2005 LEXUS LS430 ESP

FCC ID: HYQ12BBKMADE IN JAPAN
FCC ID: NI4B11UEMADE IN JAPAN
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference,
and (2) this device must accept any interference re-
ceived, including interference that may cause unde-
sired operation.
KEYS AND DOORS
41
For vehicles sold in U.S.A.
CAUTION
Changes or modifications not expressly approved by
the party responsible for compliance could void the
user’s authority to operate the equipment.
NOTICE
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there
is no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the
interference by
one or more of the following measures:
 Reorient or relocate the receiving antenna.
 Increase the separation between the equipment and
receiver.
 Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
 Consult the dealer or an experienced radio/TV
technician for help.

KEYS AND DOORS
47
Locking with inside lock button
11L047a
 1Lock 2Unlock
Push in the lock button to lock and unlock the door.
The front doors can be opened by pulling the inside handles
even if the lock buttons are in the locked position.
CAUTION
Do not pull the inside handle of the front doors while
driving. The doors will open and an accident may occur.
Lexus strongly recommends that all children be placed
in the rear seat of the vehicle.
Closing the door with the lock button pushed in will also lock
the door. Be careful not to lock your keys in the vehicle. Doors
cannot be locked when either front door is open and the key is
in the ignition. For the vehicles equipped with the smart key
system, if you open the driver’s door to get out from the vehicle
without returning the ignition switch to the “LOCK” position,
chimes sound and the door will not lock when closing the door.
If the vehicle is subjected to a severe frontal, rear or side
impact with the ignition switch turned to the “ON” position, all
doors will unlock automatically after a few seconds.
CAUTION
Before driving, make sure the doors are closed and
locked, especially when small children are in the
vehicle. Along with the proper use of seat belts, locking
the doors helps prevent the driver and passengers from
being thrown out from the vehicle in an accident. It also
helps prevent the doors from being opened
unintentionally.

SWITCHES
64The thin heater wires on the inside of the rear window and the
heater
panels in the outside rear view mirrors will quickly clear
the surface. Keep your hands off the mirror faces when the
switch is on. An indicator light is on when the defogger is
operating.
The system will automatically shut off when the defogger has
operated about 15 minutes.
CAUTION
Since the mirror surfaces can get hot, do not touch them
when the switch is on.
If further defrosting or defogging is desired, simply actuate the
switch again. When the surface has cleared, push the switch
once again to turn the defogger off. Continuous use may cause
the battery to discharge, especially during stop− and−go
driving. The defogger is not designed to dry rain water or to
melt snow.
If the outside rear view mirrors are heavily coated with ice, use
a spray de −icer before operating the switch.
NOTICE
 When cleaning the inside of the rear window, be
careful not to scratch or damage the heater wires or
connectors.
 To prevent the battery from being discharged, turn
the switch off when the engine is not running.
POWER WINDOW SWITCHES
12L248
 1
For driver’s window
2For front passenger’s window
3For left rear window
4For right rear window
To raise or lower the windows, use the switch on each
door. The passengers’ windows can also be controlled by
the switches on the driver’s door.
The power windows work when the ignition switch is in the
“ON” position.
Retained accessory power: Even if the ignition switch is
turned to the “ACC” or “LOCK” position with all the doors
closed, the window can be operated until any of the doors is
opened (or for about 45 seconds).

SWITCHES
67
Jam protection function
During automatic raising operation, retained accessory power
raising operation or raising operation using the key from the
outside, the window stops and is lowered if something gets
caught between the window and window frame.
If the window receives a strong impact, this function may work
even if nothing is caught.
CAUTION
To avoid serious personal injury, you must do the
following.
 Before you close the power windows, always make
sure there is nobody around the power windows. You
must also make sure the heads, hands and other
parts of the bodies of all occupants are kept
completely inside the vehicle. If someone’s neck,
head or hands get caught in a closing window, it
could result in death or serious injury. When anyone
closes the power windows, make sure he or she
operates the windows safely.
 When small children are in the vehicle, never let them
use the power window switches without supervision.
Use the window lock switch to prevent them from
making unexpected use of the switches.
 Be sure to remove the ignition key or turn the ignition
switch to the “LOCK” position when you leave your
vehicle.
Never leave anyone (particularly a small child) alone
in your vehicle, especially with the ignition key still
inserted or with the ignition switch in a position other
than “LOCK”. Otherwise, he/she could use the power
window switches and get trapped in a window.
Unattended persons (particularly a small child) can
be involved in a serious accident.
 Never try jamming any part of your body to activate
the jam protection function intentionally.
 The jam protection function may not work if
something gets caught just before the window is fully
closed.

