2004 SUBARU OUTBACK power button

5-29
Audio
– CONTINUED –
TPower switch and volume/bass/treble/fader/
balance control (ON/VOL)
The dial (1) is used for both power (ON/OFF) and vol-
ume control. The radio is turned ON and OFF by push-
ing the dial and the volume is controlled by turning the
dial.
This dial is used for bass/treble controls when the “BASS/TREB” button (8) is in the depressed position.
It is also used for fader/balance controls when the
“FAD/BAL” button (6) is in the depressed position.

5-32
Audio
wish to listen. T
Weather band button (WB)
Press the “WB” button (2) to choose weather band.
The display will show WB.
Use the tuning dial to select the station to which you
wish to listen. T Manual tuning
Turn the tuning dial (3) outer tuner to increase or de-
crease the reception frequency in individual steps.
FM band: 0.2 MHz steps
AM band: 10 kHz steps
Weather band: 1 step (1 channel)
T Seek tuning (SEEK)
If the Tuning dial (3) outer tuner is turned for longer
than half of a second, the radio will begin to automati-
cally search for receivable frequencies and will stop at
the first one found. This function may not be available,
however, when radio signals are weak. In such a situ-
ation, perform manual tuning to select the desired sta- tion. T Scan tuning (SCAN)
Press the “SCAN” button (4) to change the radio to the
SCAN mode. In this mode, the radio scans through the
radio band until a station is found. The radio will stop at the station for five seconds while displaying the fre-
quency, after which scanning will continue until the en-
tire band has been scanned.
Turn the tuning dial (3) inner tuner again to cancel the
SCAN mode and to stop on any displayed frequency.
Scan tuning may not function properly if the station re-
ception is weakened by distance from the station or
proximity to tall buildings and hills. T
Preset tuning
Press any one of the preset buttons (5) to select the
corresponding, previously-registered radio station.
The LED at the top of that button will turn on. V Manual preset
y Use the tuning dial (3) to select the radio station
which you wish to register. y Choose the preset button (5) to which you wish to
assign that station and press it continuously for a peri-
od of more than 2 seconds. When the radio station has
been successfully registered, the display will flash the
corresponding radio frequency on and off once.
NOTE y Each preset button can be used to store both an
FM station and an AM station. y If the power supply is interrupted by disconnec-
tion of the battery, memory presets will be cleared

6-1
6
Interior equipment
Interior light .................................................. 6-2 Dome light ......................................................... 6-2
Cargo area light (if equipped) .......................... 6-2
Map light (if equipped) ................................. 6-3
Sun visors ..................................................... 6-4 Vanity mirror (if equipped) ............................... 6-5
Storage compartment .................................. 6-5 Glove box ........................................................... 6-6
Center console .................................................. 6-6
Coin compartment ............................................ 6-7
Overhead console (if equipped) ...................... 6-7
Cup holder .................................................... 6-8 Front cup holder ............................................... 6-8
Rear passenger’s cup holder (if equipped) .... 6-9
Cigarette lighter socket (if equipped) ......... 6-10 Use with a cigarette lighter .............................. 6-10
Using as an accessory power outlet ............... 6-11
Ashtray .......................................................... 6-12 Front ashtray ..................................................... 6-12
Rear ashtray (if equipped) ................................ 6-13
OnStar® system (if equipped) ..................... 6-13 OnStar services button .................................... 6-14
OnStar emergency button ................................ 6-14
OnStar communication button (White DOT) .. 6-14
System status light ........................................... 6-14
Volume control .................................................. 6-15
OnStar subscription plans* .............................. 6-15
OnStar services ................................................. 6-15
OnStar personal calling .................................... 6-17
OnStar virtual advisor ...................................... 6-17 OnStar system limitations ............................... 6-18
Accessory power outlet ............................... 6-19 In the luggage compartment (if equipped) ..... 6-19
Convenience hook ........................................ 6-20 Coat hook .......................................................... 6-20
Shopping bag hook .......................................... 6-20
Floor mat (if equipped) ................................. 6-21
Luggage cover (if equipped) ........................ 6-22 Using the cover ................................................. 6-23
To remove the cover ......................................... 6-23
Convenient tie-down hooks (if equipped) .. 6-24
Subfloor storage (if equipped) ..................... 6-25

6-14
Interior equipment
1-888-ONSTAR7 (888-667-8277). „
OnStar services button
Press this button, and you will be connected to an On-
Star Advisor. You will hear a chime, followed by the
words “Connecting to OnStar”. The connection pro-
cess will normally take about 15 seconds. Your sys-
tem is equipped with backup connection retry capabil-
ities. If you do not immediately connect to OnStar, DO
NOT DISCONNECT. A series of retry attempts will be
made automatically. If you wish to cancel your call to
the OnStar center, simply press the OnStar Communi-
cation button. „ OnStar emergency button
In an emergency, press this button to connect with an
OnStar Advisor. Your call will be given the highest pri-
ority, and you will hear a chime followed by the words
“Connecting to OnStar Emergency.” The Advisor will
attempt to locate your vehicle, find out what kind of as-
sistance you require, and contact a nearby emergency
services provider who can dispatch ambulance, fire,
police or other emergency services. Please use this
button only for true emergencies. If you press this but-
ton by mistake, please stay on the line and tell the ad-
visor that there is no emergency. „
OnStar communication button (White DOT)
Press this button at the end of a call. You’ll hear the
words “OnStar Request Ended.” Also, press this but-
ton to answer a call from the OnStar Center, or cancel
a call if one of the other buttons is accidentally
pressed. This button is also used to access OnStar
Personal Calling and Virtual Advisor services, if those
services have been activated. „ System status light
y Solid green – Indicates the OnStar system in the
vehicle is powered ON and ready to make or receive
calls.y Blinking green – The light blinks green to indicate
a call is being connected or in progress. If you notice
this light blinking while you are not on a call, press the
OnStar Communication (white dot) button. y Red – This signals that your OnStar system may not
be functioning properly. Press the OnStar button to at-
tempt to contact an OnStar advisor. If the connection
is made, the advisor will assist you in making sure your
OnStar system is operating properly. If you cannot
contact the OnStar Center, please take your vehicle to
the nearest SUBARU dealership for diagnosis and
service.