Page 9 of 444
Power Seat
If the vehicle has this feature, the control is located on
the outboard side of the driver’s seat.
To adjust the seat do the following:
Move the seat forward or rearward by sliding the
control toward the front or rear of the vehicle.
Raise or lower the seat cushion by sliding the
control up or down.
Raise or lower the front portion of the seat by
sliding the front part of the control up or down.
Raise or lower the rear portion of the seat by sliding
the rear part of the control up or down.
Power Lumbar
If the vehicle has this feature, the power lumber control
lets the driver adjust the amount and position of the
support in the lower seatback.
The four-way control is
located on the outboard
side of the driver’s
seat cushion.
To increase or decrease lumbar support, press and
hold the front or rear of the control. To raise or lower
the lumbar support, press and hold the top or bottom
of the control.
1-3
Page 10 of 444

Heated Seats
If the vehicle has this
feature, the buttons to
activate the heat on each
front seat cushion are
located on the climate
control panel.
The button for the driver’s seat is located on the bottom
left side of the climate control panel. The button for
the passenger’s seat is on the bottom right of the climate
control panel.
Push the button once to activate a high heat setting.
Both indicator lights next to the button will come
on. Push the button again to select a lower temperature
setting. Only the bottom indicator light will come on.
Press the button a third time to turn the heat off.
This feature only works when the ignition is turned on.
Reclining Seatbacks
The recliner levers for the driver’s and passenger’s front
seatbacks are located on the outboard side of each
front seat cushion.
Lift the lever to release the seatback, then move the
seatback to the desired position. Release the lever
to lock the seatback in place. Pull up on the lever
without pushing on the seatback, and the seatback will
return to an upright position.
1-4
Page 11 of 444
But do not have a seatback reclined if the vehicle
is moving.
{CAUTION:
Sitting in a reclined position when your vehicle
is in motion can be dangerous. Even if you
buckle up, your safety belts can not do their
job when you are reclined like this.
The shoulder belt can not do its job because it
will not be against your body. Instead, it will be
in front of you. In a crash you could go into it,
receiving neck or other injuries.
The lap belt can not do its job either. In a
crash the belt could go up over your abdomen.
The belt forces would be there, not at your
pelvic bones. This could cause serious internal
injuries.
For proper protection when the vehicle is in
motion, have the seatback upright. Then sit
well back in the seat and wear your safety
belt properly.
1-5
Page 12 of 444
Head Restraints
Push the release button, located under the head
restraint to slide it up or down. Adjust the head restraint
so that the top of the restraint is closest to the top of
the occupant’s head in each front seat. This position
reduces the chance of a neck injury in a crash.
Passenger Folding Seatback
{CAUTION:
If you fold the seatback forward to carry longer
objects, such as skis, be sure any such cargo
is not near an airbag. In a crash, an in ating
airbag might force that object toward a person.
This could cause severe injury or even death.
Secure objects away from the area in which
an airbag would in ate. For more information,
seeWhere Are the Airbags? on page 1-50and
Loading Your Vehicle on page 4-33.
1-6
Page 13 of 444
{CAUTION:
Things you put on this seatback can strike
and injure people in a sudden stop or turn,
or in a crash. Remove or secure all items
before driving.
If the vehicle has this feature, the front passenger seat
can be folded at for more cargo space. Used with
the split folding rear seat, additional cargo space
is gained. SeeSplit Folding Rear Seat on page 1-8.
To fold the front passenger seat at, pull up on the lever
located in the middle of the seatback. Lift up on the
seatback and push it forward to lock it in place.
To unlock the seat and return it to the normal seating
position, pull the lever in the middle of the seatback
and raise the seatback.
Push and pull on the seatback to make sure it is locked.
1-7
Page 14 of 444
Rear Seats
Split Folding Rear Seat
Both sides of the rear seatback can be folded down in
the vehicle. Make sure the front seat is not reclined.
If it is, the rear seatback may not fold down all the way.
To lower the rear seatback, follow these steps:
1. Disconnect the rear center lap-shoulder belt latch
by using a pointed object to press the release
button.2. Pull forward on the
seatback tab located
on the outboard
side of the rear seat
cushion to fold
the seatback down.
This gives direct access to the trunk.
{CAUTION:
If the seatback is not locked, it could move
forward in a sudden stop or crash. That could
cause injury to the person sitting there. Always
press rearward on the seatback to be sure it
is locked.
1-8
Page 15 of 444
{CAUTION:
A safety belt that is improperly routed, not
properly attached, or twisted will not provide
the protection needed in a crash. The person
wearing the belt could be seriously injured.
After raising the rear seatback, always check
to be sure that the safety belts are properly
routed and attached, and are not twisted.
To raise the rear seatback, follow these steps:
1. Raise the seatback up and make sure it latches.
Push and pull on the seatback to be sure it is
locked in position.2. Reconnect the center
safety belt latch plate
to the buckle.
Make sure the safety belt label is pointing to the
release button, and that both are facing the front of
the vehicle. Make sure the belt is not twisted. Push
and pull on the latch plate to be sure it is secure.
When the seat is not in use, the seatback should be
kept in the upright, locked position.
1-9
Page 16 of 444

Safety Belts
Safety Belts: They Are for Everyone
This part of the manual tells you how to use safety
belts properly. It also tells you some things you should
not do with safety belts.
{CAUTION:
Do not let anyone ride where he or she can
not wear a safety belt properly. If you are in a
crash and you are not wearing a safety belt,
your injuries can be much worse. You can hit
things inside the vehicle or be ejected from it.
You can be seriously injured or killed. In the
same crash, you might not be, if you are
buckled up. Always fasten your safety belt,
and check that your passengers’ belts are
fastened properly too.
{CAUTION:
It is extremely dangerous to ride in a cargo
area, inside or outside of a vehicle. In a
collision, people riding in these areas are more
likely to be seriously injured or killed. Do not
allow people to ride in any area of your vehicle
that is not equipped with seats and safety
belts. Be sure everyone in your vehicle is in a
seat and using a safety belt properly.
Your vehicle has a light
that comes on as a
reminder to buckle up.
SeeSafety Belt Reminder
Light on page 3-38.
In most states and in all Canadian provinces, the law
says to wear safety belts. Here is why:They work.
1-10