/B
L/YL/BW/B
Br
GyBrL/R
6
6 6 6
7
8 90
4 3
5 2 C
BD
1 A
È
1Battery
2Fuse (30 A)
3Fuse (20 A)
4Fuse (3 A)
5Starter relay
6Fuel injector
7Remote control unit
8Antenna
9ECM0Buzzer
AMultifunction meter
BStart switch
CEngine stop switch
DEngine shut-off
switch
ÈTo entry boxB: Black
Br : Brown
Gy : Gray
L: Blue
R: Red
W: White
Y: Yellow
B/L : Black/blue
L/B : Blue/blackL/R : Blue/red
L/Y : Blue/yellow
Pu/B : Purple/black
Pu/G : Purple/green
Pu/R : Purple/red
Pu/Y : Purple/yellow
R/Y : Red/yellow
W/B : White/black
ProCarManuals.com

7-59
E
–+ELEC
REMOTE CONTROL SYSTEM
(DELUXE MODEL ONLY)
REMOTE CONTROL SYSTEM
Yamaha Security System indicator
1. Check:
Yamaha Security System indicator
Check that the “SECURITY” indicator
light 1 comes on when the Yamaha
Security System is deactivated (i.e., the
engine can be started).
Does not come on → Measure the
remote control unit output voltage.
2. Measure:
Remote control unit output voltage
Within specification → Replace the mul-
tifunction meter.
Out of specification → Replace the
remote control unit.
Remote control unit output
voltage:
Blue/yellow (L/Y) – ground
11–13 V
Measurement steps:
Disconnect the remote control unit 1
coupler from the multifunction meter.
Measure the remote control unit output
voltage while pushing the unlock button
of the remote control transmitter.
1
1
L/Y
1
Low-rpm mode indicator
1. Check:
Low-rpm mode indicator
Does not come on → Replace the multi-
function meter.
Checking steps:
Press the unlock button 1 of the remote
control transmitter for more than 4 sec-
onds to select the low-rpm mode.
Check that the beeper sounds three
times and that the “L-MODE” indicator
light 2 comes on.
1
ProCarManuals.com

7-60
E
–+ELEC
REMOTE CONTROL SYSTEM
(DELUXE MODEL ONLY)
Checking the remote control transmitter
1. Check:
Remote control transmitter
Does not operate → Replace the remote
control transmitter.
Checking steps:
CAUTION:
If the buttons on the remote control
transmitter are pushed but the transmit-
ter does not operate, the battery may be
low.
Press the lock button 1 of the remote
control transmitter. The beeper sounds
once.
Check that the “SECURITY” indicator
light goes off and that the engine cannot
be started.
Press the unlock button 2 of the remote
control transmitter for a short time. The
beeper sounds two or three times.
Check that the “SECURITY” indicator
light comes on and that the engine can
be started.
Press the unlock button for more than 4
seconds to select the low-rpm mode.
Check that the beeper sounds three
times and that the “L-MODE” indicator
light comes on.
Number of
beepsYamaha
Security
System modeEngine
startability
1 beep Lock Unable
2 beepsUnlock
(normal mode)Able
3 beepsUnlock
(low-rpm
mode)Able
12
ProCarManuals.com

7-61
E
–+ELEC
REMOTE CONTROL SYSTEM
(DELUXE MODEL ONLY)
NOTE:
If the start switch or the remote control
transmitter is not operated for more than
25 seconds, the multifunction meter dis-
play and the “L-MODE” indicator light will
go off. To change the modes again, press
the lock button for a short time, and then
start the procedures from the lock mode.
While the engine is running, input is not
received from the remote control transmit-
ter.
ProCarManuals.com

7-62
E
–+ELEC
REMOTE CONTROL SYSTEM
(DELUXE MODEL ONLY)
Transmitter registration
1. Register:
Remote control transmitter 1
ID codes can be added or re-registered
by connecting the entry box 2.
Registration steps:
Connect the entry box.
Transmit the ID code from the remote
control transmitter to be registered.
NOTE:
The remote control transmitters can be reg-
istered in any sequence, regardless of
whether they are original equipment or
additional transmitters.
At this time, the system enters the regis-
tration mode to register the first code. All
existing ID codes will be deleted from the
EEPROM.
The “SECURITY” indicator light flashes
when the registration of the ID code has
been completed. (If the registration could
not be completed, the “SECURITY” indi-
cator light comes on. Re-transmit the ID
code.)
After confirming that the registration of
the ID code has been completed using
the “SECURITY” indicator light, transmit
the next ID code.
Register the ID codes for up to five
remote control transmitters.
After ID code registration has been com-
pleted, disconnect the entry box to exit
the registration mode.
Gy
B
12
ProCarManuals.com

7-63
E
–+ELEC
REMOTE CONTROL SYSTEM
(DELUXE MODEL ONLY)
Replacing of the transmitter battery
CAUTION:
Do not allow any water, dust, or dirt to
enter the remote control transmitter case
when replacing the battery.
Make sure that no foreign material is
trapped between the upper case and
lower case of the remote control transmit-
ter during assembly.
1. Remove:
Cover
NOTE:
Loosen the transmitter cover screws in the
sequence shown.
4
1
532 6
2. Install:
Battery 1
NOTE:
Install the battery (CR2016) with the positive
side facing down.
1
3. Install:
Cover
NOTE:
Tighten the transmitter cover screws in the
sequence shown.
T R..
Transmitter cover screw:
0.1 N  m
(0.01 kgf  m, 0.1 ft  lb)
3
6
245 1
ProCarManuals.com

E
HULL
HOOD
1
2
3
4
5
6
7
8
9
REMOTE CONTROL CABLES AND SPEED SENSOR LEAD .................... 8-23
EXPLODED DIAGRAM ........................................................................... 8-23
REMOVAL AND INSTALLATION CHART .............................................. 8-23
SERVICE POINTS .................................................................................. 8-26
Remote control cables inspection ..................................................... 8-26
Steering cable (jet pump end) installation ......................................... 8-26
Steering cable stopper installation .................................................... 8-26
Shift cable (jet pump end) installation (Deluxe model only) .............. 8-27
Shift cable (shift lever end) installation (Deluxe model only)............. 8-27
Remote control cables adjustment .................................................... 8-27
SEAT AND HAND GRIP................................................................................ 8-28
EXPLODED DIAGRAM ........................................................................... 8-28
REMOVAL AND INSTALLATION CHART .............................................. 8-28
SERVICE POINTS .................................................................................. 8-30
Seat lock assembly inspection .......................................................... 8-30
EXHAUST SYSTEM ...................................................................................... 8-31
EXPLODED DIAGRAM ........................................................................... 8-31
REMOVAL AND INSTALLATION CHART .............................................. 8-31
SERVICE POINTS .................................................................................. 8-34
Exhaust system inspection................................................................ 8-34
Exhaust component parts sub-assembly .......................................... 8-34
Exhaust system installation ............................................................... 8-35
DECK AND HULL.......................................................................................... 8-36
EXPLODED DIAGRAM ........................................................................... 8-36
REMOVAL AND INSTALLATION CHART .............................................. 8-36
ENGINE MOUNT ........................................................................................... 8-38
EXPLODED DIAGRAM ........................................................................... 8-38
REMOVAL AND INSTALLATION CHART .............................................. 8-38
ProCarManuals.com