Page 89 of 332

'05 Rav4_U (L/O 0409)
81
2005 RAV4 from Sep. '04 Prod. (OM42570U)
Same
angle
Same position
When installing a child restraint
system on the rear center position,
adjust both seat cushions to the
same position and align both seat-
backs at the same angle. Otherwise,
the child restraint system cannot be
securely restrained and this may
cause death or serious injuries in a
collision.1. Sit the child on a booster seat. Run
the lap and shoulder belt through or
around the booster seat and across the
child following the instructions provided
by its manufacturer and insert the tab
into the buckle taking care not to twist
the belt.
Make sure the shoulder belt is correctly
across the child's shoulder and that the
lap belt is positioned as low as possible
on the child's hips. See Seat beltsº on
page 44 in this Section for details.
CAUTION
Always make sure the shoulder belt
is positioned across the center of
child's shoulder. The belt should be
kept away from child's neck, but
not falling off child's s houlder.
Otherwise, the child may be killed
or seriously injured in case of sud-
den braking or a collision.
Both high- positioned lap belts and
loose- fitting belts could cause
death or serious injuries due to
sliding under the lap belt during a
collision or other unintended event.
Keep the lap belt positioned as low
on a child's hips as possible.
For child's safety, do not place the
shoulder belt under child's arm.
After inserting the tab, make sure
the tab and buckle are locked and
that the lap and shoulder portions
of the belt are not twisted.
Do not insert coins, clips, etc. in
the buckle as this may prevent your
child from properly latching the tab
and buckle.
Page 90 of 332
'05 Rav4_U (L/O 0409)
82
2005 RAV4 from Sep. '04 Prod. (OM42570U)
If the seat belt does not function
normally, it cannot protect your
child from death or serious injury.
Contact your Toyota dealer immedi-
ately. Do not install the child
restraint system on the seat until
the seat belt is fixed.
2. To remove the child restraint system,press the buckle release button and
allow the belt to retract.Outside position
Center position (U.S.A. only)
Ð U sin g a to p st rap
Page 91 of 332
'05 Rav4_U (L/O 0409)
83
2005 RAV4 from Sep. '04 Prod. (OM42570U)
Follow the procedure below for a child
restraint system that requires the use
of a top strap.
Anchor brackets
U.S.A.
Anchor brackets
Canada
For U.S.A.Ð
Use the anchor brackets behind the rear
seatbacks and on the luggage compart-
ment to attach the top strap.
Anchor brackets are installed for each
rear seating position.
For CanadaÐ
Use the anchor brackets behind the rear
seatbacks to attach the top strap.
Anchor brackets are installed for both out-
side rear seating positions.
Page 92 of 332

'05 Rav4_U (L/O 0409)
84
2005 RAV4 from Sep. '04 Prod. (OM42570U)
TO USE THE ANCHOR BRACKET:1. Outside anchor brackets onlyÐ Remove the head restraint.Outside position
Center position (U.S.A. only)
2. Fix the child restraint system withthe seat belt.
Center anchor bracket onlyÐ
Run the top strap through between
both seatbacks.
Latch the hook onto the anchor
bracket and tighten the top strap.
For instructions to install the child re-
straint system, see Child restraintº on
page 69 in this Section.
CAUTION
When you use the center anchor
bracket, make sure the top strap
runs through between both seat-
backs and tighten it. The top strap
on seatback could cause death or
serious injury due to abnormal
moving of the child restraint system
in case of sudden braking or a col-
lision.
Make sure the top strap is securely
latched, and check that the child
restraint system is secure by push-
ing and pulling it in different direc-
tions. Follow all the installation in-
structions provided by its manufac-
turer.
Page 93 of 332
'05 Rav4_U (L/O 0409)
85
2005 RAV4 from Sep. '04 Prod. (OM42570U)
3. Outside anchor brackets onlyÐReplace the head restraint.Lower anchorages for the child restraint
systems complying with the FMVSS225
or CMVSS210.2 specifications are
installed in the rear seat.
The anchorages are installed in the clear-
ance between the seat cushion and seat-
back of both outside rear seats.
Child restraint systems complying with the
FMVSS213 or CMVSS213 specification
can be fixed to these anchorages. In this
case, it is not necessary to fix the child
restraint system with a seat belt on the
vehicle.
1st lock
position
4th lock
position
CHILD RESTRAINT SYSTEM
INSTALLATION
1. Fold down the seatback and back it to the 1st lock position (most up-
right position) until it locks into
place. Adjust the seatback to the 4th
lock position.
Make sure the seatback is locked secure-
ly.
ÐInstallation with child
restraint lower anchorages
Page 94 of 332
'05 Rav4_U (L/O 0409)
86
2005 RAV4 from Sep. '04 Prod. (OM42570U)
Canada only
Ty p e ACanada only
Ty p e B
For owners in Canada
The symbol on a child restraint system
indicates the presence of a lower connec-
tor system.
Ty p e A Ð 2. Widen the gap between the seat cushion and seatback slightly and
confirm the position of the lower an-
chorages below the tag on the seat-
back.
3. Latch the hooks of lower straps onto the anchorages and tighten the lower
straps.
Ty p e B Ð
2. Widen the gap between the seat cushion and seatback slightly and
confirm the position of the lower an-
chorages below the tag on the seat-
back.
3. Latch the buckles onto the anchor- ages.
If your child restraint system has a top
strap, it should be anchored. (For the
installation of the top strap, see ÐUsing
a top strapº on page 82 in this Section.)
Page 95 of 332

'05 Rav4_U (L/O 0409)
87
2005 RAV4 from Sep. '04 Prod. (OM42570U)
For installation details, refer to the instruc-
tion manual equipped with each product.
CAUTION
When using the lower anchorages
for the child restraint system, be
sure that there are no irregular ob-
jects around the anchorages or that
the seat belt is not caught.
Push and pull the child restraint
system in different directions to be
sure it is secure. Follow all the
installation instructions provided by
its manufacturer.
When using the lower anchorages
for the child restraint system, en-
sure that the seat is moved to the
rear- most position, with the seat-
back close to the child restraint
system.
After securing the child restraint
system, never slide or recline the
seat.
Do not install a child restraint sys-
tem on the rear seat if it interferes
with the lock mechanism of the
front seats. Otherwise, the child or
front seat occupant(s) may be killed
or seriously injured in case of sud-
den braking or a collision.
Page 96 of 332
'05 Rav4_U (L/O 0409)
88
2005 RAV4 from Sep. '04 Prod. (OM42570U)