2005 YAMAHA VX110 drain bolt

2-11
ESPECTIGHTENING TORQUES
Oil separator1st
Bolt M6 23.70.372.7572LT5-12
2nd 7.6 0.76 5.5
Ground lead box Bolt M6 3 7.6 0.76 5.5
572LT5-12
Oil tank1st
Bolt M10 515 1.5 11
572LT5-12
2nd 39 3.9 28
Plastic tie/collar1st
Bolt M6 13.70.372.7
5-12
2nd 7.6 0.76 5.5
Oil tank1st
Nut—22.0 0.2 1.4
5-12 2nd 15 1.5 11
3rd 39 3.9 28
Oil tank stay1st
Bolt M10 22.0 0.2 1.4
572LT5-12 2nd 15 1.5 11
3rd 39 3.9 28
Bracket (coupling cover)1st
Bolt M6 23.70.372.7
572LT5-15
2nd 7.6 0.76 5.5
Oil tank cover1st
Bolt M6 83.70.372.7
572LT5-15
2nd 7.6 0.76 5.5
Oil breather plate1st
Bolt M5 91.90.191.4
E5-15
2nd 4.4 0.44 3.2
Baffle plate1st
Bolt M5 31.90.191.4
E5-15
2nd 4.4 0.44 3.2
Oil strainer1st
Bolt M6 23.70.372.7
E5-15
2nd 7.6 0.76 5.5
Oil cooler cover1st
Bolt M6 243.70.372.7
572LT5-15
2nd 7.6 0.76 5.5
Anode Screw M4 1 3.8 0.38 2.7
E5-15
Oil pump assembly BoltM6 6 10 1.0 7.2
572LT5-21 1st
M8 415 1.5 11
2nd 28 2.8 20
Drain plug (engine oil) Bolt M8 1 13 1.3 9.4 5-21
Strainer1st
Bolt M6 23.70.372.7
5-21
2nd 7.6 0.76 5.5
Drive coupling——1282.820
572LT5-24
Reduction drive gear
case1st
Bolt M6 23.70.372.7
572LT5-24
2nd 7.6 0.76 5.5
1st
Bolt M8 515 1.5 11
572LT5-24
2nd 28 2.8 20
Starter motor lead Nut—1 4.9 0.49 3.5
A5-33
Starter motor Bolt M8 2 18 1.8 13 5-33
Generator cover1st
Bolt M10 815 1.5 11
572LT5-33
2nd 50 5.0 36
Flywheel magneto Bolt M10 1 75 7.5 54
E5-33
Starter clutch Bolt M8 6 24 2.4 17 5-33Part to tightenedPart
nameThread
sizeQ’tyTightening torque
RemarksRefer to
page
Nmkgfmftlb
ProCarManuals.com

2-14
ESPECTIGHTENING TORQUES
Shift cable locknut
(Deluxe model only)Nut—1 3.8 0.38 2.7572LT8-23
Steering cable locknut
(steering column side)Nut—1 6.5 0.65 4.7 8-23
Steering cable locknut
(jet pump side)Nut—1 6.8 0.68 4.9
572LT8-23
Steering cable seal Nut—1 5.9 0.59 4.3 8-23
Steering cable bracket Bolt M6 1 6.9 0.69 5.0
572LT8-23
Speed sensor lead grommet Nut—1 5.9 0.59 4.3 8-23
Hinge assembly Bolt M6 2 6.9 0.69 5.0 8-8
Hood lock assembly Bolt M5 2 1.9 0.19 1.4
572LT8-8
Hinge assembly Bolt M6 4 6.9 0.69 5.0
242LT8-8
Lid lock hook Bolt M6 2 6.9 0.69 5.0
242LT8-8
Mirror (Deluxe model only) Nut—4 15 1.5 11 8-8
Shift handle lever
(Deluxe model only)Screw M5 2 3.70.372.7
572LT8-11
Multifunction meter Bolt M5 4 3.9 0.39 2.8
572LT8-11
Engine hatch cover
(Deluxe model only)Bolt M6 1 6.9 0.69 5.0
572LT8-11
Engine hatch cover Bolt M6 8 6.9 0.69 5.0
572LT8-11
Detent plate Bolt M6 2 8.0 0.8 5.8
572LT8-16
Shift lever bracket
(Deluxe model only)Nut—2 15 1.5 11 8-16
Pilot water outlet Nut—1 4.2 0.42 3.0 8-17
Hand grip Nut—4 6.9 0.69 5.0 8-28
Seat bracket Nut—2 15 1.5 11 8-28
Seat lock projection Bolt—1 26 2.6 19 8-28
Seat lock assembly Bolt M6 2 6.4 0.64 4.6
271LT8-28
Plate/rubber hose/exhaust
valveNut—6 5.4 0.54 3.9 8-31
Hose clamp 1——2 3.7 0.37 2.7 8-31
Hose clamp 2——1 3.7 0.37 2.7 8-31
Joint clamp 1 and 4——2 3.7 0.37 2.7 8-31
Joint clamp 2 and 31st
——22.40.241.7
8-31
2nd 2.4 0.24 1.7
Sponson Bolt M810161.612
572LT8-36
Cleat Nut—2
15 1.5 11 8-36
4
Spout Nut—1 5.4 0.54 3.9 8-36
Protector (bow) Nut—5 6.9 0.69 5.0 8-36
Bow eye Bolt M6 2 13 1.3 9.4 8-36
Drain plug/packing Screw M5 4 2.0 0.2 1.4 8-36
Engine mount Bolt M8 8 17 1.7 12
572LT8-38
Engine damper Bolt M6 2 6.6 0.66 4.8
271LT8-38 Part to tightenedPart
nameThread
sizeQ’tyTightening torque
RemarksRefer to
page
Nmkgfmftlb
ProCarManuals.com

