2004 MERCEDES-BENZ CLK CABRIOLET light

205
Controls in detail
Driving systems
Swi tching on the dis tance warning
function
6 Press button 1(=page 204).
The ind icator lamp in the button lights
up. You will see a loudspeaker symbol
in the multi-function display.
Swit ching off the distance warning
function
6 Press button 1(=page 204).
Indicator lamp 1in the button goes
out. You will not see a loud speaker
symbol in the mul ti-function display. Tips for driving with Distronic
The following contains descriptions of cer-
tain road and traffic conditions in which
you must pay particular attention. In such
situations, brake if necess ary. Distronic is
then dea ctivated. Cornering, going into
and coming out of
a bend
When going into a bend, Distronic may not
detect vehicles travelling in front or it may
detect them too early. The vehicle may
brake sudden lyor brake late. Drivi
ngon a different line
Distronic may not detect a vehicle travel-
ling on a different line. The distance to the
vehicle in front will be too short.
P54.70-2213-31 P54.70-2214-31209en_d2.boo Seite
205 Dienstag, 25. Mai 2004 7:26 19

207
Controls in detail
Driving systems Variable Speedtronic
The cruise control
lever is used to operate:
! cruise control or Distronic*
! variable Speedtronic
The cruise control lever is the uppermost
lever on the left of the steering column
( = page 192).
The LIM indicator lamp on the cruise con-
trol lever indicates which system you have
se lected:
! Cruise control, Distronic*:
LIM indicator lamp off
! Speedtronic:
LIM indicator lamp lit
When the engine isrunning, you can use
the cruise control lever to limi tthe vehi-
cle's speed to any speed:
! from 30 km /hupwards using cruise
control
! from 10 km /hupwards using
Distronic* 1
To store the current speed or a higher
speed
2 To store the current speed or a lower
speed
3 To dea ctivat eth e variable speed limiter
4 To call up the last stored var iable limit
speed or to make a fine adjustment in
in crements of 1 km /h
5 To switch between cruise control,
Distronic* and variab leSpeedtronic
6 LIM indicator lamp Selecting variable Spe
edtronic
1 LIM indicator lamp
2 To select variab leSpeedtronic
6 Check whether Speedtronic is select-
ed. LIM indicator lamp 1must then
light up.
6 Otherwise, press the cru ise control
lever in the direction of arrow 2.
LIM indicator lamp 1lights up.
Sp eedtronic is selected.
P54.25-3820-31 209en_d2.
boo Seite 207 Dienstag, 25. Mai 2004 7:26 19

209
Controls in detail
Driving systems
or
6 Press the cruise control lever briefly in
the direction of arrow 2.
The current speed is stored.
All models exce ptCLK 500:
Speedtronic rounds the speed down to
the next multiple of 10 km /h.
The stored speed is shown in the mul ti-
function display. The segments in the
speedometer from the start of the scale up
to the stored speed light up.
i Allmo dels except CLK 500 and vehicles
with Distronic*
Sp eedtron ic maybe unabl etoprevent thespeed
limit fro mbeing exceeded on downhill gradients.
If th is happens:
! a signal sounds
! you will see theLIMIT exceeded!message
in the multi-function display
You should then brake yourself if necessary. Resuming a stored speed
1 To resume a stored speed
6 Press the cruise control lever briefly in
the direction of arrow 1.
If the vehicle is travel ling at a maximum
of 30 km /habove the stored speed
li mi t,Sp eedtro nicadjusts the vehicle's
speed to the last speed stored. Adjustment in 10 km
/hincrements
1 Toadjust: 10 km /hfaster
2 To adjust: 10 km /hslower
Higher speed 6 Pressthe crui secontro l le ver briefly in
the direction of arrow 1.
or
6 Press and hold the cruise control
lever in the direction of arrow 1until
th ede sired speed has been reached. 209en_d2.boo Seite
209 Dienstag, 25. Mai 2004 7:26 19

212 Controls in detail
Driving systems
6
Press the korj button.
The collection of submenus is shown in
the multi-function display.
6 Move the bar to theVehiclesubmenu
using the æorç button.
6 Press the korj button repeat-
edly until you see the
Speed limit
(winter tyres)
message in the multi-
fun ction displ ay.
The current setting is highlighted. 6
Move the bar to the desired value using
the æ orç button. You can
select:
!
Off
permanent Speedtronic is deacti-
vated
! mul tiples of 10 km /hbetween
240 km /hand 160 km /h
permanent Speedtronic limits the
vehicle's speed to the value stored.
PTS is anelectronic parking assistance
mechanism. It provi des you with a visual
and audible indication of the distance
between your vehicle and any obstacle.
P54.30-5221-31 Parktronic system* (PTS)
G
Risk of accident The Parktronic system is only an aid and
may not detec
tall obsta cles. It can be no
substitute for your payingatten tion .
Yo uare always res ponsible for safety and
must continue to pay attention to your
immediate surroundings when parking and
manoeuvring. Otherwise, you could endan-
ger yourself and others. G
Riskof injury Make sure that
noperso nsoranimals are in
the manoeuvring range. Otherwise, they
could be injured. 209en_d2.boo Seite
212 Dienstag, 25. Mai 2004 7:26 19

