2004 Peugeot Partner VU Dag lights

3YOUR PARTNER AT A GLANCE
22-12-2003
1 -Cruise control stalk.
2 - Lights and direction indicators stalk.
3 - Driver's air bag.Horn.
4 - Instrument panel.
5 - Audio equipment steeringwheel control.
6 - Windscreen wash-wipestalk.
7 - Central adjustableheating/ventilation vents.
8 - Hazard lights button.
9 - Multifunction display orclock.
10 - Central locking button.
11 - Controls:Ð Electric windows.
Ð Demisting of rear door
windows or tailgate.
Ð Air conditioning. 12 -
Windscreen demistingvents.
13 - Speaker (tweeter).
14 - Side window demistingvents.
15 - Side adjustableheating/ventilation vents.
16 - Passenger air bag disarming control*.
17 - Upper glove box or passenger air bag.
18 - Lower glove box.
19 - Audio RB3 or RD3.
20 - Heating/air conditioningcontrols.
21 - Gear lever.
22 - Storage.
23 - 12 V accessories socket.
24 - Removable ashtray. 25 -
Lighter.
26 - Handbrake.
27 - Heated seats control.
28 - Steering lock and ignition.
29 - Steering wheel adjustment control.
30 - Bonnet release.
31 - Fuse box.
32 - Headlamp height adjustment.
33 - Passenger's electric mirrorcontrol.
* According to destination.

4THE KEYS The keys allow you to switch on the ignition and operate the pas-senger air bag disarming switch,as well as to independently operatethe locks on the doors and thefuel filler cap. Central locking From the front doors, the keys allow you to lock and unlock thedoors and tailgate. If one of the doors or the tailgate is open, it is impossible to oper-ate the central locking. The remote control performs the same functions at a distance. The remote control key Locking Press button
Ato lock the vehicle.
This is confirmed by fixed lighting of the direction indicators forapproximately two seconds. Unlocking Press button Bto unlock the
vehicle. This is confirmed by rapid flash- ing of the direction indicators. Locating the vehicle
To locate your vehicle, previous- ly locked, in a car park:  press button A, the courtesy
lights come on and the direc- tion indicators flash for a fewseconds. STARTING
STOP position (S):
The ignition is off. Accessories position (A):
The
ignition is off but the accessories can be used. On position (M): The ignition is on. Starting position (D):
Operates the starter.
61
YOUR PARTNER AT A GLANCE
22-12-2003

5YOUR PARTNER AT A GLANCE
STEERING WHEEL
STALKS LIGHTING
Front and rear lights (ring A)Lights off Side lightsDipped headlamps/Mainbeam headlamps
Vehicles fitted with a rear fog lamp (ring B)
Turn the ring forwards.
Vehicles fitted withfront fog lamps and arear fog lamp (ring B)
Front fog lamps (1st turn of thering forwards). Front fog lamps and rear fog lamp (2nd turn of the ring for-wards).
To switch off: turn the ring rear- wards.
71
WINDSCREEN WIPERS Front 2 Rapid wipe (heavy rain).
1 Normal wipe (moderate rain).
I Intermittent wipe.
0 Off.
Single wipe.
Windscreen wash-wipe:pull the stalk towards you. Rear
Off Intermittent Wash- wipe wipe
72
22-12-2003

SERVICE
INDICATOR This is a visual reminder of when the
next service is due. This service is tobe carried out according to the man-ufacturer's servicing schedule. Operation As soon as the ignition is switched on and for 5 seconds, the spannersymbolising ''service operation'' is lit.The trip recorder display shows thedistance remaining (in round figures)before the next service. Example: 4,800 km remain before
the next service is due.When the ignition comes on and for 5 seconds the display indicates: 5 seconds after the ignition is switched on, the total distancerecorder resumes normal operationand the display shows the total or tripdistances. The distance remaining before thenext service is less than 1,000 km. Example:
900 km remain before the
next service is due. When switching on the ignition and for 5 seconds, the display shows: 5 seconds after the ignition is switched on, the total distancerecorder resumes normal operationand the symbol remains lit. This indicates that a service should
be carried out shortly. The displayshows the total or trip distances. The service is overdue. Each time the ignition is switched on and for 5 seconds, the symbol andthe excess distance flash. Example:
the service is overdue by
300 km. The service should be car-
ried out very shortly. When the ignition is switched on and for 5 seconds, the display shows: 5 seconds after the ignition is switched on, the total distancerecorder resumes normal operation
and the symbol remains lit. The dis-play shows the total or trip distances. Note: the service spanner lights if
the two-year interval has beed exceeded (see "PEUGEOTServicing" section).
PEUGEOT SERVICING
20
22-12-2003

