2005 DODGE GRAND CARAVAN brake light

by increased pedal travel during application, greater
pedal force required to slow or stop, and potential
activation of the Brake Warning Lamp.
Anti-Lock Brake System — If Equipped
The Anti-Lock Brake System provides increased vehicle
stability and brake performance under most braking
conditions. The system automatically “ pumps ” the
brakes during severe braking conditions to prevent
wheel lock-up.
WARNING!Pumping of the Anti-Lock Brakes will diminish
their effectiveness and may lead to an accident.
Pumping makes the stopping distance longer. Just
press firmly on your brake pedal when you need to
slow down or stop. The ABS light monitors the Anti-Lock Brake
System. The light will come on when the
ignition switch is turned to the ON position
and may stay on for as long as four seconds.
If the ABS light remains on or comes on while driving, it
indicates that the Anti-Lock portion of the brake system
is not functioning and that service is required. However,
the conventional brake system will continue to operate
normally if the BRAKE warning light is not on.
If the ABS light is on, the brake system should be serviced
as soon as possible to restore the benefits of Anti-Lock
brakes. If the ABS light does not come on when the
Ignition switch is turned to the ON position, have the
bulb repaired as soon as possible.
If both the Brake Warning Light and the ABS Light
remain on, the Anti-Lock brakes (ABS) and Electronic
Brake Force Distribution (EBD) systems are not function-
ing. Immediate repair to the ABS system is required. STARTING AND OPERATING 303
5

When the vehicle is driven over approximately 15 mph
(25 km/h), you may also hear a slight clicking sound as
well as some related motor noises. These noises are the
system performing its self check cycle to ensure that the
ABS system is working properly. This self check occurs
each time the vehicle is started and accelerated past
approximately 15 mph (25 km/h).
ABS is activated during braking under certain road or
stopping conditions. ABS-inducing conditions can in-
clude ice, snow, gravel, bumps, railroad tracks, loose
debris, or panic stops.
You also may experience the following when the brake
system goes into Anti-lock:
• The ABS motor running (it may continue to run for a
short time after the stop),
• the clicking sound of solenoid valves,
• brake pedal pulsations, • and a slight drop or fall away of the brake pedal at the
end of the stop.
These are all normal characteristics of ABS.
WARNING!The Anti-Lock Brake System contains sophisticated
electronic equipment that may be susceptible to
interference caused by improperly installed or high
output radio transmitting equipment. This interfer-
ence can cause possible loss of anti-lock braking
capability. Installation of such equipment should be
performed by qualified professionals.304 STARTING AND OPERATING

▫ Steering Shaft Seal ....................391
▫ Steering Linkage ......................391
▫ Drive Shaft Universal Joints ..............391
▫ Body Lubrication .....................391
▫ Windshield Wiper Blades ................392
▫ Windshield And Rear Window Washers .....392
▫ Exhaust System ......................393
▫ Cooling System .......................394
▫ Hoses And Vacuum/Vapor Harnesses .......399
▫ Brakes .............................399
▫ Master Cylinder — ABS Brakes Brake
Fluid Level Check .....................401
▫ Fuel System Hoses ....................402 ▫ Automatic Transmission ................402
▫ Front And Rear Wheel Bearings ...........406
▫ Appearance Care And Protection
From Corrosion ......................406
▫ Cleaning The Instrument Panel And Underseat
Cup Holders ........................410

Integrated Power Module (IPM) ............412

Vehicle Storage ........................415

Replacement Light Bulbs .................415

Bulb Replacement ......................416
▫ Headlights ..........................416
▫ Front Park/Turn Signal And
Sidemarker Lights .....................418
▫ Front Fog Light ......................419372 MAINTAINING YOUR VEHICLE

replaced immediately! Eventual deterioration of the hose
can take place resulting in a possibility of a burst failure.
WARNING!Worn brake hoses can burst and cause brake failure.
You could have an accident. If you see any signs of
cracking, scuffing, or worn spots, have the brake
hoses replaced immediately.
Master Cylinder — ABS Brakes Brake Fluid Level
Check
The fluid level in the master cylinder should be checked
when performing underhood services, or immediately if
the brake system warning light indicates system failure.
Clean the top of the master cylinder area before removing
the cap. Add fluid to bring the level up to the top of the
“ FULL ” mark on the side of the master cylinder reservoir. Overfilling of fluid is not recommended because it may
cause leaking in the system.
Add enough fluid to bring the level up to the require-
ments described on the brake fluid reservoir. With disc
brakes, fluid level can be expected to fall as the brake
pads wear. However, low fluid level may be caused by a
leak and a checkup may be needed.
Use only manufacturers recommended brake fluid, refer
to Recommended Fluids, Lubricants and Genuine Parts
for correct fluid type.
WARNING!Use of brake fluid that may have a lower initial
boiling point or unidentified as to specification, may
result in sudden brake failure during hard pro-
longed braking. You could have an accident. MAINTAINING YOUR VEHICLE 401
7