214 Controls in detail
Driving systems
Mini
mum distance
If there is an obstacle within this range, all
the warn ing lamps light up and a signal
sounds. If your vehicle's distance falls
below the minimum distance, the distance
may no longer be shown. Warnin
g displa ys
The warning displays show the distance
between the sensor and the obstacle.
The warning display for the front area is
located on the cockpit above the centre air
vents. The warn ing display for the rear area
is at the rear in the roof lining. Front are
awarning display
1 Left side ofvehicle
2 Right side of vehicle
The warning display for each side of the
vehicle is divided into six yellow and two
red segments. Parkt ronic is activated if the
frame is lit.
The gear lever or selector lever positi on
determines which warning display is acti-
vated. Vehicles with manual transmission:
Vehicles wi
thautomatic transmission*:
One or more segments light up as the vehi-
cle approaches an obstacle, depend ing on
the veh icle's distance from the obstacle.
From the 7th segment, you will hear an
interm ittent warning signal. From the
8th segment, a continuous warning signal
sounds for a maximum of three seconds.
Yo u have reac he dth e minimum distance. Centre 20 cm
Corners 15 cm P54.65-2430-31
Wa
rning display Forwa
rdgear or
neutral Front area activated
Rever
segear Front and
rear areas
activated Selector lever
positi
on Wa
rning display D Front area activated
R
or N Fron
tand rear areas
activated P No areas activated209en_d2.boo Seite
214 Dienstag, 25. Mai 2004 7:26 19

215
Controls in detail
Driving systems Ac
tivatin gand de activa tingPTS
You can activate and deactivate PTS man-
ually.
The switch is located on the upper section
of the centre console.
1 To act ivat e and deact ivat e PTS
2 Indicator lamp Deactivating PTS
6 Press button 1.
Indicator lamp 2lights up.
Ac tivating PTS
6 Press button 1.
Indicator lamp 2goes out.
i PTS is activated automatically when the key
is tur ned to position 2in the igniti onlock. Trailer towing
When you cou
ple up a trailer, PTS isdeac-
tivated for the rear area as soon as you
have established an electrical connection
between your vehicle and the trailer.
! Detach th etrailer tow hitch when you do not
require it. The minimum detection range of PTS
to an obstacle refers to the bumper, not the ball
co up ling.
P54.25-3822-31 209en_d2.boo Seite
215 Dienstag, 25. Mai 2004 7:26 19

221
Controls in detail
Loading
The handling characteristics of a vehicle
when laden depend on the distribution of
the load within the vehic le. You should
therefore load your vehicle in accordance
with the illustration s.Lu
ggage net inthe front-passenger
footw ell G
Risk ofinjury On
ly use th eluggage net to transport light
items. Do not use it to transport any heavy,
sharp-edged or breakable objects. You and
others could otherwise be injured by objects
being thrown around in the event of:
! sharp braking
! a sudden chang eof direc tion or
! an accident Loading gui
delines G
Risk of injury Do not carry heavy or hard objects
inside
th evehicle or in the boot unless they are
secured.
An incorrectly secured or wrongly posi-
tioned load incre ases the risk of injury in the
event of:
! sharp braking
! a sudde nchange ofdirection or
! an accident
Ev en if the loading guidelines are followed
pr ecisely, a load will always increase the risk
of injury in an accident. G
Risk of poisoning Al
ways make sure that the boot lid is closed
when theen gine is running. Exhaust fumes
could otherwise ent erthe vehicle interior
an d you could be poisoned as ares ult. P 00.01-2133-31209en_d2.boo Seite
221 Dienstag, 25. Mai 2004 7:26 19

222 Controls in detail
Loadingi
Observe the following notes onloading the
vehic le and transporting a load in the vehicle:
! Taking passe ngers in the vehicle as well as
th e vehicle's load into account, do not
exce ed the vehicle' s max imum perm issibl e
gross vehicle weight or axle loads.
! Slide a heavy load as far towards the front of
th e vehicle as pos sibleand stow it as far
down in the boot as possible.
! The lo adshould not be higher than theto p of
th e bac krests.
! Always lea nthe load against the front or rear
backrests ifthe load is tobe carried in the
vehicle interi or.
! When possible, always tr ansport the load
be hind seats which are not occupied.
! Secure the load with sufficiently strong and
wear-resistant lashing material. Pad sharp
ed ges for protection.
Lashing material can be ob tained ata qualified
sp ecialist wor kshop, e.g. at a Merce des-Be nz
Service Centre. In the boot there are four lashing eyelets.
6
Secure the load to the lashing eyelets.
Please note: ! Do not use elastic straps or nets to
secure a load, as these are only
intended as an anti-slip protection for
light load s.
! If you use securing straps, only use a
strap with a:
! permissible tens ile force
Fperm. = 600daN
! relative elongation of about 7% !
Do not route lashing material over
sharp corners or rough surfaces.
! Pad sharp edges for protection.
! Spread the load evenly between the
lashing points.
! Use all the lashing eyelets if possible.
! Do not overload the lashing eyelets
when using tensioners.
! Read and observe the instructions
issued with the lashing material used. Securing a load (Coupé)
G
Risk of injury Spread the load evenly between th
elashing
eyelets.
Observe the loading guidelines
(= page
221). 209en_d2.boo Seite
222 Dienstag, 25. Mai 2004 7:26 19