2005 YAMAHA CYGNUS 125 Owners Manual

3-9
1
2
3
4
5
6
7
8
9
INSTRUMENT AND CONTROL FUNCTIONS
ment.
8 88 8
8Since the storage compartment
accumulates heat when exposed
to the sun, do not store anything
susceptible to heat inside it.
8 88 8
8To avoid humidity from spread-
ing through the storage compart-
ment, wrap wet articles in a plas-
tic bag before storing them in the
compartment.
8 88 8
8Since the storage compartment
may get wet while the scooter is
being washed, wrap any articles
stored in the compartment in a
plastic bag.
8 88 8
8Do not keep anything valuable or
breakable in the storage com-
partment.To store a helmet in the storage com-
partment, place the helmet upside-down
with the front facing forward.NOTE:
8Some helmets cannot be stored in
the storage compartment because
of their size or shape.8Do not leave your scooter unat-
tended with the seat open.
EAUT1070
Luggage hookZAUM00**11. Luggage hook
EWAT1030
w8 88 8
8Do not exceed the load limit of 3
kg (7 lb) for the luggage hook.
8 88 8
8Do not exceed the maximum
load of 170 kg (374 lb) for the ve-
hicle.
5ML-F8199-E1ch3.pmd2004/10/04, 20:07 9

3-10
1
2
3
4
5
6
7
8
9
INSTRUMENT AND CONTROL FUNCTIONS
EAU15300
SidestandThe sidestand is located on the left side
of the frame. Raise the sidestand or lower
it with your foot while holding the motor-
cycle upright.NOTE:
The built-in sidestand switch is part of
the ignition circuit cut-off system, which
cuts the ignition in certain situations.
(See further down for an explanation of
the ignition circuit cut-off system.)
EWA10240
wThe vehicle must not be ridden with
the sidestand down, or if the
sidestand cannot be properly moved
up (or does not stay up), otherwise
the sidestand could contact the
ground and distract the operator, re-
sulting in a possible loss of control.
Yamaha’s ignition circuit cut-off sys-
tem has been designed to assist the
operator in fulfilling the responsibil-
ity of raising the sidestand before
starting off. Therefore, check this sys-
tem regularly as described below andhave a Yamaha dealer repair it if it
does not function properly.
EAUT1091
Sidestand switch operation
checkCheck the operation of the sidestand
switch against the information below.
EWA10260
w8 88 8
8The vehicle must be placed on
the centerstand during this in-
spection.
8 88 8
8If a malfunction is noted, have a
Yamaha dealer check the system
before riding.
5ML-F8199-E1ch3.pmd2004/10/04, 20:07 10

3-11
1
2
3
4
5
6
7
8
9
INSTRUMENT AND CONTROL FUNCTIONS
Turn the key on.
Put the sidestand up.Push the start switch while applying
either of the brake levers. The engine will
start.Put the sidestand down.
If the engine stalls:
The sidestand switch is OK.
5ML-F8199-E1ch3.pmd2004/10/04, 20:07 11

4-1
1
2
3
4
5
6
7
8
9
PRE-OPERATION CHECKS
EAU15591
The condition of a vehicle is the owner’s responsibility. Vital components can start to deteriorate quickly and unexpectedly,
even if the vehicle remains unused (for example, as a result of exposure to the elements). Any damage, fluid leakage or loss
of tire air pressure could have serious consequences. Therefore, it is very important, in addition to a thorough visual inspec-
tion, to check the following points before each ride.NOTE:
Pre-operation checks should be made each time the vehicle is used. Such an inspection can be accomplished in a very short
time; and the added safety it assures is more than worth the time involved.
EWA11150
wIf any item in the Pre-operation check list is not working properly, have it inspected and repaired before operating
the vehicle.
EAU15580
PRE-OPERATION CHECKS
5ML-F8199-E1ch4.pmd2004/10/04, 20:08 1

