2005 Acura RL lock

Û
Ý
With the ignition switch in the ON
(II) position, press the INFO button
f or more than 3 seconds, then
release it. The CUSTOMIZE ENTRY
screen appears on the multi-
inf ormation display.
Select CHG SETTING, and press the
SEL/RESET button. Select DOOR/WINDOW SET UP,
and press the SEL/RESET button.
Each time you press the INFO ( /
) button, the display changes as
shown in the illustration.
Here are the settings you can
customize in this mode:
DOOR LOCK MODE AUTO DOOR LOCK
AUTO DOOR UNLOCK
KEYLESS LOCK
ACKNOWLEDGEMENT
SECURITY RELOCK TIMER If you select EXIT and press the
SEL/RESET button, the
CUSTOMIZE GROUP screen is
shown again.
Door/Window Setup
Multi-Inf ormation Display
94

µµ
ÛÝ
You can select f rom three possible
settings f or auto door lock:
SHIFT FROM P
The doors lock whenever you move
the shift lever out of Park.
WITH VEH SPD
The doors lock when the vehicle
speed reaches about 10 mph (about
15 km/h).
CONT INUED
Auto Door Lock
Multi-Inf ormation Display
Inst rument s and Cont rols
95
Press the or button.
Press the SEL/RESET button.

µ
µ
ÛÝ µ
µ ÛÝ
Auto Door Unlock
You can select f rom three possible
settings f or auto door unlock:
SHIFT TO P The driver’s door or
all the doors, depending on your
selection in DOOR LOCK MODE
(see page ), unlock whenever
you move the shif t lever to Park.
OFF
The auto door lock is deactivated all
the time.
Select the desired condition by
pressing the or button, and
enter your selection by pressing the
SEL/RESET button.
The conf irmation screen is shown
f or 2 seconds, then the CUSTOMIZE
ENTRY screen returns.
To exit this mode without changing
the current settings, select EXIT,
and press the SEL/RESET button.
IGN OFF The driver’s door or all
doors, depending on your selection
in DOOR LOCK MODE (see page
), unlock when you turn the
ignition switch to LOCK (0).
OFF The auto door unlock is
deactivated all the time.
Select the desired setting by
pressing the or button, and
enter your selection by pressing the
SEL/RESET button.
The conf irmation screen is shown
f or 2 seconds, then the CUSTOMIZE
ENTRY screen returns.
To exit this mode without changing
the current settings, select EXIT,
and press the SEL/RESET button.
97 97
Multi-Inf ormation Display
96

ÛÝ
Keyless Lock Acknowledgment
Door Lock Mode
If you unlock the doors by pressing
the button on the remote, you can
select whether the driver’s door
unlocks or all the doors unlock.
Select the desired mode by pressing
the or button, and enter your
selection by pressing the SEL/
RESET button.
The conf irmation screen is shown
f or 2 seconds, then the CUSTOMIZE
ENTRY screen returns. To exit this mode without changing
the current settings, select EXIT,
and press the SEL/RESET button.
When you press the LOCK button
on the remote a second time within 5
seconds after you lock the doors, the
hood, and the trunk with the remote,
a beeper will sound and the exterior
lights will blink once to verif y that
the doors are locked and the security
system is ready.
CONT INUED
Multi-Inf ormation Display
Inst rument s and Cont rols
97

ÛÝ
ÛÝ Select the desired time by pressing
the or button and, enter your
selection by pressing the SEL/
RESET button.
The conf irmation screen is shown
f or 2 seconds, then the CUSTOMIZE
ENTRY screen returns.
To exit this mode without changing
the current settings, select EXIT,
and press the SEL/RESET button.
If you unlock the doors by pressing
the button on the remote or
grabbing the driver’s door handle
while carrying the remote, but do not
open any of the doors within 30
seconds, the doors automatically
relock and the security system sets.
You can select this relock time to be
90, 60, or 30 seconds.
When you press the UNLOCK
buttonontheremoteasecondtime
within 5 seconds af ter you unlock
the doors with the remote, the
beeper will sound twice and the
exterior lights will blink twice to
verif y that the doors are unlocked
and the security system is turned of f .
The conf irmation screen is shown
f or 2 seconds, then the CUSTOMIZE
ENTRY screen returns. If you do not want the beeper to
sound and the exterior lights to blink,
select OFF by pressing the or
button, and enter your selection by
pressing the SEL/RESET button.
To exit this mode without changing
the current settings, select EXIT,
and press the SEL/RESET button.
Security Relock Timer
Multi-Inf ormation Display
98

