B
A
2
3
4
26
I
I N B R I E F
IC R U I S E C O N T R O L /«C R U I S E»
This driving assistance function allows you to drive at the speed of your
choIce without the need to action the accelerator.
It is available at speeds above 40 km/h (25 mph), in the higher gears
only.
Control A for cruise control is located below the lighting/signalling control
stalk.
Note: Information relating to the cruise control is displ ayed in zone B
on the display.
To select the function
Turn control 1 to the « CRUISE » position.
To select a cruise speed
On selection of the function via control 1, no cruise
speed has yet been memorised.
Accelerate to the desired speed, then give a short press on button 2 or
button 4.
The cruise speed is then memorised. It is displayed
in zone B on the screen.
The trip mileage recorder then displays.
You can then release the accelerator pedal. The veh icle will
automatically keep to that chosen speed
Note : The vehicle speed may vary slightly from that memor ised.
Cruise control should only be used when the traffi c conditions permit driving at a constant speed.
B
1
A
2
3
4
28
I
I N B R I E F
IS P E E D L I M I T E R / « L I M I T »
This driving assistance function allows you to choo se a maximum speed that you wish not to exceed. This has to be a speed greater than 30 km/h (approx. 20 mph).
Control A for the speed limiter is located below the lightin g/signalling Acontrol stalk.
Note: The information relating to the speed limiter is shown in zone B on the screen.
To select the function
Turn control 1 to the position « LIMIT ».
On selection of the function via control 1, the last speed memorised is displayed.
To adjust the maximum speed
Provided the engine is running, you adjust the memo rised speed by pressing :- button 4 to increase the memorised speed,- button 2 to decrease the memorised speed.Note: successive presses will modify the speed in steps of 1 km/h and a continuous press in steps of 5 km/h.
Activation of the maximum speedAs you see the desired maximum speed displayed, pre ss control 3 to activate 3the limitation.
The information « OFF » then disappears from zone B.
The trip mileage recorder is shown.
While the function is active, action on the accelerator pedal will not
permit the programmed speed to be exceeded, unless you press the
pedal hard down to go beyond the tight spot (see «Temporary override of the maximum speed»).
Note : the vehicle speed may vary slightly from that memor ised.
35S T E E R I N G L O C K – I G N I T I O N - S T A R T E R
NEVER REMOVE THE IGNITION KEY UNTIL THE ENGINE HAS COMPLETELY STOPPED.
IT IS IMPERATIVE ALWAYS TO KEEP THE ENGINE RUNNING IN ORDER TO RETAIN THE BRAKING AND STEERING ASSISTANCE (risk of the steering lock engaging and loss of the safety features).
When the vehicle is stopped and the engine switched off, after you remove the ignition key turn the steering wheel slightly so as to engage the steering lock.
63IIIIIIV E N T I L A T I O N - H E A T I N G
M A N U A L A I R C O N D I T I O N I N G
Entry of air
Make sure that the exterior air inlet grille and manifold at the base of the windscreen is clean and free of dead leaves, snow, etc..If you wash the vehicle using a high pressure jet, avoid targeting anywhere near the air inlet.
Air vents
The face-level air vents have controls for adjusting the air ow and grilles for orienting the direction.
Air circulation
Maximum comfort is obtained from having a good distribution of air in both the front and the rear of the passenger compartment. Air outlets on the oor beneath the front seats enhance comfort for rear passengers, so you should make sure that these outlets are not obstructed.
Pollen lter
Your installation has a lter for excluding dust.This lter has to be changed at the prescribed maintenance intervals (see the Maintenance Guide).
Additional heating
Vehicles with HDi engines may be tted with an automatic additional heating system for enhancing your comfort.
It is normal to notice certain emissions of fumes and odours, especially when stationary, with the engine running at idle.
Air conditioning
Whatever the time of year, the air conditioning is useful in removing humidity and misting.
To keep the air conditioning compressor well sealed , it is essential to operate the air conditioning at least once in every month.
To be effective, the air conditioning should only b e operated with the windows closed.
If after a prolonged stop in bright sunshine, the inside temperature has become excessive, open the windows for a few moments to air the cabin, then close the windows again.
The temperature inside the cabin cannot be lower than the ambient temperature if the air conditioning is not operating.
If you are pulling a heavy trailer in very high ambient temperatures, the air conditioning may temporarily be interrupted if the engine cooling requirements demand this.
Water arising from the condensation in the air conditioning system drains out through a hole provided for that purpose; a pool of water may thus be observed underneath the vehicle when stationary.
It is recommended to have the air conditioning system checked on a regular basis (see the Maintenance Guide).
The air conditioning uses power from the engine to operate. There is a resulting slight increase in fu el consumption.