2005 DODGE POWER WAGON seats

2. Lift the cover (if so equipped), and attach the hook to
the square opening in the sheet metal.
3. Install the child restraint and remove the slack in the
tether strap according to the manufacturer’s instructions.Multiple Child Restraint Installation Sequence -
(Quad Cab Rear Seats)
1. Obtain tether straps by raising the head restraints and
reaching between the rear glass and rear seat. The tether
strap may be retained with an elastic band. Accessibility
to the tether strap is greatly improved by raising the seat
cushion to the“up”position. Remove the elastic before
use.
2. Place a child restraint on each outboard rear seat and
adjust the tether strap so that it will reach under the head
restraint to the tether anchor directly behind the seat and
then to the anchor directly behind the center rear seat.
3. Pass each tether strap hook under the head restraint
and through the loop of webbing behind the child seat.
4. Route each tether strap to the anchor behind the center
seat, and attach the hooks to the metal ring.
Regular Cab With Any Bench Seat
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 67
2

Children Too Large for Booster Seats
Children who are large enough to wear the shoulder belt
comfortably, and whose legs are long enough to bend
over the front of the seat when their back is against the
seat back should use the lap/shoulder belt in a rear seat.
•Make sure that the child is upright in the seat.
•The lap portion should be low on the hips and as snug
as possible.
•Check belt fit periodically. A child’s squirming or
slouching can move the belt out of position.
If the shoulder belt contacts the face or neck, move the
child closer to the center of the vehicle. Never allow a
child to put the shoulder belt under an arm or behind
their back.
ENGINE BREAK-IN RECOMMENDATIONS
A long break-in period is not required for the engine in
your new vehicle. Drive moderately during the first 300
miles (500 km). After the initial 60 miles (100 km), speeds
up to 50 or 55 mph (80 or 90 km/h) are desirable. While
cruising, brief full-throttle acceleration, within the limits
of local traffic laws, contributes to a good break-in.
Avoid wide open throttle acceleration in low gear.
The engine oil installed in the engine at the factory is a
high quality, energy conserving type lubricant. Oil
changes should be consistent with the anticipated cli-
matic conditions under which vehicle operation will
occur. The recommended viscosity and quality grades are
discussed in Section 7 under Maintenance Procedures,
Engine Oil.
NON-DETERGENT OR STRAIGHT MINERAL OILS
MUST NEVER BE USED.
70 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE

A new engine may consume some oil during its first few
thousand miles of operation. This is a normal part of the
break-in and is not an indication of difficulty.
CAUTION!
•During the first 500 miles (805 km) your new
vehicle is driven, do not tow a trailer. Doing so
may damage your vehicle.
•Limit your speed to 50 mph (80 km/h) during the
first 500 miles (805 km) of towing.
SAFETY TIPS
Transporting Passengers
This vehicle is designed to carry passengers in the cab
only. For safety reasons, NEVER TRANSPORT PASSEN-
GERS IN THE CARGO AREA.
WARNING!
It is extremely dangerous to ride in a cargo area,
inside or outside of a vehicle. In a collision, people
riding in these areas are more likely to be seriously
injured or killed.
Do not allow people to ride in any area of your
vehicle that is not equipped with seats and seat belts.
Be sure everyone in your vehicle is in a seat and
using a seat belt properly.
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 71
2

▫Exterior Mirrors Folding Feature...........86
▫Electronic Power Mirrors—If Equipped......87
▫Electric Rear Window Defroster And Heated
Sideview Mirrors—If Equipped...........88
▫Trailer Towing Mirrors—If Equipped.......88

Hands–Free Communication (UConnect™)
—If Equipped..........................90
▫Operation............................91
▫Phone Call Features....................95
▫Advanced Phone Connectivity.............97
▫UConnect™System Features..............99

Seats................................102
▫40-20-40 Front Seat....................102
▫Reclining Seats.......................103▫Adjustable Head Restraints..............104
▫Manual Rotary Lumbar Support Adjustment
—If Equipped.......................105
▫Power Seats—If Equipped..............105
▫Heated Seats—If Equipped.............107

To Open And Close The Hood.............108

Lights...............................109
▫Interior Lights.......................110
▫Battery Saver........................111
▫Headlamp Delay—If Equipped..........111
▫Headlights, Parking Lights, Panel Lights.....111
▫Daytime Running Lights (Canada And Fleet
Vehicles Only).......................112
▫Lights-On Reminder...................113
76 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

Cigar Lighter And Ash Receiver............140

Cupholders...........................141
▫Front Instrument Panel Cupholders
—Automatic Transmission Only..........141
▫Rear Cupholder—Quad Cab
—If Equipped.......................142

Storage..............................142
▫Center Storage Compartment—If Equipped . . 142▫Storage And Seats—If Equipped..........143

Fold Flat Load Floor—If Equipped.........144
▫Fold Flat Load Floor—If Equipped........144

Pickup Box...........................147

Slide-In Campers.......................148

Easy-Off Tailgate.......................148
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 79
3

SEATS
The seating options available in this truck are the result of
extensive customer research and evaluations.
WARNING!
It is extremely dangerous to ride in a cargo area,
inside or outside of a vehicle. In a collision, people
riding in these areas are more likely to be seriously
injured or killed.
Do not allow people to ride in any area of your
vehicle that is not equipped with seats and seat belts.
Be sure everyone in your vehicle is in a seat and
using a seat belt properly.
40-20-40 Front Seat
As the name implies, the seat is divided into 3 segments.
The outboard seat portions are each 40% of the total
width of the seat. The back of the center portion (20%)
easily folds down to provide an armrest/center storage
compartment (if equipped).
102 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

Each outboard seat is independently adjustable forward
or backward and is equipped with a back recliner. The
manual seat adjustment handle is found at the front edge
of each seat cushion. Pull up on the handle and slide the
seat to get the most comfortable position.
WARNING!
Adjusting a seat while the vehicle is moving is
dangerous. The sudden movement of the seat could
cause you to lose control. The seat belt might not be
properly adjusted and you could be injured. Adjust
any seat only while the vehicle is parked.
Reclining Seats
The recliner handle is on the outside of the seat cushion.
Pull up on the handle to release the seat back and adjust
for comfort.
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 103
3

Manual Rotary Lumbar Support Adjustment—If
Equipped
Rotating the lumbar control knob on the left side of the
driver’s seatback and on the right side of the passenger’s
seatback increases or decreases the lumbar support.
Power Seats—If Equipped
CAUTION!
Don’t put anything under a power seat. It may cause
damage to the seat controls.
Manual Lumbar Adjustment
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 105
3