Page 17 of 442

15 Introduction
Symbols
Symbols
The following symbols are found in this 
Operator’s Manual:
* Optional equipment is identified 
with an asterisk. Since standard 
equipment varies between models, 
the descriptions and illustrations in 
this manual may differ slightly from 
the actual equipment of your vehi-
cle.
This symbol points to instructions for 
you to follow. 
A number of these symbols appearing 
in succession indicates a multiple-step 
procedure.
 Page This symbol tells you where to 
look for further information on a 
topic.
This continuation symbol marks 
an interrupted procedure which 
will be continued on the next 
page.
-> In the glossary of technical 
terms, this symbol is used to 
indicate cross-references to 
term definitions. 
Display
Words appearing in the multi-
function display are printed in 
the type shown here.
Warning!
G
Warning notices draw your attention to haz-
ards that may endanger your health or life, 
or the health or life of others.!Highlights hazards that may result in 
damage to your vehicle.iHelpful hints or further information you 
may find useful. 
     
        
        Page 112 of 442

110 Controls in detailLightingManual headlamp mode
The low beam headlamps and the parking 
lamps can be switched on and off with the 
exterior lamp switch.
Automatic headlamp mode
The following lamps switch on and off 
automatically depending on the brightness 
of the ambient light:
Low beam headlamps
Tail and parking lamps
License plate lamps
Side marker lamps
Turn the exterior lamp switch to 
positionU.
With the SmartKey in starter switch 
position1, only the parking lamps will 
switch on and off automatically.
When the engine is running, the low 
beam headlamps, the tail and parking 
lamps, the license plate lamps, and the 
side marker lamps will switch on and 
off automatically.
iWith the SmartKey removed from the 
starter switch and the driver’s door 
open, a warning sounds if the parking 
lamps or low beam headlamps are 
switched on.
The message 
Switch off lights.
 
appears in the multifunction display
Warning!
G
If the exterior lamp switch is set toU,
the headlamps may switch off unexpect-
edly when the system senses bright 
ambient light, for example light from 
oncoming traffic.
the headlamps will not be automatically 
switched on under foggy conditions. 
To minimize risk to you and to others, 
activate headlamps by turning exterior lamp 
switch toB when driving or when traffic 
and / or ambient lighting conditions require 
you to do so.
In low ambient lighting conditions, only 
switch from positionU toB with the 
vehicle at a standstill. Switching fromU 
toB will briefly switch off the 
headlamps. Doing so while driving in low 
ambient lighting conditions may result in an 
accident.
The automatic headlamp feature is only an 
aid to the driver. The driver is responsible for 
the operation of the vehicle's lights at all 
times. 
     
        
        Page 117 of 442

115 Controls in detail
Lighting
Interior lighting
The controls are located in the overhead 
control panel.
1Rear interior lights
2Right front reading lamp
3Rocker switch for automatic control 
system
4Left front reading lampActivating automatic control
Press rocker switch3 to center 
position.
Interior lamps are switched on in 
darkness, even when you:
unlock the vehicle
open a door
remove the SmartKey from the 
starter switch
The interior lamps are switched off after a 
preset time, see “Setting interior lighting 
delayed shut-off” (
page 145).Deactivating automatic control
Press the= symbol on rocker 
switch3.
The interior lighting remains switched 
off, even when you:
unlock the vehicle
open a door 
remove the SmartKey from the 
starter switch
Manual control
Switching all front interior lights on and 
off
Press theW symbol on rocker 
switch3.
The front interior lights come on.
Press rocker switch3 to center 
position to activate the automatic 
control.
iIf the door remains open, the interior 
lamps switch off automatically after 
approximately five minutes, when the 
SmartKey is removed or in starter 
switch position0.
An interior lamp switched on manually 
does not go out automatically. 
     
        
        Page 118 of 442

116 Controls in detailLightingSwitching rear interior lights on and off
Press buttonV.
The lights in the rear passenger 
compartment come on.
Press buttonV again.
The lights in the rear passenger 
compartment go out.
Switching right front reading lamp on 
and off
Press right buttonX.
The right reading lamp comes on.
Press right buttonX again.
The right reading lamp goes out.
Switching left front reading lamp on and 
off
Press left buttonX.
The left reading lamp comes on.
Press left buttonX again.
The left reading lamp goes out.
Door entry lamps
The appropriate door entry lamp switches 
on if a door is opened in darkness and if 
the interior lighting is switched to auto-
matic function.
The entry lamp switches off automatically 
when the door is closed.
Trunk lamp
The trunk lamp switches on if the trunk lid 
is opened.
If you leave the trunk open for an extended 
period of time, the trunk lamp will switch 
off automatically after approximately ten 
minutes.
iIf you turn the SmartKey in the starter 
switch to position0 and switch off the 
exterior headlamps, the door entry 
lamps will remain lit for approximately 
five minutes. 
     
