2005 SUBARU LEGACY tow

11 - 6 8
Maintenance and service
Fuses
Never replace a fuse with one having a higher
rating or with material other than a fuse be-
cause serious damage or a fire could result.
The fuses are designed to melt during an overload to
prevent damage to the wiring harness and electrical
equipment. The fuses are located in two fuse boxes.
One is located under the instrument panel behind the
fuse box cover on the driver’s seat side. Open the lid that is located above the hood release
knob and pull it toward you to remove it.
UBB569BA
UBB584BA

12-5
Specifications
– CONTINUED –
!Tires
! Wheel alignment
Tire sizeP205/55R16 89H215/45ZR17P225/60R16 97HP225/55R17 95V
Wheel size16 x 6.5JJ17 x 7JJ16 x 6.5JJ17 x 7JJ
PressureFront32 psi
(220 kPa, 2.2 kgf/cm 2
)35 psi
(240 kPa, 2.4 kgf/cm 2
)32 psi (220 kPa, 2.2 kgf/cm 2
)
Rear30 psi
(210 kPa, 2.1 kgf/cm 2
)33 psi
(230 kPa, 2.3 kgf/cm 2
)30 psi (210 kPa, 2.1 kgf/cm 2
)
Rear at trailer
towing–32 psi (220 kPa, 2.2 kgf/cm 2
)
Temporary
spare tireSizeT135/80R16T135/70D17T155/70D17
Pressure60 psi (420 kPa, 4.2 kgf/cm 2
)
ItemLegacyOUTBACK
SedanStation wagonSedanStation wagon
ToeFront0 in (0 mm)
Rear0 in (0 mm)
CamberFront–0 °15’0 °40’
Rear–0 °40’–0 °30’–0 °10’

13-6
Consumer information and Reporting safety defects !
Recommended tire inflation pressure
! Recommended cold tire inflation pressure
Recommended cold tire inflation pressure for your vehicle’s tires is as follows,
Tire size P205/55R16 89H215/45ZR17 P225/60R16
97HP225/55R17
95V
Wheel size 16 x 6.5JJ 17 x 7JJ 16 x 6.5JJ 17 x 7JJ
Pressure Front 32 psi (220 kPa, 2.2 kgf/cm2
) 35 psi (240 kPa,
2.4 kgf/cm 2
) 32 psi (220 kPa, 2.2 kgf/cm
2
)
Rear 30 psi (210 kPa, 2.1 kgf/cm2
) 33 psi (230 kPa,
2.3 kgf/cm 2
) 30 psi (210 kPa, 2.1 kgf/cm
2
)
Rear at trailer towing – 32 psi (220 kPa, 2.2 kgf/cm
2
)
Tempo-
rary spare tire Size T135/80R16 T135/70D17 T155/70D17
Pressure 60 psi (420 kPa, 4.2 kgf/cm
2
)

13-10
Consumer information and Reporting safety defects
left hand side of the vehicle. (Each tire must be
kept on its original side of the vehicle.) Replace
any damaged or unevenly worn tire at the time of
rotation. After tire rotation, adjust the tire pres-
sures and make sure the wheel nuts are correct-
ly tightened. A tightening torque specification
and a tightening sequence specification for the
wheel nuts can be found “Flat tires” in Chapter 9. !
Vehicle load limit – how to determine
The load capacity of your vehicle is determined
by weight, not by available cargo space. The
load limit of your vehicle is shown on the vehicle
placard attached to the driver’s side B-pillar. Lo-
cate the statement “The combined weight of oc-
cupants and cargo should never exceed XXX kg
or XXX lbs” on your vehicle’s placard.
The vehicle placard also shows seating capacity
of your vehicle.
The total load capacity includes the total weight
of driver and all passengers and their belong-
ings, any cargo, any optional equipment such as
a trailer hitch, roof rack or bike carrier, etc., and
the tongue load of a trailer. Therefore cargo ca- pacity can be calculated by the following method.
Cargo capacity = Load limit – (total weight of oc-
cupants + total weight of optional equipment +
tongue load of a trailer (if applicable))
For towing capacity information and weight lim-
its, refer to “Trailer towing” in Chapter 8. !
Calculating total and load capacities vary-
ing seating configurations
Calculate the available load capacity as shown in
the following examples:
Example 1A
UBD201BA

