ENGINE – SPECIAL TOOLS11 - 2
Special tools
ToolNumber NameFunction
MB991502MUT-II Sub
ASSYChecking and adjusting the tension in
timing belt B
Note
If a MUT-III main harness A is
connected to a vehicle not fitted with
CAN, there is a chance that a pulse
signal will be entered in the simulated
vehicle speed line, when the MUT-III is
activated. Therefore, use a MUT-III main
harness B with vehicles not fitted with
CAN.
MB991955
A: MB991824
B: MB991827
C: MB991910
D: MB991911
E: MB991825
F: MB991826MUT-III Sub ASSY
A: Vehicle
Communication
Interface (VCI)
B: USB cable
C: MUT-III Main
harness A
(For vehicles
fitted with CAN)
D: MUT-III Main
harness B
(For vehicles
not fitted with
CAN)
E: Adaptor
F: Trigger harness
MB991668
A: MB991969
B: MB991670Belt tension meter
set
A: Tension meter
cartridge
B: Mic ASSY• Checking the tension in the drive belt.
(Use in conjunction with VCI)
• Checking the tension in the balancer
timing belt.
Adjusting (Use in conjunction with VCI)
MD998772Valve spring
compressorCompression of the valve spring.
DO NOT USE
MPI – SERVICING STANDARDS, SPECIAL TOOLS
13A-3
Servicing standards
Special tools
ItemStandard level
Revolutions when idling r/min800 ± 50
Air temperature sensor resistance kΩat -20 ºC13~18
at 0 ºC5.1~6.9
at 20 ºC2.0~3.0
at 40 ºC0.9~1.5
at 60 ºC0.40~0.78
at 80 ºC0.23~0.42
Oil feeder control valve resistance (at 20 ºC) Ω6.9~7.9
ToolNumberNameFunction
MB991502MUT-II sub ASSYChecking the MPI system
MB991955
A:MB991824
B:MB991827
C:MB991910
D:MB991911
E:MB991825
F:MB991826MUT-III sub ASSY
A: Vehicle Communication
Interface (V.C.I..)
B: USB cable
C: MUT-III Main harness A
(For vehicles fitted with
CAN)
D: MUT-III Main harness B
(For vehicles not fitted with
CAN)
E: Adaptor
F: Trigger harnessNote
If a MUT-III main harness A is connected to
a vehicle not fitted with CAN, there is a
chance that a pulse signal will be entered
in the simulated vehicle speed line, when
the MUT-III is activated. Therefore, use a
MUT-III main harness B with vehicles not
fitted with CAN.
DO NOT USE