SWITCHES
69
SEAT HEATER SWITCHES
Front seat heater
12L172
1For driver’s seat 2For front passenger’s seat
The front seat heater has two switches: one marked “L”
(for the left seat) and the other marked “R” (for the right
seat).
The ignition switch must be in the “ON” position.
To use the seat heater:
1. Push the knob to pop it out.
2. Turn the knob clockwise. The indicator light turns on.
3. Adjust the knob to the desired temperature.
To turn off the seat heater, turn the knob counterclockwise until
it stops.
Push the knob into the recessed position when not in use.
Rear seat heater
12L174
 Vehicles without rear power seats
1
For left seat 2For right seat
The rear seat heater has two switches: one marked “L”
(for the left seat) and the other marked “R” (for the right
seat). Push these switches to turn the respective seat
heaters on, and push the switches again to turn them off.
The ignition switch must be in the “ON” position.
The indicator light turns on when the seat heater is operating.

GAUGES, METERS AND SERVICE REMINDER INDICATORS
100
w272
In the following cases, the master warning light flashes, a
warning tone sounds and the above message appears.
A smart key is not detected in the vehicle when you push the
ignition switch. In this case, the above message appears for
5 seconds.
 A smart key is not detected in the vehicle because someone
has taken a smart key outside of the vehicle without turning
off the ignition. At this time, the smart key sounds an alarm.
The above message turns off if you turn the ignition off or the
smart key system detects a smart key in the vehicle.
In addition to either of the above conditions, if you get out from
the vehicle, having a smart key when the ignition switch is in
the “ACC” or “ON” position and the selector lever is in a posit\
ion
other than “P”, “Shift to P Range” and “Key is not Detected”\
appear alternately.
w273
If you get out from the vehicle, having a smart key when
the ignition switch is in the “ACC” or “ON” position and
the selector lever is in a position other than “P”, the
master warning light flashes, a beep sounds inside the
vehicle and the above message appears. When you shift
the selector lever to the “P” position or start driving, the
beeping stops sounding, the above message turns off.
In addition to the above condition, if the smart key system does
not detect a smart key in the vehicle, “Shift to P Range” and
“Key is not Detected” appear alternately.
w274
If the smart key system determines that the electronic
code of the detected key does not correspond to the
registered ID when you push the ignition switch or lock
button on the outside door handle, the master warning
light flashes, a warning tone sounds and the above
message appears for 5 seconds.

INTERIOR EQUIPMENT
125
(c) Erasing the entire HomeLink\b memory
(all three programs)
To erase all previously programmed codes at one time, press
and hold down the 2 outside buttons for 20 seconds until the
indicator light flashes.
If you sell your vehicle, be sure to erase the programs stored
in the HomeLink
\b memory.
CAUTION
 When programming the HomeLink\b Universal
Transceiver, you may be operating a garage door or
other device. Make sure people and objects are out
of the way of the garage door or other device to
prevent potential harm or damage.
 Do not use this HomeLink
\b Universal Transceiver
with any garage door opener that lacks the safety
stop and reverse feature as required by federal safety
standards. (This includes any garage door opener
model manufactured before April 1, 1982.) A garage
door opener which cannot detect an object
(signaling the door to stop and reverse), does not
meet current federal safety standards. Using a
garage door opener without these features increases
risk of serious injury or death.
This device complies with Part 15 of the FCC Rules
and with RSS− 210 of the IC Rules.
Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired
operation.
WARNING: This transmitter has been tested and
complies with FCC and IC rules. Changes or
modifications not expressly approved by the party
responsible for compliance could void the user’s
authority to operate the device.

EXTERIOR EQUIPMENT
151
Never leave anyone (particularly a small child) alone
in your vehicle, especially with the ignition key still
inserted or with the ignition switch in a position other
than “LOCK”. Otherwise, he/she could use the moon
roof switches and get trapped in the roof opening.
Unattended persons (particularly a small child) can
be involved in a serious accident.
 Never sit on top of the vehicle around the roof
opening.
 Never try jamming any part of your body to activate
the jam protection function intentionally.
 The jam protection function may not work if
something gets caught just before the moon roof is
fully closed.