2005 SKODA OCTAVIA lights

Lights and Visibility81
Using the systemSafetyDriving TipsGeneral MaintenanceBreakdown assistanceTechnical Data
Note
•Do not touch the surface of the exterior mirrors if the exterior mirror
heater is switched on.
•You can set the exterior mirrors by hand, if the power setting function
fails at any time, by pressing on the edge of the mirror surface.
•Contact your specialist garage if a fault exists with the power setting of
the exterior mirrors.
Automatic dimming exterior mirror*
The exterior mirrors are dimmed together with the automatic dimming inte-
rior mirror. If the automatic dimming is switched on, the mirror dims auto-
matically depending on the light striking the mirror from the rear.
When the interior lights are switched on or the reverse gear is engaged,
the mirror always moves back into the basic position (not dimmed).
Note
•Automatic mirror dimming operates only properly if the sun screen* for
the rear window is not in use or the light striking the rear of the interior
rear-view mirror is not affected by other objects.
•Do not affix any stickers in front of the light sensor, so that you do not
impair the automatic dimming function or put it out of operation.
•If you switch off the automatic dimming interior rear-view mirror, also
the exterior mirror dimming is switched off.
s24s.book Page 81 Thursday, November 24, 2005 12:27 PM

Heating and air conditioning system 121
Using the systemSafetyDriving TipsGeneral MaintenanceBreakdown assistanceTechnical Data
Fresh air mode - ventilation
Non pre-warmed fresh air streams through the air inlet nozzles
3 and 4 for
the following settings.
Recirculated air mode must not be switched on.
•Turn the control dial ⇒p a g e 11 9 , f i g . 11 6 to the left up to the stop
•Blower switch in the desired position
•Turn the air distribution control into the position 
•Open air outlet vents 3 and 4 ⇒ page 122, fig. 117
The control dial can be set to other positions as required.
Recirculated air mode
In recirculated air mode air is sucked out of the interior of
the vehicle and then fed back into the interior.
Recirculated air mode prevents polluted air outside the vehicle
from getting into the vehicle, for example when driving through a
tunnel or when standing in a traffic jam.
Switching recirculated air mode on
– Press the button - the warning light lights up in the button ⇒page 119, fig. 116 .
Switching recirculated air mode off
– Press again the button - the warning light in the button goes out.
The recirculated air mode is switched off automatically if the air distribu-
tion control is in position  ⇒ page 119, fig. 116 . You can also switch recirculated air mode on again from this setting by repeatedly pressing
button .
WARNING
You should not leave recirculated air mode on over a longer period
of time. “Stale air” may result in
fatigue in the driver and passen-
gers, reduce attention levels and also cause the windows to mist
up. The risk of having an accident increases. Switch recirculated
air mode off as soon as the windows begin misting up.AA
AB
AC
AC


AC

s24s.book Page 121 Thursday, November 24, 2005 12:27 PM

Heating and air conditioning system
124
Using the system
Fig. 119 Climatic: Controls
Setting temperature
– Turn the control dial ⇒fig. 119 to the right in order to
increase the temperature.
– Turn the control dial to the left in order to increase the temperature.
Controlling blower
– Turn the blower switch into one of the positions, 1 to 4, in order to switch the blower on.
– Turn the blower switch into position 0 in order to switch the blower off.
– Pressing button - causes the recirculating air system ⇒page 126 to be switched on. Control for air distribution
– You can adjust the direction of the inlet air flow
⇒page 127
using air distribution regulator .
switching cooling on and off
– Press the button ⇒fig. 119 . The warning light lights up
in the button.
– When you again press the switch , the cooling system is switched off. The warning light in the button goes out.
Rear window heater
– Press button . Further information ⇒page 72.
Auxiliary heating
– Press the button in order to directly switch on/off the auxiliary heating (auxiliary heating and ventilation. Further
information ⇒page 134, “Auxiliary heating (auxiliary heating
and ventilation)*”.
The set temperature will be automatically maintained other than
when the control dial is on the extreme right or extreme left position:
Extreme right position - full heating
Extreme left position - full cooling
The blower should aways be on to prevent the windows from misting up.
Note
•The whole heat output will be needed to unfrost the windscreen and
side windows. No warm air will be fed to the footwell. This can lead to
restriction of the heating comfort.
AA
AA
AB
AB
A3
AC
ACA1
AC
A2
A4
s24s.book Page 124 Thursday, November 24, 2005 12:27 PM

