Page 23 of 357

GETTING TO KNOW YOUR CAR21
FRONT SEATS
MOVING THE SEATS
BACKWARDS OR FORWARDS Lift lever (A) and push the seat backwards
or forwards: in the driving position the arms
should be slightly flexed and hands should
rest on the rim of the steering wheel.
ADJUSTING THE HEIGHT
OF THE DRIVER’S SEAT To raise the seat, pull the lever (B) tak-
ing it upwards, then continue operating the
lever (up and down) until reaching the re-
quired height, then release the lever. To
lower the seat, push the lever (B) down-
wards, then operate the lever (up and
down) until reaching the height required.
WARNINGAdjustment must only be car-
ried out when seated in the driver’s seat.ADJUSTING THE ANGLE
OF THE BACKREST This can be done by turning the knob (C)
until the desired position is reached.
The sporty seats equipped with lateral air
bags have an electric adjustment; use the
button (D-fig. 21) on the outer part of
the seat to set the seat back in the required
position.
fig. 20
A0B0054m
fig. 19
A0B0028m
Fig. 19: standard equipment;
Fig. 20: sporty seats (where applicable);
Fig. 21: sporty seats and lateral air bags.
Adjustments may be made
solely with the car sta-
tionary.
WARNING
Once you have let go off
the lever, check that the
seat is firmly locked in the runners
by trying to move it back and
forth. If the seat is not locked prop-
erly, in the case of collision t might
move unexpectedly with clearly
dangerous consequences.
WARNING
Page 24 of 357
GETTING TO KNOW YOUR CAR22
BACKREST ANGLE ELECTRIC
ADJUSTMENT(optional for versions/markets
where applicable)
This can be done by pressing button (D)
located on the outer part of the seat.
LUMBAR ADJUSTMENT
OF THE DRIVER’S SEAT(optional for versions/markets
where applicable)
Adjustment is done by turning the knob
(E) until reaching the most comfortable po-
sition.CENTRE ARMREST (where required)
To use the armrest lower it as illustrated.
Inside the armrest there is an oddment
compartment (B-fig. 22); to use it, raise
the cover (A).
SEAT WARMING
(fig. 23)
(optional for versions/markets
owhere applicable)
The seat warming pad can be switched on
and off using switch (A) on the inner side
of the seat; for sporty seats, press the switch
(F-fig. 21) on the outer side of the seat.
When the warming pad is on, the warning
light (B) on the outer side of the seat turns
on.
fig. 22
A0B0293m
fig. 23
A0B0052m
fig. 21
A0B0053m
Page 347 of 357

RIGHT HAND DRIVE VERSION
345
MILEAGE RECORDER WITH
DOUBLE METER DISPLAY
(TOTAL AND TRIP)The display shows:
– the mileage on the first line (6 figures)
– the trip meter (4 figures).
To reset the trip meter, keep the button
(A) pressed for a few seconds.
WARNINGThe trip meter reading is not
stored if the battery is disconnected.
DASHBOARD LIGHTING
ADJUSTMENT (fig. 4)When the outside lights are on, the dash-
board lighting is adjusted pressing button
(B).
Each press of the button (B) cyclically se-
lects one of the three lighting levels pro-
vided: low-medium-high.
HEADLIGHT CORRECTOR
(fig. 4)The control (C) on the plate at the side
of the steering column can be moved to four
positions corresponding to various vehicle
loads given below.
Both headlights should be adjusted to com-
pensate for vehicle loading.
Position 0: 1 or 2 people occupying front
seats, full fuel tank, on-board equipment
present.
Position 1: 5 people on-board.
Position 2: 5 people on-board, luggage
compartment full (50 kg approximately).
Position 3: Driver and 300 kg in luggage
compartment.
fig. 4
A0B0418m
Page 348 of 357

RIGHT HAND DRIVE VERSION
346
SEATSFRONT SEATS (fig. 5)
Adjusting the height
of the driver’s seat
To raise the seat, pull the lever (B) tak-
ing it upwards, then continue operating the
lever (up and down) until reaching the re-
quired height.
To lower the seat, push the lever (B)
downwards, then operate the lever (up and
down) until reaching the height required.
WARNINGAdjustment must only be car-
ried out when seated in the driver’s seat.Adjusting the angle
of the backrest
This can be done by turning the knob (C)
until the desired position is reached.
Lumbar adjustment
of the driver’s seat
(for versions/markets where applicable)
Adjustment is done by turning the knob
(D) until reaching the most comfortable po-
sition. Moving the seat backwards
or forwards
Lift lever (A) and push the seat backwards
or forwards. Once you have let go of the
lever, check that the seat is firmly locked
in the runners by trying to move it back and
forth.
If the seat is not locked properly, in the
case of collision it might move unexpect-
edly with clearly dangerous consequences.fig. 5
A0B0419m
Adjustments may be made
solely with the car sta-
tionary.
WARNING