2005 MITSUBISHI LANCER EVOLUTION IX wiring diagram

GENERAL INFORMATION - HOW TO READ THE WIRING DIAGRAMS 0-6
Connector / Earth Markings
The circuits contain a large number of connectors and earths, and the following system has been adopted for depicting
connectors and earths in the circuit diagrams.
Ignition switchFusible link
Solenoid
valve
Inspection connector
MotorSensor

GENERAL INFORMATION - HOW TO READ THE WIRING DIAGRAMS0-7
ItemNoConnector / EarthSymbolDetails
Terminals and
connectors-Different terminal symbols are
used to indicate male terminals,
which are inserted into another
terminal, and female terminals,
which receive other terminal. A
connector containing male
terminals is called a male
connector, and a connector
containing female connectors is
called a female connector. The
connector symbol for a male
connector has a two-line outline,
whereas the symbol for a female
connector has a single-line outline,
in order to distinguish them in the
diagrams.
Connector
symbols1The symbol shows the connector
used in the actual vehicle, as
viewed from the direction of the
illustration. At the connection with
the device, the connector symbol
on the device side, and the
intermediate connector are shown
by male connector symbols.
Spare connectors and inspection
connectors are not connected to
the device, and therefore, these
are represented by a harness side
connector symbol. Note, however,
that the above does not apply to
diagnosis connectors.
2
3
Male connector
Male connector Male
terminal
Female
terminal
Device
Intermediate connector
Spare connector / Inspection connectorMale
terminal
Female
terminal

GENERAL INFORMATION - HOW TO READ THE WIRING DIAGRAMS0-9
If a cable has two colours, the first colour code indicates the standard colour (the basic colour of the cable coating), and the
second colour code indicates the marking colour.
Note :
• * : No indication : 0.5 mm2.
Cable colour in brackets indicates 0.3 mm2.
Abbreviation Symbols
The abbreviation symbols used in the wiring diagrams have the following meanings.
1. Abbreviations of System Names
Wire Colour Codes
The different wire colours are indicated by the following letter codes.
Example
M3000011000154
--

GENERAL INFORMATION - HOW TO READ THE WIRING DIAGRAMS0-10
2. Abbreviations used in internal circuits of combination meter
3. Abbreviations used in switch and relay circuits

GENERAL INFORMATION - HOW TO READ THE WIRING DIAGRAMS0-11
4. Other abbreviations

LAYOUT DIAGRAMS - GENERAL LAYOUT DIAGRAM1-3
Front
harness (RH)Control panelInstrument
panel harnessRoof harness
Floor harness (RH)
Battery
harness
Front harness (LH)
Front door
harness *Floor
harness (LH)Fuel harnessRear door harness *
Note :
1. This diagram shows the main wiring harnesses only.
2. The * symbol indicates that the harness is also fitted on the right-hand side.
General Layout Diagram