2005 MERCEDES-BENZ CLK500 CABRIOLET oil level

343 Operation
Maintenance
Clearing the maintenance service indicator
The maintenance service indicator is
automatically cleared

after 30 seconds when you switch on
the ignition or when reaching the main-
tenance service threshold while driving


after 30 seconds, once the suggested
maintenance service term has passed
You can also clear it yourself.
1Reset button

Press reset button 1 on the
instrument cluster.
Maintenance service term exceeded
If you have exceeded the suggested
maintenance service term, you will see the
following message in the multifunction
display:Service A exceeded by XXXXX miles
(km)
Service A exceeded by XXX days
Service A exceeded by X dayIn addition, a signal sounds when the
message appears.
Any authorized Mercedes-Benz Center will
reset the maintenance service indicator
following a completed maintenance
service.Calling up the maintenance service
indicator
Switch on the ignition (
page 36).
The standard display of the control sys-
tem appears (
page 133).

Press buttonkorjon the mul-
tifunction steering wheel until the
maintenance service indicator with the
service symbol9or´and the
service deadline appears in the
multifunction display.iIf the battery is disconnected, the days
of disconnection will not be included in
the count shown by the maintenance
service indicator. To arrive at the true
maintenance service deadline, you will
need to subtract these days from the
days shown in the maintenance service
indicator.
Do not confuse the maintenance
service indicator with the engine oil
level indicator :.

380 Practical hintsWhat to do if …?Display symbol
Display message
Possible cause
Possible solution
:
USA only:Add 1 qt. engine oil
at next refuelingCanada only:Add 1 liter engine oil
at next refueling
The engine oil level is too low.

Add engine oil (
page 309) and check
the engine oil level (
page 307).
Engine oil level
Reduce oil level!
You have added too much engine oil.
There is a risk of damaging the engine or
the catalytic converter.

Have oil siphoned or drained off. Ob-
serve all legal requirements with re-
spect to its disposal.
Engine oil level
Stop, engine off!
There is no oil in the engine. There is a
danger of engine damage.

Carefully bring the vehicle to a halt as
soon as possible.

Turn off the engine.

Add engine oil (
page 309) and check
the engine oil level (
page 307).

381 Practical hints
What to do if …?
When the message
Add 1 qt. engine oil
at next refueling (Canada:
1 liter
) ap-
pears while the engine is running and at
operating temperature, the engine oil level
has dropped to approximately the
minimum level.When this occurs, the warning will first
come on intermittently and then stay on if
the oil level drops further.
Visually check for oil leaks. If no obvious oil
leaks are noted, drive to the nearest ser-
vice station where the engine oil should be
topped to the required level with an
approved oil specified in the Factory
Approved Service Products pamphlet.
Display symbol
Display message
Possible cause
Possible solution
:
Engine oil
Visit workshop!
It may be that there is water in the engine
oil.

Have the engine oil checked.
Engine oil level
Visit workshop!
The engine oil has dropped to a critical
level.

Check the engine oil level
(page 307) and add oil as required
(page 309).

If you must add engine oil frequently,
have the engine checked for possible
leaks.
The measuring system is malfunctioning.

Have the measuring system checked
by an authorized Mercedes-Benz
Center.!The engine oil level warnings should
not be ignored. Extended driving with
the symbol displayed could result in
serious engine damage that is not
covered by the Mercedes-Benz Limited
Warranty.

389 Practical hints
What to do if …?
Display symbol
Display message
Possible cause
Possible solution
K
Lock top
The soft top is not properly locked.

Lock the soft top again (
page 250).
Top being opened
The soft top is not completely open or
closed. The hydraulics are losing pres-
sure.

Open or close the soft top all the way.
Top
Visit workshop!
The soft top is malfunctioning.

Have the system checked at an autho-
rized Mercedes-Benz Center as soon
as possible.
Start engine to
operate top
The on-board voltage is too low.

Start the engine.
Top locked
as vehicle is moving
You have attempted to open or close the
soft top while driving.

Pull over to the side of the road and re-
peat soft top operation while the vehi-
cle is stationary.
_
Steering oil
Visit workshop!
The steering gear oil level is too low. There
is a danger of steering gear damage.

Have the system checked by an autho-
rized Mercedes-Benz Center.
Warning!
G
If the level of steering gear oil in reservoir is
too low, the steering power assistance could
fail. Much greater effort will then be needed
to turn the steering wheel.
Do not add steering oil without checking the
steering system.
Do not drive the vehicle. Have the system
checked at an authorized Mercedes-Benz
Center as soon as possible.

458 Technical dataFuels, coolants, lubricants, etc.Coolants
The engine coolant is a mixture of water
and anticorrosion / antifreeze, which
provides:

Corrosion protection


Freeze protection


Boiling protection (by increasing the
boiling point)
The cooling system was filled at the factory
with a coolant providing freeze protection
to approximately -22°F (-30°C) and
corrosion protection.
If the antifreeze mixture is effective
to -22°F (-30°C), the boiling point of the
coolant in the pressurized cooling system
is reached at approx. 266°F (130°C).The coolant solution must be used
year-round to provide the necessary corro-
sion protection and increase boil-over pro-
tection. Refer to Maintenance Booklet for
replacement interval.
Coolant system design and coolant used
determine the replacement interval. The
replacement interval published in the
Maintenance Booklet is only applicable if
MB 325.0 Anticorrosion/Antifreeze solu-
tion or other Mercedes-Benz approved
products of equal specification (see Facto-
ry Approved Service Products pamphlet)
are used to renew the coolant concentra-
tion or bring it back up to the proper level.To provide important corrosion protection,
the solution must be at least 45% anticor-
rosion/antifreeze (equivalent to freeze
protection to approx. -22°F [-30°C]). If you
use a solution that is more than 55% anti-
corrosion/antifreeze (freeze protection to
approx. -49°F [-45°C]), the engine temper-
ature will increase due to the lower heat
transfer capability of the solution. There-
fore, do not use more than this amount of
anticorrosion/antifreeze.
If the coolant level is low, water and MB
Anticorrosion /Antifreeze should be used
to bring it up to the proper level (have cool-
ing system checked for signs of leakage).
Please make sure the mixture is in accor-
dance with label instructions.
The water in the cooling system must meet
minimum requirements, which are usually
satisfied by normal drinking water. If you
are not sure about the water quality,
consult an authorized Mercedes-Benz
Center.

462 Technical termsCruise control
Driving convenience system for auto-
matically maintaining the vehicle speed
set by the driver.
Curb weight
(
page 336)
DOT
(Department O
f Transportation)
(
page 336)
Engine number
The number set by the manufacturer
and placed on the cylinder block to
uniquely identify each engine pro-
duced.
Engine oil viscosity
Measurement for the inner friction (vis-
cosity) of the oil at different tempera-
tures. The higher the temperature an
oil can tolerate without becoming thin,
or the lower the temperature it can tol-
erate without becoming viscous, the
better the viscosity.ESP
(E
lectronic S
tability Pr
ogram)
Improves vehicle handling and direc-
tional stability.
ETD
(E
mergency T
ensioning D
evice)
Device which deploys in certain frontal
and rear collisions exceeding the sys-
tem's threshold to tighten the seat
belts.
->SRS
FSS (Canada vehicles)
(F
lexible S
ervice S
ystem)
Maintenance service indicator in the
multifunction display that informs the
driver when the next vehicle mainte-
nance service is due. FSS evaluates en-
gine temperature, oil level, vehicle
speed, engine speed, distance driven
and the time elapsed since your last
maintenance service, and calls for the
next maintenance service accordingly.GAWR
(G
ross A
xle W
eight R
ating)
(
page 336)
Gear range
Number of gears which are available to
the automatic transmission for shifting.
The automatic gear shifting process
can be adapted to specific operating
conditions using the gear selector le-
ver.
GPS
(Global P
ositioning S
ystem)
Satellite-based system for relaying
geographic location information to and
from vehicles equipped with special re-
ceivers. Employs CD digital maps for
navigation.
GVW
(G
ross V
ehicle W
eight)
(
page 336)
GVWR
(Gross V
ehicle W
eight R
ating)
(
page 336)

471 Index
Central locking
Automatic 110
From inside 110
Locking from inside 110
Switch 110
Switching on/off
(control system) 155
Unlocking from inside 110
Central locking switch 110
Certification label 442
Changing
CDs 218
Key setting 156
Charcoal filter 197
Activating 197
Deactivating 197
Charging
Vehicle battery 428
CHECK ENGINE
malfunction indicator lamp 356
Checking
Coolant level 310
Oil level 304, 307
Tire inflate pressure 304
Vehicle lighting 304Child safety 72
Air bags 62
Front passenger front
air bag off indicator lamp 79
Infant and child
restraint systems 67, 72
LATCH child seat anchors 80
OCS 75
Child safety switch see
Blocking of rear window operation
Child seat anchors see
LATCH child seat anchors
Cigarette lighter 274Cleaning 345
Cup holder 351
Gear selector lever 351
Hard plastic trim items 351
Headlamps 176
Headliner 351
Instrument cluster 351
Leather upholstery 352
Light alloy wheels 350
Nubuck leather upholstery
(CLK 55 AMG) 352
Parktronic system* sensor 349
Plastic and rubber parts 352
Seat belts 351
Soft top 347
Steering wheel 351
Upholstery 352
Windows 350
Windshield 53
Wiper blades 349
Wood trims 352
Cleaning and care of vehicle 345
Cleaning tires 315
Climate control 180
Clock 25, 148

475 Index
E
Easy-entry/exit feature 112
Activating 156
Electrical fuses 436
Electrical outlet in
rear passenger compartment 275
Electrical system
Technical data 450
Electronic Stability Program see ESP
Emergency call
911 237
Emergency call system* 277
Emergency calls
Initiating an emergency call 279
With Tele Aid 278
Emergency operation
(Limp Home Mode) 175
Emergency operations
Closing soft top 403
Locking the vehicle 398
Remote door unlock 283
Unlocking the vehicle 397
Emergency tensioning device see ETD
Emission control 300
Emission control information label 442Ending
A call (telephone*) 161
Engine
Compartment 305
Message in display 356
Starting 47
Starting with KEYLESS-GO* 47
Starting with the SmartKey 47
Technical data 444
Turning off 56
Engine cleaning 347
Engine compartment 305
Fuse box in 437
Hood 305
Engine malfunction
indicator lamp 25, 356
Engine number 442, 462Engine oil 306, 455
Adding 309
Additives 455
Checking level 307
Consumption 306
Filler cap 309
Filler neck 309
Message in display 380
Messages in display 308
Viscosity 462
Engine oil level see Oil level
ESP 25, 86, 462
Messages in display 368
Switching off 87
Switching on 88
Warning lamp 358
ETD 462
Safety guidelines 64
ETD (Emergency tensioning device) 70
Exterior lamp switch 122
Exterior rear view mirrors
Adjusting 41
Parking position for 157