4-2
1
2
3
4
5
6
7
8
9
PRE-OPERATION CHECKS
ITEM CHECKS PAGE
Fuel Check fuel level in fuel tank.
 Refuel if necessary.
 Check fuel line for leakage.3-6
Engine oil Check oil level in engine.
 If necessary, add recommended oil to specified level.
 Check vehicle for oil leakage.6-8
Final transmission oil Check vehicle for oil leakage. 6-10
Front brake Check operation.
 If soft or spongy, have Yamaha dealer bleed hydraulic system.
 Check brake pads for wear.
 Replace if necessary.
 Check fluid level in reservoir.
 If necessary, add recommended brake fluid to specified level.
 Check hydraulic system for leakage.6-18, 6-19
Rear brake Check operation.
 Lubricate cable if necessary.
 Check lever free play.
 Adjust if necessary.6-18, 6-19
Throttle grip Make sure that operation is smooth.
 Check cable free play.
 If necessary, have Yamaha dealer adjust cable free play and lubricate cable and
grip housing.6-14, 6-21
Wheels and tires Check for damage.
 Check tire condition and tread depth.
 Check air pressure.
 Correct if necessary.6-15, 6-17
Brake levers Make sure that operation is smooth.
 Lubricate lever pivoting points if necessary.6-21
EAU15603
Pre-operation check list
5ML-F8199-E1ch4.pmd2004/10/04, 20:08 2

4-3
1
2
3
4
5
6
7
8
9
PRE-OPERATION CHECKSCenterstand, sidestand Make sure that operation is smooth.
 Lubricate pivots if necessary.6-21
Chassis fasteners Make sure that all nuts, bolts and screws are properly tightened.
 Tighten if necessary.-
Instruments, lights, signals
and switches Check operation.
 Correct if necessary.-
Sidestand switch Check operation of ignition circuit cut-off system.
 If system is defective, have Yamaha dealer check vehicle.3-10 ITEM CHECKS PAGE
5ML-F8199-E1ch4.pmd2004/10/04, 20:08 3

5-1
1
2
3
4
5
6
7
8
9
OPERATION AND IMPORTANT RIDING POINTS
EAU15980
EWA10870
w8 88 8
8Become thoroughly familiar with
all operating controls and their
functions before riding. Consult
a Yamaha dealer regarding any
control or function that you do
not thoroughly understand.
8 88 8
8Never start the engine or operate
it in a closed area for any length
of time. Exhaust fumes are poi-
sonous, and inhaling them can
cause loss of consciousness and
death within a short time. Always
make sure that there is adequate
ventilation.
8 88 8
8For safety, always start the engine
with the centerstand down.EAU15940
OPERATION AND IMPORTANT RIDING POINTS
EAUT1100
Starting a cold engine
ECA10250
cCSee page 5-3 for engine break-in in-
structions prior to operating the ve-
hicle for the first time.1. Turn the key to “ON”.
2. Close the throttle grip completely.
3. Start the engine by pushing the
star t switch or by kicking the
kickstarter, while applying the front
or rear brake.NOTE:
If the engine fails to start by pushing
the start switch, release the switch, wait
a few seconds, and then try again. Each
starting attempt should be as short as
possible to preserve the battery. Do not
crank the engine more than 5 seconds
on any one attempt. If the engine does
not start with the starter motor, try us-
ing the kickstarter.
ECA11040
cCFor maximum engine life, never ac-
celerate hard when the engine is cold!
5ML-F8199-E1ch5.pmd2004/10/04, 20:08 1

5-2
1
2
3
4
5
6
7
8
9
OPERATION AND IMPORTANT RIDING POINTS
EAU16780
Acceleration and decelerationZAUM00**
(a)(b)
The speed can be adjusted by opening
and closing the throttle. To increase the
speed, turn the throttle grip in direction
(a). To reduce the speed, turn the throttle
grip in direction (b).
EAU16760
Starting offNOTE:
Before starting off, allow the engine to
warm up.1. While pulling the rear brake lever
with your left hand and holding the
grab bar with your right hand, push
the scooter off the centerstand.
2. Sit astride the seat, and then ad-
just the rear view mirrors.
3. Switch the turn signal on.
4. Check for oncoming traffic, and
then slowly turn the throttle grip (on
the right) in order to take off.
5. Switch the turn signal off.
EAU16791
Braking1. Close the throttle completely.
2. Apply both front and rear brakes si-
multaneously while gradually in-
creasing the pressure.
EWA10300
w8 88 8
8Avoid braking hard or suddenly
(especially when leaning over to
one side), otherwise the scooter
may skid or overturn.
8 88 8
8Railroad crossings, streetcar
rails, iron plates on road con-
struction sites, and manhole cov-
ers become extremely slippery
when wet. Therefore, slow down
when approaching such areas
and cross them with caution.
8 88 8
8Keep in mind that braking on a
wet road is much more difficult.
8 88 8
8Ride slowly down a hill, as brak-
ing downhill can be very difficult.
5ML-F8199-E1ch5.pmd2004/10/04, 20:08 2