The windshield wiper arms have two
parked positions: winter and summer.
In the winter position, the arms sit
slightly above the edge of the hood.
This reduces the possibility of
damage to the wiper arms or
windshield wiper motor by a build-up
of snow and ice.A heavy build-up of snow or ice on
the wiper arms will cause them to
automatically park in the winter
position. Adjust the wiper arms to the winter
position by holding both arms as
shown in the illustration at the same
time. Pull on the arm, parallel to the
windshield, until it locks in the
higher position.To return to the summer position,
pushthesameareaof botharmsthe
other direction.
Windshield Wipers and Washers
Wiper A rm Posit ions
Inst rument s and Cont rols
103
WIPER ARMS
Winter position WIPER ARMS
Summer position HOLDING
LOCATIONS
HOLDING
LOCATIONS

µ
µ µPush down on the
lef t lever to signal a lef t turn and up
to signal a right turn. To signal a lane
change, push lightly on the lever and
hold it. The lever will return to
center when you release it or
complete a turn.
Turn signal
Of f
Parking and indicator lights
AUTO
Headlights on
High beams
Flashhighbeams
Fog lights of f
Fog lights on The rotating switch
on the lef t lever controls the lights.
Turning this switch to the ‘‘ ’’
position turns on the parking lights,
taillights, instrument panel lights,
side-marker lights, and rear license
plate lights.
Turning the switch to the ‘‘ ’’
position turns on the headlights. If
you leave the lights on with the
ignition switch released af ter turned
to the LOCK (0) position or when
the built-in key is removed f rom the
ignition switch, you will hear a
reminder chime when you open the
driver’s door. When the light switch is in the
‘‘ ’’ or ‘‘ ’’ position, the
lights on indicator comes on as a
reminder. This indicator stays on if
you leave the light switch on and
turn the ignition switch to the
ACCESSORY (I) or LOCK (0)
position.
To switch f rom low
beams to high beams, push the lef t
lever f orward until you hear a click.
The blue high beam indicator will
come on (see page ). Pull it back
to return to low beams. To flash the
high beams, pull the lever back
lightly, then release it. The high
beamsstayonaslongasyouhold
the lever back.
1.
2.
3.
4.
5.
6.
7.
8.
9. 64
Turn Signal
Headlights
High Beams
Turn Signal, Headlights
104

Turn the f og lights on and of f by
turning the switch next to the
headlight switch.
You can use the f og lights only when
the headlights are on low beam.
The headlights revert to normal
operation when you turn them on
with the switch. With the light switch in the AUTO
position, you can also use the f og
lights when the headlights turn on
automatically. They will go of f when
the headlights turn of f .
With the headlight switch off, the
high beam headlights come on with
reduced brightness when you turn
the ignition switch to ON (II) and
release the parking brake. They
remain on until you turn the ignition
switch of f , even if you set the
parking brake.This f eature turns of f the headlights,
all other exterior lights, and the
instrument panel lights within 15
seconds after you turn the ignition
switch to LOCK (0) and close the
driver’s door.
To change the ‘‘HEADLIGHT AUTO
OFF TIMER’’ setting, see page . If you see a ‘‘CHECK DRL
SYSTEM’’ message on the multi-
inf ormation display, there is a
problem with the daytime running
light system. Take your vehicle to a
dealer to have it checked.
When the multi-information display
shows a ‘‘DRL OFF’’ message, the
daytime running lights are of f .
Follow the procedure in the lef t
column to turn them on.The automatic lighting of f f eature
activates if you leave the headlight
switch in the ‘‘ ’’ or ‘‘ ’’
position or if the lights are turned on
by setting the switch in the ‘‘AUTO’’
position, turn the ignition switch to
LOCK (0), then open and close the
driver’s door.
If you turn the ignition switch to
LOCK (0) with the headlight switch
on, but do not open the door and get
out, the lights turn off after 10
minutes (3 minutes, if the switch is
in the ‘‘AUTO’’ position).
The lights turn on again when you
unlock or open the driver’s door.
If you unlock the door, but do not
open it within 15 seconds, the lights
go of f . With the driver’s door open,
you will hear a lights-on reminder
chime.
92
Headlights
Fog Lights
Daytime Running Lights Automatic Lighting Of f Feature
106