Page 495 of 539

6 OWNER MAINTENANCE
18
!
Transmission Fluid Capacity The fluid capacity of the automatic transmission is 10.5 litres (Petrol En- gine)/ 11.8 litres (Diesel Engine).
To Check the Transmission Fluid Level
2. Remove the transmission dipstick,wipe it clean, reinsert the dipstick as far as it will go, then remove it again. Now check the fluid level on the dipstick. It should be in the"HOT" range on the dipstick.
CAUTION:
The transmission fluid level shouldbe checked when the engine is atnormal operating temperature. This means that the engine, radiator, exhaust system etc., are very hotso you should exercise great care not to burn yourself during this procedure. Park the car on level ground with the
parking brake engaged. When thetransmission fluid level is checked, the transmission fluid should be at normal operating temperature and theengine idling.
Whilst the engine is idling, apply the
brakes and move the gear selectorlevel from "P" to each of its other positions — "R", "N", "D", "2", "L" — and then return to "N" or "P". With theengine still idling:
1. Open the bonnet, being careful to keep hands and clothing clear of any moving parts.
HHP3018-E
HHP5009-E
G110D01HP
Petrol Engine
Diesel Engine
Page 496 of 539

6
OWNER MAINTENANCE
19
!
!
!
3. If the transmission fluid level is low,
use a funnel to add transmission fluid through the dipstick tube until the level reaches the "HOT" range. Do not overfill. WARNING (Diesel only):
Never work on injection system with
engine running or within 30 sec-onds after shutting off engine. Highpressure pump, rail, injectors and high pressure pipes are subject to high pressure even after the enginestopped. The fuel jet produced by fuel leaks may cause serious injury, if it touch the body. People usingpacemakers should not move than 30cm closer to the ECU or wiring harness within the engine roomwhilst engine is running, since the high currents in the Common Rail system produce considerable mag-netic fields.
WARNING:
The electric engine cooling fan au-tomatically switches on and off ac- cording to engine temperature. Be careful to keep away from the fanduring this check as it may switch on at any time. NOTE: Only lint free cloth should be used
for wiping the dipstick. The pres- ence of lint within the transmis- sion may cause problems with the normal function of the transmis-sion. CAUTION:
Correct operation of the brakingsystem is essential to the safe op- eration of the vehicle and there- fore, any maintenance operationsother than those listed below should be entrusted to a Hyundai dealer. SG120C2-E Brake Fluid Recommendations Only brake fluid conforming to DOT 3 or DOT 4 specifications or highermay be used in the braking system. Care should be taken to observe the instructions and precautions printedupon the container.
Fluid level should be within "HOT" range
G110D04HP
BRAKE SYSTEM CHECKING
SG120A1-E
Page 506 of 539

6
OWNER MAINTENANCE
29
YG220A1-E POWER STEERING HOSES It is suggested that you check the power steering hose connections forfluid leakage at those intervals speci- fied in the vehicle maintenance sched- ule in Section 5. The power steeringhoses should be replaced if there are severe surface cracking, pulling, scuff- ing or worn spots. Deterioration of thehoses could cause premature failure. NOTE: The power steering pump may be noisy when the engine is first started in the extreme cold (-4°F).This noise is not abnormal and will stop as the engine warms up. If the power steering pump contin-ues to be noisy after the engine has warmed up, have it inspected by your Authorised Hyundai Dealer.
The power steering fluid level should
be checked regularly.
To check the power steering fluid level,
be sure the ignition is "OFF", thencheck to make certain that the powersteering fluid level is between the "MAX" and "MIN" level markings on the fluid reservoir.
NOTE: Do not check whilst the engine is
running. Do not start when power steering fluid reservoir is empty. Fluid Recommendation
Only automatic transmission fluid meeting the specification of PSF-3 orATF DEXRON 2 should be used in the power steering system.POWER STEERING FLUID LEVEL
G230A03A-EAT
Petrol Engine
G230A01HP-E
HHP5014-E
Diesel Engine
Page 533 of 539
9
VEHICLE SPECIFICATIONS
5
Q'ty (lmp.qts)(litre)
2.82 (3.2) Petrol : 9.24(10.5), Diesel : 10.38 (11.8) 1.25(1.42)Part-time 4WD : 1.58(1.8) Full-time 4WD : 1.14(1.3) NO.7 : 2.29(2.6) NO.7.5 : 2.46(2.8) Petrol : 9.68 (11), Diesel : 7.92(9) 1.14 (1.3) As required
Oil & Grease Standard
HYUNDAI GENUINE PARTS MTF 75W/90 (API GL-4)MOBILE DEXRON-II ATF DEXRON-IIIHYPOID GEAR OIL API GL-5 or HIGHER, SAE 80W[BELOW -22°F (-30°C)]/90W[ABOVE -22°F (-30°C)] MOBIL INFILREX 33HYPOID GEAR OIL API GL-5 or HIGHER, SAE 80W[BELOW -22°F (-30°C)]/90W[ABOVE-22°F (-30°C)] Ethylene glycol base for aluminiumPSF-3 or ATF Dexron 2 DOT 3 or DOT 4 Equivalent
Item
Transmission FluidTransfer case oil Front axle gear oil Rear axle gear oil Coolant Power steering oil Brakes and clutch fluid
J080A08HP-EAT
Manual
Auto
With LSD Without LSD