PEUGEOT SERVICING25
22-12-2003
A AND C SERVICE LEVELS AND THE INTERMEDIATE VISIT
Level
Operations Description of operation 1st service
A C Intermediate
DRAIN/REFILLÐ Engine oilÐ Bleed fuel filter (diesel)Ð Oil filterÐ Petrol filter (according to engine)REPLACEÐ Diesel filter or element (according to engine)Ð Air filter elementÐ Spark plugs (petrol)Ð Engine oil (check + top-up) Ð Manual gearbox oil (check + top-up) Ð Battery (check + top-up) if cap is removableLEVELÐ Screen wash (check + top-up)Ð Coolant (check + top-up)Ð Brake fluid (check + top-up)Ð Power steering fluid (check + top up according to specification)Ð Operation of lights and indicatorsÐ Condition of glass, headlamp and light lenses and mirrorsÐ HornÐ Windscreen washer jetsÐ Condition of wiper bladesÐ Condition and tension of the ancillary drive beltsÐ HandbrakeÐ Condition of hydraulic circuits (hoses and covers)CHECKÐ Condition of rubber boots and gaitersÐ Brake pads Ð Play in hubs, link rods, ball joints, flexible mountingsÐ Shock absorbersÐ Rear drum brake lining wearÐ Condition and pressure of tyres (including spare wheel)Ð Emission control check as per current legislation (petrol)Ð Smoke opacity (diesel)Ð Passenger compartment filter (according to specification) Ð Visual check of the whole vehicle
SERVICE*Ð Courtesy vehicle
ROAD TEST
: All driving conditions. : Arduous conditions. * According to destination.

INSTRUMENTS AND CONTROLS29
22-12-2003
Handbrake, low brake
fluid level and Electronic BrakeForce Distribution
system faultwarning light
Linked to the central (STOP) warninglight. This indicates one of the following:
Ð that the handbrake is applied or not fully released,
Ð an excessive drop in brake fluid level (if the warning light remains on even when the handbrake isreleased),
Ð a fault in the Electronic Brake Force Distribution system, if lit at
the same time as the ABS warninglight.
You must stop.
Consult a PEUGEOT dealer.
INSTRUMENTS AND CONTROLS
A permanently lit warning light or one flashing
,with the engine
running, indicates an operatingfault of the unit concerned. Theillumination of certain warninglights may be accompanied byan audible signal and a message
on the multifunction display. Donot ignore this warning: consulta PEUGEOT dealer as soon aspossible.
If the central STOP warning light comes on when you are driving,
stop your vehicle immediately,where it is safe to do so.
Anti-lock braking system (ABS)warning light
This comes on for 3 seconds each time the ignition is switched on. If the warning light remains on or comes on above 8 mph (12 km/h),
this indicates an ABS malfunction.
However, the vehicle retains conven- tional servo-assisted braking. Lighting of this warning light, accompanied by an audible signal,
indicates an ABS fault.
Consult a PEUGEOT dealer.
Diesel engine low coolant levelwarning light
Linked to the central (STOP) warn-ing light.
You must stop.
Wait for the engine to cool before topping up the level. The cooling circuit is pressurised.In the event of breakdown and to prevent any risk of burns , unscrew
the cap by two turns to allow thepressure to drop. When the pressure has dropped, remove the cap and top up the level.
Consult a PEUGEOT dealer.
Central (STOP) warning light
Linked to the warning lights:
Ð "engine oil pressure and tempera- ture",
Ð "low coolant level",
Ð "handbrake",
Ð "low brake fluid level",
Ð "electronic brake force distribution system fault".
Linked with the "coolant tempera-
ture" indicator.
You must stop if the light flashes with the engine running.
Consult a PEUGEOT dealer. Engine oil pressure and temperaturewarning light
Linked to the central (STOP) warn-ing light.
You must stop. This warning light indicates one of the following:
Ð insufficient oil pressure,
Ð a lack of oil in the lubrication cir- cuit. Top up the level.
Ð an oil temperature which is too high. The warning light is acom-
panied by an audible signal. Tolower the oil temperature, reduceyour speed.
Consult a PEUGEOT dealer.

Lighting rheostat With the lights on, press the button to vary the intensity of the lighting ofthe instruments and controls. Whenthe lighting reaches the minimum (ormaximum) setting, release the but-ton then press it again to increase(or reduce) the brightness. As soon as the lighting is of the required brightness, release thebutton.
Total distance recorder Briefly pressing button
1alternates
between the total and trip distance displays.
To reset the trip recorder to zero, when it is displayed press button 1
until zeros appear.
INSTRUMENTS AND CONTROLS
32
22-12-2003

YOUR PARTNER IN DETAIL61
THE KEYS The keys allow you to switch on the ignition and operate the passengerair bag disarming switch as well as toindependently operate the locks onthe doors and the fuel filler cap. Central locking From the front doors, the keys allow you to lock and unlock the doors andtailgate. If one of the doors or the tailgate is open, the central locking does notwork. The remote control performs the same functions at a distance.
Locating your vehicle
To locate your vehicle, if you have locked it, in a car park: press button A, the courtesy
lights come on and the direction indicators flash for a few seconds.
The remote control Locking Press button
Ato lock the vehicle.
This is confirmed by fixed lighting of the direction indicators for approxi-mately two seconds. Unlocking Press button B to unlock the vehicle.
This is confirmed by rapid flashing of the direction indicators. Note: if the vehicle is locked and
unlocking is activated inadvertently, unless the doors are opened within30 seconds, the vehicle will lock
automatically.
Changing the battery of the remote control The "battery flat" information is pro-
vided by an audible signal accompa-
nied by the message "Remote con-
trol battery flat" on the screen.
To change the battery, unclip thecasing using a coin at the ring
(CR 2016/3 volt battery). If the remote control does not work after the battery has been changed,re-programme the remote control. Programming the remote control  Switch off the ignition.
 Switch the ignition on again.
 Press button Aimmediately for a
few seconds.
 Switch off the ignition and remove the remote control key from the
ignition lock. The remote control isnow working again.
22-12-2003