3-1
E
INSP
ADJ
MAINTENANCE INTERVAL CHART
MAINTENANCE INTERVAL CHART
The following chart should be considered strictly as a guide to general maintenance intervals.
Depending on operating conditions, the intervals of maintenance should be changed.
*1: After every use
MAINTENANCE INTERVAL INITIALTHEREAFTER
EVERYPAGE
10 hours 50 hours 100 hours 100 hours 200 hours
ITEM6
months12
months12
months24
months
Spark plug Inspect, clean, adjust 3-20
Lubrication points Lubricate 3-26
Fuel system Inspect3-7
Fuel tank Inspect, clean 3-7
Trolling speed Inspect3-6
Throttle shaft Inspect—
Cooling water passages Flush *1 —
Water inlet strainer Inspect, clean —
Bilge strainer Clean3-26
Impeller Inspect3-25
Jet thrust nozzle angle Inspect, adjust 3-2
Shift cable and
mechanism
(Deluxe model only)Inspect, adjust 3-5
Throttle cable Inspect, adjust 3-4
Stern drain plugs Inspect, replace 3-26
Battery Inspect 3-22
Rubber coupling Inspect—
Engine mount Inspect5-7
Nuts and bolts Inspect—
Air filter Inspect, replace 3-18
Engine oil Replace 3-14
Engine oil filter Replace 3-16
Valve clearance Inspect, adjust 3-8
ProCarManuals.com

5-1
EPOWRENGINE UNIT
ENGINE UNIT
EXPLODED DIAGRAM
REMOVAL AND INSTALLATION CHART
Step Procedure/Part name Q’ty Service points
ENGINE UNIT REMOVAL
Follow the left “Step” for removal.
Engine oil Drain.
Refer to “POWER UNIT” in Chapter 3.
Storage compartment panel Refer to “FRONT HOOD” in Chapter 8.
Battery negative and positive lead Refer to “FUSE BOX” in Chapter 7.
Fuel hose Refer to “FUEL INJECTION SYSTEM” in
Chapter 4.
Water lock and exhaust joint Refer to “EXHAUST SYSTEM” in Chapter 8.
1 Bolt/washer 2/2
2 Fuse box 1
14 10
10
2
113
3
4
11
15
12
8
7
9
6
5
2nd 18 N  m (1.8 kgf  m, 13 ft  Ib) 1st 8.8 N  m (0.88 kgf  m, 6.4 ft  Ib)
8 × 35 mm
6 × 25 mm
7.8 N  m (0.78 kgf  m, 5.6 ft  Ib)
8 × 35 mm 17 N  m (1.7 kgf  m, 12 ft  Ib)
17 N  m (1.7 kgf  m, 12 ft  Ib)8 × 40 mm
17 N  m (1.7 kgf  m, 12 ft  Ib)
10LT
242
LT
LT
572
LT
LT
271
ProCarManuals.com

5-21
EPOWROIL PUMP
OIL PUMP
EXPLODED DIAGRAM
REMOVAL AND INSTALLATION CHART
Step Procedure/Part name Q’ty Service points
OIL PUMP ASSEMBLY
REMOVALFollow the left “Step” for removal.
Oil tank Refer to “OIL TANK”.
1 Drain plug/washer 1/1 Drain engine oil.
2Bolt 6
3Bolt 2
4Bolt 2
5 Oil pump assembly 1
6Gasket 1
7Pin 2
2nd 28 N  m (2.8 kgf  m, 20 ft  Ib) 1st 15 N  m (1.5 kgf  m, 11 ft  Ib)
8 × 112 mm
6 × 25 mm
10 N  m (1.0 kgf  m, 7.2 ft  Ib)
2nd 7.6 N  m (0.76 kgf  m, 5.5 ft  Ib) 1st 3.7 N  m (0.37 kgf  m, 2.7 ft  Ib)
6 × 16 mm
LT
572
LT
LT
572
LT
13 N  m (1.3 kgf  m, 9.4 ft  Ib)
8 × 12 mm
LT
572
LT
1
5
7 73
4
2
6
8
8
9
2nd 28 N  m (2.8 kgf  m, 20 ft  Ib) 1st 15 N  m (1.5 kgf  m, 11 ft  Ib)
8 × 95 mm
Not reusable
ProCarManuals.com

8-36
E
HULL
HOODDECK AND HULL
DECK AND HULL
EXPLODED DIAGRAM
REMOVAL AND INSTALLATION CHART
Step Procedure/Part name Q’ty Service points
DECK AND HULL DISASSEMBLY
Follow the left “Step” for disassembly.
1Nut 1
2 Spout 1
3Nut 2
4 Cleat 1
5Plate 2
6 Bolt/collar 10/10
7 Sponson 2
8 Nut/washer 4/4
9 Screw/washer 4/4
10 Drain plug 2
11 Seal 2
453
7
6
1 2
5
LT
572
16
16
19
17
18
9 10111315
1412
6 × 20 mm
13 N • m (1.3 kgf • m, 9.4 ft • Ib)6.9 N • m (0.69 kgf • m, 5.0 ft • Ib)
8 × 45 mm
16 N • m (1.6 kgf • m, 12 ft • Ib)
15 N • m (1.5 kgf • m, 11 ft • Ib)
5 × 25 mm
2.0 N • m (0.2 kgf • m, 1.4 ft • Ib) 5.4 N • m (0.54 kgf • m, 3.9 ft • Ib)
LT
572
LT
8
14
20
15 N • m (1.5 kgf • m, 11 ft • Ib)
ProCarManuals.com