Heating and air conditioning system
126
•Control dial in the position 4, supplies the interior of the car with
fresh air.
•After brief airing, turn the control dial to the position 2 or 3
•Turn the air distribution control into the position 
•Open the air outlet vents 3 and 4
•Switch on the cooling system by pressing button
•We recommend briefly pressing button air recirculation mode.
Optimum cooling
•Control dial at the desired heat temperature. This temperature will
be maintained automatically.
•Blower switch in position 1, 2 , or 3
•Turn the air distribution control into the position 
•Open the air outlet vents 3 and 4
•Switch on the cooling system by pressing button
•We recommend setting the air outlet vents 3 and 4 in such a way that
the air flows to the rear over the heads of the occupants. Do not switch to
recirculated air mode.
Fresh air mode - ventilation
Non pre-warmed fresh air streams through the air inlet nozzles 3 and 4 for
the following settings.
•Turn the control dial ⇒page 124, fig. 119 to the left up to the stop
•Blower switch in the desired position
•Turn the air distribution control into the position 
•Open air outlet vents 3 and 4 ⇒ page 127, fig. 120
•Switch off the cooling by pressing button
•Switch off the recirculated air mode by pressing button
The control dial can be set to other positions as required.
Recirculated air mode
In recirculated air mode air is sucked out of the interior of
the vehicle and then fed back into the interior.
Recirculated air mode prevents polluted air outside the vehicle
from getting into the vehicle, for example when driving through a
tunnel or when standing in a traffic jam.
Switching recirculated air mode on
– Press the button ⇒page 124, fig. 119 - the warning light
lights up in the button.
Switching recirculated air mode off
– Press again the button - the warning light in the button goes out.
Recirculated air mode is switched off automatically if the air distribution
control is in position  ⇒ page 124, fig. 119 . You can also switch recir-
culated air mode on again from this setting by repeatedly pressing button
.
WARNING
You should not leave recirculated air mode on over a longer period
of time. “Stale air” may result in fatigue in the driver and passen-
gers, reduce attention levels and also cause the windows to mist
up. The risk of having an accident increases. Switch recirculated
air mode off as soon as the windows begin misting up.
AB
AB
AC
A1
A3
AA
AB
AC
A1
AA
AB
AC
A1
A3
AC


AC

s24s.book Page 126 Thursday, November 24, 2005 12:27 PM

Heating and air conditioning system 131
Using the systemSafetyDriving TipsGeneral MaintenanceBreakdown assistanceTechnical Data
– Press the button - the warning light lights up in the
button.
The automatic mode is switched off by pressing the button for the air distri-
bution or increasing or decreasing the blower speed. The temperature is
nevertheless regulated.
ECON mode
The cooling system is switched off in the ECON mode -
heating and ventilation are regulated automatically.
Switching ECON mode on
– Press the button - the warning light lights up in the button.
– Set a temperature between +16 °C (60 °F) and +29,5 °C (85 °F).
Recirculated air mode in ECON mode
– First of all press the button - the warning light lights up in the button.
– Then press the button - the warning light lights up in the button.
ECON mode operates only within the control temperature range from +16
°C (60 °F) up to +29.5 °C (85 °F).
The ECON mode is switched off when pressing button or . Please note that, in the ECON mode, the interior temperature cannot be
lower than the outside temperature. The interior is not cooled and the air
is not dehumidified.
If you select the temperature below +16 °C (60°F),
LO appears on the
display. If you select a temperature higher than +29.5 °C (85 °F), HI
appears on the display. In the position LO the supplied air is not warmed
up. In the HI position, the system operates continuously with maximum
heating capacity.
Please refer to the information regarding recirculated air mode
⇒ page 132.
Defrosting windscreen
Defrosting windscreen - switching on
– Press the button ⇒page 130, fig. 122 .
Defrosting windscreen - switching off
– Once again press the button or the button .
The temperature control is controlled automatically. More air flows out of
the air outlet vents 1 and 2.
AUTO
ECON

