b. Install bearing retainer.
c. Put drive chain onto the front drive sprocket and front driveshaft, and then put them in center case.
d. Install front drive shaft by tapping lightly.
e. Apply gear oil to needle bearings and install them into front drive sprocket.
These needle bearings will be installed more easily if front
drive sprocket is rotated while installing them.
SMT407A
SMT408A
SMT409A
SMT410A
SMT411A
ASSEMBLY
TF-29
http://vnx.su/
FINAL DRIVE SIDE
Ð TS82F type Ð
1. Install new small boot band, boot and side joint housing to driveshaft.
Cover drive shaft serration with tape so as not to damage boot
during installation.
2. Install spider assembly securely, ensuring marks are properly aligned.
I Press-fit with spider assembly serration chamfer facing
shaft.
3. Install new snap ring.
4. Pack with grease. Specified amount of grease:190 - 210 g (6.70 - 7.41 oz)
5. Set boot so that it does not swell and deform when its length is ªLº.Length ªLº = 102 - 104 mm (4.02 - 4.09 in)
Make sure that boot is properly installed on the drive shaft
groove.
6. The rubber cover comes with clamps on both ends. Firmly clinch the clamp to the end which is wider in diameter and
repeat the procedure at the narrower end. Use the appropriate
tool.
SFA800
SFA397
SFA882
SFA883
SFA395
FRONT AXLE Ð Drive Shaft
Assembly (Cont'd)
FA-26
http://vnx.su/
