2005 SKODA SUPERB ignition

BRIEF OPERATING INSTRUCTIONS
4
Pos. ................................................... Page
ßU– Security diode ................................ 22When the radio is switched off and
the ignition key is removed, this diode
will flash to signal that the car radio is
theft-protected by a code system.
´I– SCN button ...................................... 7Pressing this button briefly plays
stations in radio mode or titles in
cassette or CD mode.
Display
4– TP indication .................................... 2
6– DOLBY B NR.................................... 2
8– Station button indication .................. 2
ßE– Waveband ....................................... 2
ßT– Station name ................................... 2
Manufactured under license from Dolby
Laboratories.
"Dolby" and the double-D symbol are
trademarks of Dolby Laboratories.

6
1– Control knob/push button
This knob/button permits:
• Switching on/off
• Volume control
• Tone control
• Tone balance control
TP
Switching on/off,
volume control
Pressing the push button1switches
the radio on and off
The frequency and volume adjusted
before switching off are recovered.
If the ignition key is removed from the
ignition lock with the radio switched on,
the radio is automatically switched off.
If the ignition key is refit into the ignition
lock and turned, the radio is automatically
switched on.
If the ignition key is pulled out, you may
switch on the radio by pressing the control
knob/push button
1twice.
After about 1 hour the radio is automati-
cally switched off to avoid discharging of
the car battery.
You may repeat this operation as often as
desired.
If the radio is switched off and the ignition
key pulled out, the flashing diode
ßUsig-
nals that the car radio is equipped with an
electronic theft protection system.
If the car radio remains mute after switch-
ing on and "SAFE" appears in the display,
observe the notes from page 18.
Turning the control knob
1allows you
to change the volume, the tone or the tone
balance settings.
TP
RADIO MODE
Control knob/push button
11

• Use the control knob/push button 1to
select the desired setting. The setting
range is -- – 47.
LOUD ON/OFF
The Loudness function improves the
sound at low volume.
The function is activated if "LOUD ON" is
shown in the display.
IGN ON/OFF
Switching on and off with the ignition
switch.
"IGN ON" You may switch the car radio on and off with the ignition
switch of the vehicle.
"IGN OFF" You may switch the car radio on and off only with the "IO"
button.
• Press
or of the rocker ß`to select
the desired setting.
REG ON/OFF
If the reception quality gets poor, your car
radio first only selects an alternative fre-
quency of the current station.
However, if the reception quality gets so
poor that a lose of the station becomes
possible, the radio will also accept fre-
quencies of a “related” station.
The "REG ON/REG OFF" function ena-
bles you to select whether alternative
frequencies with identical programme are
to be tuned to with the help of the RDS
signal, that is, regional stations are only
selected in the case of emergency.
• Select REG ON/REG OFF in the Setup menu.
"SETUP" and the current setting are
displayed. The "REG ON" setting is
preset at the factory.
• Press
or of the rocker ß`to select
the desired setting.
REG OFF: free change between all regio-
nally related stations.
REG ON: preferred change between identi-
cal programmes; in the “case of emergen-
cy” also change to a regional programme.
LOC ON/OFF
The LOC ON/OFF function is used to
adjust the station search sensitivity.
Maximum station search sensitivity when
"LOC OFF" is shown in the display.
MONO ON/OFF
The MONO ON/OFF functionis used to
select between mono and stereo sound.
ONVOL
With the ONVOL function you may limit
the maximum switch-on volume.
Normally the last adjusted volume will be
recovered when switching the car radio
on. However, if the switch-off volume is
higher then the ONVOL setting, the
switch-on volume will automatically be
limited to the ONVOL setting.
• Select ONVOL in the Setup menu. "SETUP ONVOL" and the current setting
appear in the display.
19
GB
SETTINGS

21
GB
LED ON/OFF
Switching the security LED on and off.
"LED ON" The security LED is on.
"LED OFF" The security LED is off.
• Press on
or of the rocker ß`to
switch the desired function on.
BEEP ON/OFF
Switching the sound signal on and off.
"BEEP ON" Sound signal as function confirmation.
"BEEP OFF" Function confirmation by brief muting of the loud-
speaker outputs.
• Press on
or of the rocker ß`to
switch the desired function on.
Convenience radio coding
In teh event that you did not receive the
security code for your radio, this is becau-
se your car is equiped with the convenien-
ce system of coding for which this code is
not needed. In the battery is disconnected
and then re-connected, first of all switch
the ignition on with the key and then, after
this, the radio. Should you nevertheless
wish to have the security code, please
contact your ·koda dealer.
Deactivating the electronic security
system
If the electronic security system has
locked the car radio for any reason, for
example, when the car battery has been
disconnected or a fuse has blown, “SAFE”
appears in the radio’s display after swit-
ching on.
• After about 1 second, "1– – – –" appears in the display.
If you now enter the correct code number,
the electronic security system can be
deactivated.
If is absolutely necessary to follow the
order of the operational steps:
• Switch the radio on: "SAFE" appears in the display.
• After about 1 second, "1– – – –" appears in the display (1 stands for the
first attempt).
• Use the station buttons
ßRto enter the
code number which is to be found on the
radio card.
Briefly press the station button 1 to
enter the first digit of the code number,
then station button 2 for the second
digit, etc.• When this is done, press for more than 2 seconds on



or of the rocker ß`then
release the pressure.
• If you have entered the correct code, the frequency will be displayed after a few
moments.
The car radio is operational again.
!If you should have lost the radio
card with the code number, please
contact a Skoda service point.
Coding
SETTINGS THEFT PROTECTION CODING

22
Security diode
Activating the electronic security
system
Press the TP button ß?to display the
Setup menu.
• Select the "CODE/SAFE" function.
• Press
or of the rocker ß`.
• "1– – – –" appears in the display.
• Use the station buttons
ßRto enter the
code number which is to be found on the
radio card.
Briefly press the station button 1 to
enter the first digit of the code number,
then station button 2 for the second
digit, etc.
• When this is done, press for more than 2 seconds on


or of the rocker ß`
then release the pressure.
• If you have entered the correct code, “SAFE” will be displayed after a few
moments.
The car radio is locked again.
THEFT PROTECTION CODING
The security diode ßUflashes if the radio
is switched off and the ignition key is
removed.
›19
Incorrect code number
If you enter an incorrect code number
when attempting to deactivate the electro-
nic security system, "SAFE" appears after
about 10 seconds and then “2 – – – –”
(2nd attempt) in the display.
You may then repeat once the entire
operation. The number of attempts is
indicated in the display.
If you enter an incorrect code number
again, the radio will be locked for the
waiting times indicated in the table below.
Waiting times between attempts:
Attempt Waiting time
(display) (approximately)1 10 sec.
2 1.5 min.
3 5 min.
4 21 min.
5 1.5 hrs.
6 6 hrs.
7 24 hrs.
8 24 hrs.