13-15
Consumer information and Reporting safety defects
– CONTINUED –
!Adverse safety consequences of over-
loading on handling and stopping and on tires
Overloading could affect vehicle handling, stop-
ping distance, vehicle and tire as shown below.
This could lead to an accident and possibly result
in severe personal injury. " Vehicle stability will deteriorate.
" Heavy and/or high-mounted loads could in-
crease the risk of rollover." Stopping distance will increase.
" Brakes could overheat and fail.
" Suspension, bearings, axles and other body
parts could break or experience accelerated
wear that will shorten vehicle life. " Tires could fail.
" Tread separation could occur.
" Tire could separate from its rim.
! Steps for Determining Correct Load Limit
1. Locate the statement “The combined weight
of occupants and cargo should never exceed
XXX pounds” on your vehicle’s placard. 2. Determine the combined weight of the driver
and passengers that will be riding in your vehicle.
3. Subtract the combined weight of the driver
and passengers from XXX kilograms or XXX
pounds.
4. The resulting figure equals the available
amount of cargo and luggage load capacity. For
example, if the “XXX” amount equals 1,400 lbs
(635kg). and there will be five- 150 lbs (68 kg)
passengers in your vehicle, the amount of avail-
able cargo and luggage load capacity is 650 lbs.
(1,400 – 750 (5 x 150) = 650 lbs.)
5. Determine the combined weight of luggage
and cargo being loaded on the vehicle. That
weight may not safely exceed the available car-
go and luggage load capacity calculated in Step 4.
6. If your vehicle will be towing a trailer, load
from your trailer will be transferred to your vehi-
cle. Consult this manual to determine how this
reduces the available cargo and luggage load
capacity of your vehicle.

14-9
Index
Tilt steering wheel ............................................. 3-63 Tire
Chains .......................................................... 8-17
Inspection ................................................... 11-51
Pressures and wear .................................... 11-52
Replacement .............................................. 11-56
Rotation ...................................................... 11-55
Tires .................................................................. 12-5
Types .......................................................... 11-49
Tires and wheels ............................................. 11-49
Top tether anchorages ...................................... 1-55
Towing ............................................................... 9-21 All wheels on the ground .............................. 9-28
Flat-bed truck ................................................ 9-27
Tie-down hooks ............................................ 9-22
Weight .......................................................... 8-31
Trailer
Hitch ............................................................. 8-27
Hitches .......................................................... 8-37
Towing .......................................................... 8-31
Towing tips ................................................... 8-40
Trip meter ................................................. 3-10, 3-16
Trunk lid ............................................................. 2-35
Release handle ............................................. 2-37
Trunk light ........................................................ 11-86
Turn signal
Indicator lights .............................................. 3-34 Lever ............................................................. 3-47
U
Under-floor storage compartment ..................... 6-30 V
Valet mode ........................................................ 2-27
Vanity mirror ........................................................ 6-6
Vehicle Capacity weight ............................................ 8-19
Identification ............................................... 12-11
Vehicle Dynamics Control
OFF indicator light ........................................ 3-32
OFF switch ................................................... 7-48
Operation indicator light ................................ 3-31
System .......................................................... 7-43
Warning light ................................................. 3-32
Ventilator ............................................................. 4-2 W
Warning and indicator lights .............................. 3-20
Warning lights ABS .............................................................. 3-28
All-wheel drive .............................................. 3-31
Anti-lock Brake system ................................. 3-28
AT OIL TEMPerature .................................... 3-27

GAS STATION REFERENCE
Fuel: !2.5-liter non-turbo models
Use only unleaded gasoline with an octane rating of
87 AKI or higher. ! 2.5-liter turbo models and 3.0-liter models
Use premium unleaded gasoline with an octane rat-
ing of 91 AKI or higher. For temporary purposes if
premium unleaded gasoline is not available, you
may use regular unleaded gasoline with an octane
rating of 87 AKI or higher. For optimum engine per-
formance and driveability, it is required (for 2.5-liter
turbo models), and recommended (for 3.0-liter mod-
els) that you use premium grade unleaded gasoline. ! Fuel octane rating
This octane rating is the average of the Research Octane and Motor Octane numbers and is commonly
referred to as the Anti Knock Index (AKI). Refer to
“Fuel” section in this manual.
Fuel capacity:
16.9 US gal (64 liters, 14.1 Imp gal) Engine oil:
Use only API classification SL with the words “EN-
ERGY CONSERVING” and the New API certification
mark (starburst mark) displayed on the container. Engine oil capacity:
2.5-liter models: 4.2 US qt (4.0 liters, 3.5 Imp qt)
3.0-liter models: 5.8 US qt (5.5 liters, 4.8 Imp qt)
Cold tire pressure: Tire size P205/55R16 89H 215/45ZR17 P225/60R16 97H P225/55R17 95V
Wheel size 16 x 6.5JJ 17 x 7JJ 16 x 6.5JJ 17 x 7JJ
Pressure Front 32 psi (220 kPa, 2.2 kgf/cm2
) 35 psi
(240 kPa, 2.4 kgf/cm 2
) 32 psi (220 kPa, 2.2 kgf/cm
2
)
Rear 30 psi (210 kPa, 2.1 kgf/cm 2
) 33 psi
(230 kPa, 2.3 kgf/cm 2
) 30 psi (210 kPa, 2.1 kgf/cm
2
)
Rear at trail-
er towing – 32 psi (220 kPa, 2.2 kgf/cm
2
)
Temporary
spare tire Size T135/80D16 T135/70D17 T155/70D17
Pressure
60 psi (420 kPa, 4.2 kgf/cm2
)