2005 CHEVROLET SILVERADO child lock

[x] Cancel search: child lock

Page 1 of 580

CHEVROLET SILVERADO 2005 1.G Owners Manual Seats and Restraint Systems........................... 1-1
Front Seats
............................................... 1-3
Rear Seats
............................................... 1-8
Safety Belts
.

Page 21 of 580

CHEVROLET SILVERADO 2005 1.G Owners Manual Q:If I am a good driver, and I never drive far from
home, why should I wear safety belts?
A:You may be an excellent driver, but if you are in an
accident — even one that is not your fault — you
an

Page 29 of 580

CHEVROLET SILVERADO 2005 1.G Owners Manual Right Front Passenger Position
To learn how to wear the right front passenger’s safety
belt properly, seeDriver Position on page 1-15.
The right front passenger’s safety belt works the same
way as

Page 60 of 580

CHEVROLET SILVERADO 2005 1.G Owners Manual 6. To tighten the belt, push down on the child restraint,
pull the shoulder portion of the belt to tighten the
lap portion of the belt and feed the shoulder belt back
into the retractor. If you are us

Page 64 of 580

CHEVROLET SILVERADO 2005 1.G Owners Manual 5. Pull the rest of the shoulder belt all the way out of
the retractor to set the lock.6. To tighten the belt, push down on the child restraint,
pull the shoulder belt to tighten the lap belt portion

Page 67 of 580

CHEVROLET SILVERADO 2005 1.G Owners Manual 3. Pick up the latch plate, and run the lap and shoulder
portions of the vehicle’s safety belt through or
around the restraint. The child restraint instructions
will show you how.
4. Buckle the belt

Page 68 of 580

CHEVROLET SILVERADO 2005 1.G Owners Manual 6. To tighten the belt, push down on the child restraint,
pull the shoulder portion of the belt to tighten the
lap portion of the belt and feed the shoulder
belt back into the retractor. If you are us

Page 94 of 580

CHEVROLET SILVERADO 2005 1.G Owners Manual Resynchronization
Resynchronization may be necessary due to the
security method used by this system. The transmitter
does not send the same signal twice to the receiver.
The receiver will not respond
Page:   1-8 9-16 next >