ECON


AUTO
s24s.book Page 131 Thursday, November 24, 2005 12:27 PM

Heating and air conditioning system
132
Recirculated air mode
In recirculated air mode air is sucked out of the interior of
the vehicle and then fed back into the interior.
Recirculated air mode prevents polluted air outside the vehicle
from getting into the vehicle, for example when driving through a
tunnel or when standing in a traffic jam.
Switching recircul ated air mode on
– Press the button - the warning light lights up in the button.
Switching recirculat ed air mode off
– Press again the button or the button - the warning light in the button goes out.
WARNING
You should not leave recirculated air mode on over a longer period
of time. “Stale air” may result in fatigue in the driver and passen-
gers, reduce attention levels and also cause the windows to mist
up. The risk of having an accident increases. Switch recirculated
air mode off as soon as the windows begin misting up.
Note
If the windscreen mists up, press the button ⇒page 130, fig. 122 .
After the windscreen has been demisted, press the button .
Setting temperature
You can separate the interior temperature for the left and right
side separately.
– You can set the temperature for both sides after switching on the ignition with the control dial .
– If you wish to set the temperature for the right side, turn the control dial .
If the temperature for the right side was set via the control dial , it can
no longer be set via the control dial - temperature for both sides. This
is only possible if you press the button for about 2 seconds.
You can set the interior temperature between +16 °C (60 °F) and +29.5
°C (85 °F). The interior temperature is regulated automatically within this
range. If you select the temperature below +16 °C (60 °F), “LO” appears
in the display. If you select the temperature higher than +29.5 °C (85 °F),
“HI” appears in the display. In both limit positions the Climatronic operates
at maximum cooling or heating capacity, respectively. The temperature is
not controlled in this case.
Lengthy and uneven distribution of the air flow out of the vents (in partic-
ular at the leg area) and large differences in temperature, for example
when getting out of the vehicle, can result in chills in sensitive persons.
Controlling blower
There are a total of seven blower stages available.
The Climatronic system controls the blower stages automatically
in line with the interior temperature. You can also, however,
adapt the blower stages manually to suit your particular needs.

AUTO
A9AUTO
A7
A11
A11A7AUTO
s24s.book Page 132 Thursday, November 24, 2005 12:27 PM

Heating and air conditioning system 133
Using the systemSafetyDriving TipsGeneral MaintenanceBreakdown assistanceTechnical Data
– Turn the control dial ⇒page 130, fig. 122 to the left (reduce
blower speed) or right (increase blower speed).
Switch off the blowers, the Climatronic is switched off and on the displays
appears OFF.
The set blower speed is displayed above the control dial when the
respective number of warning lights come on.
WARNING
•The “stale” air may result in fatigue, divert your attention and
also cause the windows to mist up. The risk of having an accident
increases.
•Do not switch the Climatronic system off for longer than neces-
sary.
•Switch the Climatronic system on as soon as the windows mist
up.
Air outlet vents
Fig. 123 Air vents at the front
Fig. 124 Air vents at the rear
Open air outlet vents
– Turn the vertical thumbwheel (not when in the end position).
A10
A10
s24s.book Page 133 Thursday, November 24, 2005 12:27 PM

Heating and air conditioning system
136
The last programmed pre-set time remains active.
The active pre-set time can be changed in the menu Aux. Heating in the
menu Activation by selecting a pre-set time.
The prerequisite for the correct switching on of the auxiliary heating (auxil-
iary heating and ventilation) according to the programmed pre-set time is
the correct setting of the current time ⇒page 17 and weekday ⇒ page 135.
If the system is running, a warning light in the button for direct switching
on/off of the auxiliary heating lights up.
The running system deactivates after expiration of the operating period or
is deactivated earlier by pressing the button for direct switching on/off of
the auxiliary heating ⇒page 136.
The deactivation of a desired pre-set time can be performed by selecting
the menu Deactive in the menu Active .
It is possible to re-establish the factory setting using the menu Factory
setting in the menu Aux. Heating .Direct switching on/off
Fig. 126 Button for direct switching on/off of the auxiliary heating (auxiliary
heating and ventilation) on the operating part of the Climatic
The auxiliary heating (auxiliary heating and ventilation) can be switched
on or off at any time directly using the button on the operating part of
the Climatic ⇒fig. 126 , if necessary the operating part of the heating
⇒ page 119, fig. 116 or the operating part of the Climatronic ⇒page 130,
fig. 122 .
The auxiliary heating system (auxiliary heating and ventilation) switches
off automatically after expiration of the set operating period in the menu
Running time , if it is not switched off beforehand by you.
WARNING
•The auxiliary heating must never be operated in closed rooms -
risk of poisoning!
•The auxiliary heating must not be running during refueling - risk
of fire.



s24s.book Page 136 Thursday, November 24, 2005 12:27 PM