        
        Page 165 of 442

163 Controls in detail
Automatic transmission*
Driving tips
Accelerator position
Your driving style influences the 
transmission’s shifting behavior:
Less throttle Earlier upshifting
More throttle  Later upshifting
Kickdown 
Use kickdown when you want maximum 
acceleration.
Press the accelerator past the point of 
resistance.
The transmission shifts into a lower 
gear.
Ease on the accelerator when you have 
reached the desired speed. 
The transmission shifts up again.Stopping
When you stop briefly, e.g. at traffic lights:
Leave the transmission in gear.
Hold the vehicle with the brake.
When you stop longer with the engine 
idling or on an uphill gradient:
Move the gear selector lever to 
positionP.
Set the parking brake.Maneuvering
When you maneuver in tight areas, 
e.g. when pulling into a parking space:
Control the vehicle speed by gradually 
releasing the brakes.
Accelerate gently.
Never abruptly step on the accelerator.
Working on the vehicleWarning!
G
When working on the vehicle, set the 
parking brake and move gear selector lever 
to positionP. Otherwise the vehicle could 
roll away. 
     
        
        Page 327 of 442

325 Practical hints
What to do if …
Display symbol
Display message
Possible cause
Possible solution
.
Low beam right
The right low beam lamp is 
malfunctioning.
Halogen headlamp:
Replace the bulb as soon as possible.
Bi-Xenon* headlamp:
Visit an authorized Mercedes-Benz 
Center as soon as possible.
Parking lamp
left front
The left front parking lamp is 
malfunctioning.
Replace the bulb as soon as possible.
Parking lamp
right front
The right front parking lamp is 
malfunctioning.
Replace the bulb as soon as possible.
Rear fog lamp
Substitute bulb on
The rear fog lamp is malfunctioning.
A substitute bulb is being used.
Replace the bulb as soon as possible.
Switch off lights.
Headlamps have been turned on with the 
driver’s door opened and the SmartKey 
removed from the starter switch.
Switch off the headlamps.
Taillamp left
Substitute bulb on
 
The left tail lamp is malfunctioning.
A substitute bulb is being used.
Replace the bulb as soon as possible.
Taillamp right
Substitute bulb on
 
The right tail lamp is malfunctioning.
A substitute bulb is being used.
Replace the bulb as soon as possible. 
     
        
        Page 346 of 442
344 Practical hintsReplacing bulbsSafe vehicle operation depends on proper 
exterior lighting and signaling. It is there-
fore essential that all bulbs and lamp 
assemblies are in good working order at all 
times.
Correct headlamp adjustment is extremely 
important. Have headlamps checked and 
readjusted at regular intervals and when a 
bulb has been replaced. See an authorized 
Mercedes-Benz Center for headlamp 
adjustment.
Bulbs
iIf the headlamps or front fog lamps are 
fogged up on the inside as a result of 
high humidity, driving the vehicle a 
distance with the lights on should clear 
up the fogging.iSubstitute bulbs will be brought into 
use when lamps malfunction. Observe 
the messages in the multifunction 
display (
page 323) 
     
        
        Page 348 of 442

346 Practical hintsReplacing bulbs
Notes on bulb replacement
Only use 12 volt bulbs of the same type 
and with the specified watt rating. 
Switch lights off before changing a bulb 
to prevent short circuits. 
Always use a clean lint-free cloth when 
handling bulbs. 
Your hands should be dry and free of oil 
and grease.
If the newly installed bulb does not 
come on, visit an authorized 
Mercedes-Benz Center.Have the LEDs and bulbs for the following 
lamps replaced by an authorized 
Mercedes-Benz Center:
Additional turn signals in the exterior 
rear view mirrors
High mounted brake lamp
Xenon* lamps
Front fog lamps
Warning!
G
Bulbs and bulb sockets can be very hot. 
Allow the lamp to cool down before 
changing a bulb.
Keep bulbs out of reach of children.
Halogen lamps contain pressurized gas. 
A bulb can explode if you
touch or move it when hot
drop the bulb
scratch the bulb
Wear eye and hand protection.
Because of high voltage in Xenon lamps, it is 
dangerous to replace the bulb or repair the 
lamp and its components. We recommend 
that you have such work done by a qualified 
technician.
iHave the headlamp adjustment 
checked regularly.