INTEGRATED POWER MODULE (IPM)
An Integrated Power Module is located in the engine
compartment near the battery. This center contains maxi
fuses, mini fuses and relays. A label that identifies each
component is printed on the inside of the cover. Cavity Maxi Fuse Description
F4 30 Amp
Pink Front Wipers
F9 40 Amp
Green Anti-Lock Brake System
(ABS) Pump
F10 40 Amp
Green Front Blower
F13 40 Amp
Green Electronic Back Light (EBL)
F19 40 Amp
Green Body Control Module
(BCM) Feed 1
F20 30 Amp
Pink Central Amplifier
F22 30 Amp
Pink Seats
F27 40 Amp
Green Radiator FanIntegrated Power module (IPM)412 MAINTAINING YOUR VEHICLE

Once a Month
• Check tire pressure and look for unusual wear or
damage.
• Inspect the battery and clean and tighten the terminals
as required.
• Check the fluid levels of coolant reservoir, brake
master cylinder and transmission; add as needed.
• Check all lights and all other electrical items for correct
operation. At Each Oil Change
• Change the engine oil filter.
• Inspect the exhaust system.
• Inspect the brake hoses.
• Inspect the CV joints and front suspension compo-
nents.
• Check the automatic transmission fluid level.
• Check the coolant level, hoses, and clamps.428 MAINTENANCE SCHEDULES
8 M
A
I
N
T
E
N
A
N
C
E
S
C
H
E
D
U
L
E
S

Adding Fuel ........................... 334
Adding Washer Fluid .................. 286,392
Additives, Fuel ......................... 332
Adjustable Pedals ....................... 146
Air Conditioner Maintenance ............... 388
Air Conditioning ..................... 262,267
Air Conditioning Controls ................. 262
Air Conditioning Filter ................. 284,389
Air Conditioning, Operating Tips ............ 284
Air Conditioning, Rear Zone ............. 270,279
Air Conditioning Refrigerant ............... 388
Air Conditioning System .......... 262,267,272,388
Air Conditioning System, Zone Control ........ 263
Air Pressure, Tires ....................... 317
Airbag ................................ 53
Airbag Deployment ....................... 65
Airbag Light ................... 57,58,68,84,199
Airbag Maintenance ....................... 67
Airbag, Window ......................... 54 Alarm Light ........................... 200
Alarm System ........................... 27
Alignment and Balance ................... 324
Alterations/Modifications, Vehicle ............. 7
Antenna, Satellite Radio ................... 257
Antifreeze (Engine Coolant) ........... 395,396,421
Disposal ............................ 397
Anti-Lock Brake System (ABS) .............. 303
Anti-Lock Warning Light .................. 199
Anti-Theft Security Alarm .................. 27
Appearance Care ........................ 406
Arming Theft System ...................... 27
Ashtray ............................... 171
Auto Down Power Windows ................ 40
Automatic Dimming Mirror ................. 92
Automatic Door Locks ................... 19,20
Automatic Headlights .................... 136
Automatic Temperature Control ............. 272
Automatic Transaxle ...................... 297458 INDEX

Interlock System ....................... 298
Reset Mode .......................... 299
Selection Of Lubricant ................ 403,423
Shifting ............................. 299
Special Additives ...................... 405
Automatic Transmission ................... 402
Adding Fluid ......................... 404
Fluid and Filter Changes ................. 405
Fluid Change ......................... 405
Fluid Level Check ...................... 404
Fluid Type ........................ 403,423
Ball Joints ............................. 390
Battery ............................... 387
Gas Caution .......................... 387
Jump Starting ......................... 365
Keyless Transmitter Replacement ............ 26
Saving Feature (Protection) ............... 137
Bearings .............................. 406 Belts, Drive ............................ 383
Body Mechanism Lubrication ............... 391
B-Pillar Location ........................ 312
Brake Fluid ............................ 423
Brake, Parking .......................... 301
Brake System ........................ 302,399
Anti-Lock ........................... 303
Fluid Check .......................... 401
Hoses .............................. 400
Warning Light ........................ 197
Brakes ............................. 302,399
Brake/Transmission Interlock ............... 298
Break-In Recommendations, New Vehicle ........ 82
Bulb Replacement ....................... 416
Bulbs, Light ............................ 415
Calibration, Compass ..................... 152
Capacities, Fluid ........................ 421 INDEX 459
10